Comparative study of R134a and R744 driven solar assisted heat pump systems for different applications

QR Code

Comparative study of R134a and R744 driven solar assisted heat pump systems for different applications

A solar assisted heat pump (SAHP) system is considered in this study where space cooling, water heating, drying and desalination are carried out using solar energy, ambient energy and the waste heat available from air conditioning system. The integration of different applications with SAHP system l...

Full description

Bibliographic Details
Main Authors:	Baradey, Yehya, Hawlader, Mohammad Nurul Alam, Ismail, Ahmad Faris, Hrairi, Meftah
Format:	Proceeding Paper
Language:	English English
Published:	IOP Publishing 2016
Subjects:	TJ807 Renewable energy sources
Online Access:	http://irep.iium.edu.my/56894/ http://irep.iium.edu.my/56894/1/Baradey_2017_IOP_Conf._Ser.%253A_Mater._Sci._Eng._184_012060.pdf http://irep.iium.edu.my/56894/7/56894_Comparative%20study%20of%20R134a_SCOPUS.pdf

Similar Items

Desalination technologies: a critical review
by: Baradey, Yehya, et al.
Published: (2018)

Solar assisted heat pump desalination system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2004)

Solar assisted heat-pump dryer and water heater
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2003)

The performance of a solar assisted heat pump water heating system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2001)

An economic analysis of a solar assisted heat pump system for cooling, water heating and drying
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)

An economic optimization of evaporator and air collector area in a solar assisted heat pump drying system
by: Rahman, S. M. A., et al.
Published: (2013)

A solar assisted heat pump system for desalination
by: Amin, Zakaria Mohd., et al.
Published: (2011)

Utilization of solar energy and waste heat for water heating, drying and desalination of seawater
by: Hawlader, Mohammad Nurul Alam
Published: (2013)

An analysis of the non-convecting solar pond
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (1981)

Development of solar air collectors for drying applications
by: Karim, M A, et al.
Published: (2004)

Improving the efficiency of poly-crystalline photovoltaic module using special transparent glass covers
by: Baradey, Y., et al.
Published: (2014)

An integrated solar thermal and photovoltaic system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2012)

Performance evaluation of solar collectors using a solar simulator
by: Mohamed, Norhafana, et al.
Published: (2015)

Effect of periodic drying on energy utilization, product quality, and drying time
by: Baradey, Yehya, et al.
Published: (2017)

Performance of different photovoltaic cells operating under the meteorological conditions of Singapore
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)

Development of solar powered irrigation system
by: Abdelkerim, A I, et al.
Published: (2013)

An air conditioning system providing cooling, water heating and drying
by: Ihsan, Sany Izan, et al.
Published: (2012)

Design and development of hybrid energy generator (photovoltaics) with solar tracker
by: Mohiuddin, A. K. M., et al.
Published: (2017)

Development of portable solar generator
by: Mat Jamil, Khamelrun Shah
Published: (2015)

Assessment of solar energy potential in Johor, Malaysia
by: Samsudin, Muhammad Zahid, et al.
Published: (2021)

Thermal performance of backflow solar air heating with integrated nanoparticle enhanced pcm absorber storage system
by: Hayder, Ali Mohammed
Published: (2019)

Solar photocatalytic degradation of basic red 51 in hair dye bathroom greywater using zinc oxide nanoparticles synthesized with Corriandrum sativum leaf extract
by: Gopalakrishnan, Yashni
Published: (2021)

Modeling and analysis of flutter-based thin-film cantilever microgenerator
by: Abdul Hakim, Javid, et al.
Published: (2015)

Investigation of PEM fuel cell for automotive use
by: Mohiuddin, A. K. M., et al.
Published: (2015)

Ocean thermal energy conversion: the promise of a clean future
by: Hossain, A., et al.
Published: (2013)

Improvement design of parabolic trough
by: Ihsan, Sany Izan, et al.
Published: (2017)

Recycling and disposal of lithium batteries: an economical and environmental approach
by: Rahman, Mohammed Ataur, et al.
Published: (2017)

Modelling of spray evaporation and penetration for alternative fuels
by: Azami, Muhammad Hanafi, et al.
Published: (2016)

Enhancement of oil palm empty fruit bunch char by impregnation of pyrolytic carbon from tar vapor decomposition
by: Rozhan, Alya Naili, et al.
Published: (2016)

Carbon deposition from biotar by fast pyrolysis of palm empty fruit bunch
by: Rozhan, Alya Naili, et al.
Published: (2016)

Design and investigation of a fuel cell car prototype
by: Mohiuddin, A. K. M., et al.
Published: (2014)

Economic performance of bio-gas plant in the context of Bangladesh
by: Paul, Dilip Kumar, et al.
Published: (1999)

The applicability of ISO household refrigerator-freezer energy test specifications in Malaysia
by: Masjuki , H.H., et al.
Published: (2001)

Design and Development of a Fuel Cell Car Prototype
by: Mohiuddin, A. K. M., et al.
Published: (2013)

3-D CFD transient simulation of transesterification in stirred tank reactor
by: Mohiuddin, A. K. M., et al.
Published: (2013)

Zn/MCM-41/MnO2 leclanché button cell R2025 for low rate applications
by: Mohd Zawi, Nor Liza, et al.
Published: (2012)

Cooling of motorcyclist helmet with thermoelectric module
by: Hrairi, Meftah, et al.
Published: (2013)

Dynamic analysis of a 10m diameter wind turbine rotor under maximum wind load of Malaysia
by: Mohd, Sofian
Published: (2006)

Advance control of Dual Active Bridge Multilevel Inverter (DABMI) with Open Winding Transformer (OWT) model
by: Bohari, Azuwien Aida
Published: (2021)

The bonded macro fiber composite (MFC) and woven kenaf effect analyses on the micro energy harvester performance of kenaf plate using modal testing and Taguchi method
by: Hamdan, A., et al.
Published: (2016)