Infrared tomography : data distribution system for real-time mass flow rate measurement

QR Code

Infrared tomography : data distribution system for real-time mass flow rate measurement

The system developed in this research has the objective of measuring mass flow rate in an online mode. If a single computer is used as data processing unit, a longer time is needed to produce a measurement result. In the research carried out by previous researcher shows about 11.2 seconds is needed...

Full description

Bibliographic Details
Main Authors:	Abdul Rahim, Ruzairi, Pang, Jon Fea, Chan, Kok San, Leong, Lai Chen, Rahiman, Mohd. Hafiz Fazalul
Format:	Article
Language:	English
Published:	International Frequency Sensors Association (IFSA) 2007
Subjects:	TK Electrical engineering. Electronics Nuclear engineering
Online Access:	http://eprints.utm.my/8663/ http://eprints.utm.my/8663/1/8663.pdf

Similar Items

Infrared tomography : data distribution system and software development for real-time velocity measurement
by: Hj. Abdul Rahim, Ruzairi, et al.
Published: (2007)

Optical tomography : real-time image reconstruction for various flow regime in gravity flow conveyors
by: Abd. Rahim, Ruzairi, et al.
Published: (2007)

Real time mass flow rate measurement using multiple fan beam optical tomography
by: Abd. Rahim, Ruzairi, et al.
Published: (2008)

Initial result on low cost microprocessor and ethernet controller based data acquisition system for optical tomography system
by: Hj. Abdul Rahim, Ruzairi, et al.
Published: (2007)

Initial result on electrical impedance tomography
by: Abdul Rahim, Ruzairi, et al.
Published: (2003)

Investigating multiple fan beam projection technique using optical fibre sensor in process tomography
by: Abdul Rahim, Ruzairi, et al.
Published: (2007)

Area-Based Concentration Measurement Using Optical Tomography Technique For Various Flow Patterns
by: Abdul Rahim, Ruzairi, et al.
Published: (2005)

Determination of water and oil flow composition using ultrasonic tomography techniques
by: Abdul Rahim, Ruzairi, et al.
Published: (2007)

Ultrasonic Tomography System For Liquid/Gas Flow: Frame Rate Comparison Between Visual Basic And Visual C++ Programming
by: Abdul Rahim, Ruzairi, et al.
Published: (2006)

Ultrasonic transmission-mode tomography imaging for liquid/gas two-phase flow
by: Rahiman, Mohd. Hafiz Fazalul, et al.
Published: (2006)

Hardware development of ultrasonics tomography for composition determination of water and oil flow
by: Abdul Rahim, Ruzairi, et al.
Published: (2007)

Optical tomography imaging in pneumatic conveyor
by: Abdul Rahim, Ruzairi, et al.
Published: (2008)

Non-invasive imaging of liquid/gas flow using ultrasonic transmission-mode tomography
by: Fazalul Rahiman, Mohd. Hafiz
Published: (2005)

Data acquisition process in optical tomography : signal sample and hold circuit
by: Abdul Rahim, Ruzairi, et al.
Published: (2005)

Real-time mass flow rate measurement for bulk solid flow using electrodynamic tomography system
by: Yaw, Wee Lee
Published: (2007)

Image reconstruction using iterative transpose algorithm for optical tomography
by: Md. Yunos, Yusri, et al.
Published: (2007)

Ultrasound tomography : preliminary result
by: Abdul Rahim, Ruzairi, et al.
Published: (2003)

Non-invasive ultrasonic tomography: liquid/gas flow visualization
by: Abdul Rahim, Ruzairi, et al.
Published: (2005)

Embedded system based solid-gas mass flow rate meter using optical tomography
by: Chiam, Kok Thiam
Published: (2006)

Ultrasonic tomography for multiphase flow application
by: Abdul Rahim, Ruzairi, et al.
Published: (2010)

Optical tomography experimental setup : a study on reflection effect
by: Mohd Muji, Siti Zarina, et al.
Published: (2011)

Simulation and Experimental Study of The Sensor Emitting Frequency for Ultrasonic Tomography System in a Conducting Pipe
by: Goh, Chiew Loon, et al.
Published: (2017)

A novel hybrid binary reconstruction algorithm for ultrasonic tomography
by: Abdul Rahim, R., et al.
Published: (2008)

The linearity of optical tomography: sensor model and experimental verification
by: Mohd. Muji, Siti Zarina, et al.
Published: (2011)

A Review of Process Tomography Application in Inspection System
by: Yasmin, Abdul Wahab, et al.
Published: (2014)

Single-plane dual-modality tomography for multiphase flow imaging by integrating electrical capacitance and ultrasonic sensors
by: Pusppanathan, Jaysuman, et al.
Published: (2017)

Solid/gas concentration measurements using multiple fan beam optical tomography
by: Abdul Rahim, R., et al.
Published: (2008)

Simulation and experimental study of the sensor emitting frequency for ultrasonic tomography system in conducting pipe
by: Goh, Chiew Loon, et al.
Published: (2017)

Forward Problem Solving for Non-Invasive Electrical Resistance Tomography System
by: Yasmin, Abdul Wahab, et al.
Published: (2018)

Forward problem solving for non-invasive electrical resistance tomography system
by: Yasmin, Abdul Wahab, et al.
Published: (2018)

Segmented capacitance tomography electrodes: a design and experimental verifications
by: Mohamad, Elmy Johana, et al.
Published: (2012)

Hardware Development of Dual-Modality Tomography Using Electrical Resistance and Ultrasonic Transmission Tomography for Imaging Liquid and Gas
by: Fazlul Rahman, Mohd Yunus, et al.
Published: (2022)

Hardware Development of Dual-Modality Tomography Using Electrical Resistance and Ultrasonic Transmission Tomography for Imaging Liquid and Gas
by: Fazlul Rahman, Mohd Yunus, et al.
Published: (2022)

Simulation of Electrode for Dual-Modality Electrical Resistance Tomography and Ultrasonic Transmission Tomography for Imaging Two-Phase Liquid and Gas
by: Fazlul Rahman, Mohd Yunus, et al.
Published: (2015)

Mobile electrical capacitance tomography (ECT) development for liquid-gas flow measurement
by: Chan, Kok Seong, et al.
Published: (2015)

Sensitivity Map Generation for Conducting Strategy In Electrical Resistance Tomography
by: Suzanna, Ridzuan Aw, et al.
Published: (2015)

Non-invasive Process Tomography in Chemical Mixtures – A Review
by: Yasmin, Abdul Wahab, et al.
Published: (2015)

Non-Invasive Process Tomography in Chemical Mixtures - A Review
by: Yasmin, Abdul Wahab, et al.
Published: (2015)

Analysis of Crude Palm Oil Composition in a Chemical Process Conveyor using Electrical Capacitance Tomography
by: E. J., Mohamad, et al.
Published: (2016)

Review of wire-mesh tomography in different experiments
by: Rajan, Navintiran, et al.
Published: (2021)