A study on optical sensors orientation for tomography system development

QR Code

A study on optical sensors orientation for tomography system development

This paper describes the investigation of optical sensors performance towards the development of optical tomography system. The orientation of the transmitters has been set from 0o until 180o and then the receiver’s responses were analyzed. Hence, sensors capabilities were tested further by p...

Full description

Bibliographic Details
Main Authors:	Abdul Shaib, M. Fadzli, Abdul Rahim, Ruzairi, M. Muji, Siti Zarina, Leow, Pei Ling, Abdul Jamil, M. Mahadi
Format:	Article
Language:	English
Published:	International Frequency Sensor Association (IFSA) 2012
Subjects:	T Technology (General)
Online Access:	http://eprints.uthm.edu.my/8015/ http://eprints.uthm.edu.my/8015/1/J4273_6343ab5dac6797d04b3758c62d49ec4e.pdf

Similar Items

A study on optical sensors orientation for tomography system development
by: Abdul Shaib, M. Fadzli, et al.
Published: (2012)

The linearity of optical tomography: sensor model and experimental verification
by: Mohd Muji, Siti Zarina, et al.
Published: (2011)

The linearity of optical tomography: sensor model and experimental verification
by: Mohd. Muji, Siti Zarina, et al.
Published: (2011)

An overview: effectiveness of different arrangement for electrode guard in electrical capacitance tomography
by: Abd Shaib, Mohd Fadzli, et al.
Published: (2011)

Fundamental Sensor Development in Electrical Resistance Tomography
by: Ling, En Hong, et al.
Published: (2015)

Optical tomography : transmitter and receiver circuit preparation
by: Mohd Muji, Siti Zarina, et al.
Published: (2011)

Optical tomography experimental setup : a study on reflection effect
by: Mohd Muji, Siti Zarina, et al.
Published: (2011)

Optical tomography verification for single and mixed modalities
by: Mohd. Muji, Siti Zarina, et al.
Published: (2017)

Ethernet Based Optical Tomography System
by: Abdul Rahim, Ruzairi, et al.
Published: (2005)

Optical tomography imaging in pneumatic conveyor
by: Abdul Rahim, Ruzairi, et al.
Published: (2008)

A review on electrical capacitance tomography sensor development
by: Abd. Rahman, Noor Amizan, et al.
Published: (2015)

Optical tomography: Image improvement using mixed projection of parallel and fan beam modes
by: Mohd Muji, Siti Zarina, et al.
Published: (2013)

Ultrasonic tomography - image reconstruction algorithms
by: Rahiman, Mohd Hafiz Fazalul, et al.
Published: (2012)

Ultrasonic tomography – image reconstruction algorithms
by: Rahiman, Mohd Hafiz Fazalul, et al.
Published: (2012)

Investigating multiple fan beam projection technique using optical fibre sensor in process tomography
by: Abdul Rahim, Ruzairi, et al.
Published: (2007)

Sensor modeling for portable electrical capacitance tomography system using simulation by comsol multiphysics
by: Mohamad, Elmy Johana, et al.
Published: (2012)

Optical tomography system for process measurement using light-emitting diodes as a light source
by: Abdul Rahim, Ruzairi, et al.
Published: (2004)

Measurement and analysis of water/oil multiphase flow using electrical capacitance tomography sensor
by: Mohamad, Elmy Johana, et al.
Published: (2016)

Optical fiber sensor review
by: Durasad, Akmal Dzuhairi, et al.
Published: (2020)

Forward Problem Solving for Non-Invasive Electrical Resistance Tomography System
by: Yasmin, Abdul Wahab, et al.
Published: (2018)

Forward problem solving for non-invasive electrical resistance tomography system
by: Yasmin, Abdul Wahab, et al.
Published: (2018)

Forward problem solving for non-invasive electrical resistance tomography system
by: Abdul Wahab, Yasmin, et al.
Published: (2018)

Data acquisition process in optical tomography : signal sample and hold circuit
by: Abdul Rahim, Ruzairi, et al.
Published: (2005)

Simulation and experimental study of the sensor emitting frequency for ultrasonic tomography system in conducting pipe
by: Goh, Chiew Loon, et al.
Published: (2017)

Hardware Development of Dual-Modality Tomography Using Electrical Resistance and Ultrasonic Transmission Tomography for Imaging Liquid and Gas
by: Fazlul Rahman, Mohd Yunus, et al.
Published: (2022)

Hardware Development of Dual-Modality Tomography Using Electrical Resistance and Ultrasonic Transmission Tomography for Imaging Liquid and Gas
by: Fazlul Rahman, Mohd Yunus, et al.
Published: (2022)

Simulation and Experimental Study of The Sensor Emitting Frequency for Ultrasonic Tomography System in a Conducting Pipe
by: Goh, Chiew Loon, et al.
Published: (2017)

Area-Based Concentration Measurement Using Optical Tomography Technique For Various Flow Patterns
by: Abdul Rahim, Ruzairi, et al.
Published: (2005)

Image reconstruction using iterative transpose algorithm for optical tomography
by: Md. Yunos, Yusri, et al.
Published: (2007)

Tomography systems and sound manipulation using acoustic
by: Abdul Hamid, Siti Zaleha, et al.
Published: (2018)

A simulation study of sensor behavior for non-invasive electrical resistance tomography
by: Yasmin, Abdul Wahab, et al.
Published: (2020)

Optical tomography system using charge-coupled device for transparent object detection
by: Juliza, Jamaludin, et al.
Published: (2018)

An investigation on chemical bubble column using ultrasonic tomography for imaging of gas profiles
by: Rahiman, Mohd Hafiz Fazalul, et al.
Published: (2014)

Smart sensors for structural health monitoring (SHM)
by: Suhadi, Nor Aisyah, et al.
Published: (2017)

Simulation study on CCD tomography system for ruby stone optical properties
by: Syarfa Najihah, Raisin, et al.
Published: (2021)

Development of an angle sensor using optical polarizer
by: Rana, M. M., et al.
Published: (2015)

Non-invasive Process Tomography in Chemical Mixtures – A Review
by: Yasmin, Abdul Wahab, et al.
Published: (2015)

Non-Invasive Process Tomography in Chemical Mixtures - A Review
by: Yasmin, Abdul Wahab, et al.
Published: (2015)

Segmented capacitance tomography electrodes: a design and experimental veriﬁcations
by: Mohamad, Elmy Johana, et al.
Published: (2012)

Segmented capacitance tomography electrodes: a design and experimental verifications
by: Mohamad, Elmy Johana, et al.
Published: (2012)