Voltage supply and voltage regulation

QR Code

Voltage supply and voltage regulation

A stable voltage supply is important for the proper operation of electronic devices. Stability is characterized by the ability of the voltage output to stay constant and ripplefree regardless of how much load is connected to the circuit. There is a brief discussion on how much inaccuracy is caused b...

Full description

Bibliographic Details
Main Authors:	Torla, Ahmad Lutfi, Khan, Sheroz, Abdul Muthalif, Asan Gani
Format:	Book Chapter
Language:	English
Published:	IIUM Press 2011
Subjects:	TK7800 Electronics. Computer engineering. Computer hardware. Photoelectronic devices
Online Access:	http://irep.iium.edu.my/21642/ http://irep.iium.edu.my/21642/1/VOLTAGE_SUPPLY_AND_VOLTAGE_REGULATION.pdf

Similar Items

Full-wave rectification of a low-voltage source
by: Torla, Ahmad Lutfi, et al.
Published: (2011)

Low voltage DC power supply with spike-blocking features
by: Torla, A. Lutfi, et al.
Published: (2013)

Spikes blocking and surge protection
by: Torla, Ahmad Lutfi, et al.
Published: (2011)

Analysis of hybrid stepper motor performance under the influence of voltage supply interference
by: Salami, Abdulazeez F., et al.
Published: (2011)

Acquisition of a very low voltage and a low frequency biomedical signal- frequency selective filter design
by: Shobaki, Mohammed M., et al.
Published: (2014)

Channel length effect on the saturation current and the threshold voltages of CNTFET
by: Ani, Mohd Hanafi, et al.
Published: (2014)

Design and optimization of alLow-voltage shunt capacitive RF-MEMS switch
by: Ma, Li Ya, et al.
Published: (2014)

Capacitance-voltage characterization of commercial gallium nitride diodes subjected to electron radiation
by: Hedzir, Anati Syahirah, et al.
Published: (2016)

Power supply power-supply interference in smart sensors-to-microntroller interface for biomedical signals
by: Ashraful, Muhammad, et al.
Published: (2011)

Power supply interference in smart sensor microcontroller interface
by: Tijani, Ismaila, et al.
Published: (2011)

Design and analysis of a low-voltage electrostatic actuated RF CMOS-MEMS switch
by: Ma, Li Ya, et al.
Published: (2013)

Design, optimization and simulation of a low‑voltage shunt capacitive RF‑MEMS switch
by: Ma, Li Ya, et al.
Published: (2015)

Low power and high voltage swing cascode Pierce oscillator for MEMS SAW resonators
by: Md Hamzah, Mohd Haidar, et al.
Published: (2016)

Analysis of mutual inductance and coupling factor of inductively coupled coils for wireless electricity
by: Nataraj, Chandrasekharan, et al.
Published: (2017)

General analysis of resonance coupled wireless power transfer (WPT) using inductive coils
by: Nataraj, Chandrasekharan, et al.
Published: (2018)

Ripple voltage and its elimination in low voltage power supply
by: Torla, Ahmad Lutfi, et al.
Published: (2012)

A novel design of low-voltage low-loss K-band RF-MEMS capacitive switch
by: Ma, Li-Ya, et al.
Published: (2018)

3MeV-electron beam induced threshold voltage shifts and drain current degradation on ZVN3320FTA & ZVP3310FTA commercial MOSFETs
by: Abubakkar, Sheik Fareed Ookar, et al.
Published: (2014)

Regulation of stable low voltage power supply through phase angle modulation: simulation details
by: Torla, Ahmad Lutfi, et al.
Published: (2012)

Pavement condition analysis via vehicle mounted accelerometer data
by: Mohiddeen, Ahmad Jazlan, et al.
Published: (2020)

Performance improvement of sensors response using piece-wise non-linear (PWL) A/D and pulse-width modulation (PWM) A/D techniques
by: Tijani, Ismaila, et al.
Published: (2011)

Design of differential resistive measuring system and its applications
by: Abdul Wahab, Deji, et al.
Published: (2011)

Linearizing techniques for sensor output
by: Saddiqi, Mohammad Tahir, et al.
Published: (2011)

Response and inaccuracy issues of sensors
by: Ashraful, Muhammad, et al.
Published: (2011)

Review of SCADA systems and IoT honeypots
by: Alquwatli, Mohammed H., et al.
Published: (2020)

Sensor and sensor response-issues and interfacing
by: Ahmmad, Syed Masrur, et al.
Published: (2011)

Design and simulation of 10 MHz MEMS oscillator
by: Taufik, Mohamad Syamsi, et al.
Published: (2014)

Design and simulation of 20MHz oscillator using CMOS-MEMS beam resonators
by: Zainuddin, Ahmad Anwar, et al.
Published: (2013)

RLC circuit response
by: Tasnim, Rumana, et al.
Published: (2011)

UWB pulse generation,shaping and analysis
by: Shahid, Zeeshan, et al.
Published: (2011)

Sensors in electronic applications
by: Tasnim, Rumana, et al.
Published: (2011)

Output control devices : actuators
by: Tasnim, Rumana, et al.
Published: (2011)

On the electrode arrangements of capacitive sensor for two phase Gas flow measurement
by: Tasnim, Rumana, et al.
Published: (2011)

Design of two-stage CMOS amplifier for quartz crystal resonator
by: Mohd Taufik, Muhammad Syamsi, et al.
Published: (2013)

Design and simulation of Clamped-Clamped and Clamped-Free resonators
by: Zainuddin, Ahmad Anwar, et al.
Published: (2013)

Inductive loops for sensing position as signature signals
by: Larbani, Sofiane, et al.
Published: (2013)

Application and case studies of magnetic induction
by: Arshad, Atika, et al.
Published: (2011)

Magnetic hysteresis theory :application perspective
by: Arshad, Atika, et al.
Published: (2011)

The principle of resistive sensing
by: Arshad, Atika, et al.
Published: (2011)

Inductive power system for energy harvesting
by: Arshad, Atika, et al.
Published: (2011)