Search Results - "brickwork"
-
1
-
2
-
3
Modelling of shear in post-tensioned brickwork cantilever fin walls
Published 1995“…This paper describes a model scale investigation of the shear behaviour of post-tensioned brickwork cantilever fin walls. The developments of models to represent the critical region under shear are described. …”
Get full text
Get full text
-
4
Investigation of failure modes in unreinforced brick masonry walls subjected to different load combinations
Published 2003“…Using a simple statistical method, the characteristic compressive strength of the structural brickwork under axial compression for each set has been determined. …”
Get full text
Get full text
-
5
Investigation on the physical properties of clay and engineering bricks / Abdul Halim Mahfodz
Published 1997“…From the strength of bricks units , we can predict the strength of structural brickwork for use as load bearing wall.…”
Get full text
-
6
Categorization of General Problems and Defects in Historical Building
Published 2012“…Generally all existing structures of historical buildings are from stone, brickwork, plaster and timber. The problem, weakening and failure of the building are due to old age which gives rise to defects and faulty formation that had occurred since it was erected and aggravated by subsequent sloppy repairs or total ignorance. …”
Get full text
Get full text
-
7
Simulation On The Effect Of Water Absorption On The Strength Of Masonry Wall
Published 2006“…Experimental investigation was conducted on 60 specimens (individual bricks and brickwork prisms made up of calcium silicate, clay and cement sand bricks) in obtaining the brick’s compressive strength, mortar strength, unit water absorption and initial rate of absorption. …”
Get full text
Get full text
-
8
Emulation based uncertainty and sensitivity analysis for complex building performance simulation
Published 2020“…The similar insignificance of stochastic phenomena (0.0130) as compared to brickwork solar absorptance (0.5032) and wall insulation conductivity (0.3714) has been observed during cooling season, due to the acceleration of short- and long-wave radiation phenomena which then dampens the occupants' interaction to restore their thermal comfort.…”
Get full text
-
9
Sustainable manufacturing of next generation building materials using microwave energy
Published 2018“…This is 92% faster than in brickworks, where conventional samples could not match the heating rates without cracking. …”
Get full text
-
10
Load-Bearing Mansory Construction System: What is LB and how it benefits home buyers?
Published 2016“…Dr Che Sobry bin Abdullah, an expert in Concrete and Brickwork Technology from Univeristi Utara Malaysia, "Load-bearing mansory construction system is considered one of the most pertinent agendas in the socio-economic development of the country".…”
Get full text
Get full text
-
11
Experimental study of properties for sand bricks with palm oil clinker as partial replacement for fine aggregate with ratio of 5% with rice husk 10%, 20% and 30%
Published 2018“…The ratio of the mortar is 1:6 which is consist of one (1) part of cement to six (6) parts of sand according to Jabatan Kerja Raya (JKR) of Standard Specification at section E (brickworks) in clause 3.1. The size of the sand brick according to the JKR specification is 225 mm x 113 mm x 75mm for one brick. …”
Get full text
Get full text
