Study Of Cutting Edge Temperature And Cutting Force Of End Mill Tool In High Speed Machining
A wear of cutting tools during machining process is unavoidable due to the presence of frictional forces during removing process of unwanted material of workpiece. It is unavoidable but can be controlled at slower rate if the cutting speed is fixed at certain point in order to achieve optimum cutt...
Main Authors: | , , , , |
---|---|
Format: | Article |
Language: | English |
Published: |
EDP Sciences
2017
|
Subjects: | |
Online Access: | http://ir.unimas.my/17237/ http://ir.unimas.my/17237/ http://ir.unimas.my/17237/ http://ir.unimas.my/17237/1/Study%20Of%20Cutting%20Edge%20Temperature%20And%20Cutting%20Force%20Of%20End%20Mill%20Tool%20%28abstract%29.pdf |
Summary: | A wear of cutting tools during machining process is unavoidable due to the presence of frictional forces
during removing process of unwanted material of workpiece. It is unavoidable but can be controlled at slower rate if
the cutting speed is fixed at certain point in order to achieve optimum cutting conditions. The wear of cutting tools is
closely related with the thermal deformations that occurred between the frictional contact point of cutting edge of
cutting tool and workpiece. This research paper is focused on determinations of relationship among cutting
temperature, cutting speed, cutting forces and radial depth of cutting parameters. The cutting temperature is
determined by using the Indium Arsenide (InAs) and Indium Antimonide (InSb) photocells to measure infrared
radiation that are emitted from cutting tools and cutting forces is determined by using dynamometer. The high speed
machining process is done by end milling the outer surface of carbon steel. The signal from the photocell is digitally
visualized in the digital oscilloscope. Based on the results, the cutting temperature increased as the radial depth and
cutting speed increased. The cutting forces increased when radial depth increased but decreased when cutting speed is
increased. The setup for calibration and discussion of the experiment will be explained in this paper. |
---|