Design And Fabricate Of Pneumatic Punching Tool
Many machines today are using of electrical, hydraulic and pneumatic component as a source of system. So, to gain skills and knowledge on how to develop machine, this project are recommend. With the title of “Design and Fabricate of Pneumatic Punching Tool”, there are many requirements to know su...
| Summary: | Many machines today are using of electrical, hydraulic and pneumatic component as a
source of system. So, to gain skills and knowledge on how to develop machine, this
project are recommend. With the title of “Design and Fabricate of Pneumatic Punching
Tool”, there are many requirements to know such as function of pneumatic component,
capability to use design software and conventional machine to fulfill this project. In
design stage, there provide three design that need to be considered and the design was
selected using Pugh Method selection. Then, the design was drawing back using
SolidWork 2007. For pneumatic circuit, Fuidsim software has been used which is
required to see the process of machine before it implemented. For fabrication part, the
machining process are only used conventional machine; milling machine and lathe
machine. In testing process, compressor with motor 2.5 HP has been using as a source of
air and the machine was functioned well where it can punch on 0.7mm of sheet metal
with diameter 10mm. At the end of task, the conclusion is making and several
recommendations are suggests to make an improvement about the result and the project
for future study. |
|---|