Pressure fryer
In cooking, pressure frying is a variation on pressure cooking where meat and cooking oil are brought to high temperature while pressure is held high enough to cook the food quickly. This leaves the meat very hot and juicy (Figure 5.1). A receptacle used in pressure frying is known as a pressure fry...
| Main Authors: | Johar, Ahmad Sufiyan, A. Karim, Mohamad Nur, Mohidin, Mohamad Nasiruddin, Mohd Yazid, Muhamad Afiq Najmi, Hassan, Mohd Fahrul, Nardir, Nur Atikah, Wan Ali, Wan Norsyukriah |
|---|---|
| Format: | Book Section |
| Language: | English |
| Published: |
Penerbit UTHM
2017
|
| Subjects: | |
| Online Access: | http://eprints.uthm.edu.my/4696/ http://eprints.uthm.edu.my/4696/1/Chapter%205_EDP_S1.pdf |
Similar Items
Experimental investigation the effect of nanofluid on the pressure drop across the solar collector
by: Nurshahiera, Mohidin
Published: (2013)
by: Nurshahiera, Mohidin
Published: (2013)
Effects of temperature and time on the physical characteristics of moist cakes baked in air fryer
by: Zakuan Azmi, Mazidah Mior, et al.
Published: (2019)
by: Zakuan Azmi, Mazidah Mior, et al.
Published: (2019)
Effect of pre-treatment in producing pumpkin powder using air fryer and its application in 'Bingka' baking
by: Nik Murzaini, Nik Masturah, et al.
Published: (2020)
by: Nik Murzaini, Nik Masturah, et al.
Published: (2020)
Optimization of processing conditions in drying of different parts pumpkin powder using air fryer method
by: Nik Murzaini, Nik Masturah, et al.
Published: (2016)
by: Nik Murzaini, Nik Masturah, et al.
Published: (2016)
Effects of different operating conditions of air fryer and convection oven on the quality of moist chocolate cake
by: Mior Zakuan Azmi, Mazidah
Published: (2019)
by: Mior Zakuan Azmi, Mazidah
Published: (2019)
Investigation of machining performance of the PVD coated tungsten carbide by sandblasting pre-treatment
by: Hariz Sufiyan, Mohamed Sunari
Published: (2012)
by: Hariz Sufiyan, Mohamed Sunari
Published: (2012)
Low Pressure Strand Burner for Solid Propellant Burning Rate Studies
by: Amir, Aziz, et al.
Published: (2013)
by: Amir, Aziz, et al.
Published: (2013)
Implications Of Pressure And Range Of Motion On Posterior Fixation Of Thoracolumbar Burst Fractures
by: Marzuki, Nur Aimi Amanina Mohd
Published: (2019)
by: Marzuki, Nur Aimi Amanina Mohd
Published: (2019)
Effect Of Pressure And Droplet Number On Smt Adhesive Dispensing
by: Yusoff, Nur Maisara Mohamed
Published: (2019)
by: Yusoff, Nur Maisara Mohamed
Published: (2019)
The Influence of Gouge Defects on Failure Pressure of Steel Pipes
by: Nasrual Azuan, Alang, et al.
Published: (2013)
by: Nasrual Azuan, Alang, et al.
Published: (2013)
Prediction of Blood Pattern in S-Shaped Model of Artery under Normal Blood Pressure
by: Mohd Azrul Hisham, Mohd Adib, et al.
Published: (2013)
by: Mohd Azrul Hisham, Mohd Adib, et al.
Published: (2013)
Mahasiswa FKM ke Persidangan Pemimpin Belia Aceh-Malaysia
by: Mohd Najmi, Mohamad
Published: (2013)
by: Mohd Najmi, Mohamad
Published: (2013)
Water hammer analysis on high pressure due to stopping pump / Nur Zalynda Zakaria
by: Nur Zalynda , Zakaria
Published: (2019)
by: Nur Zalynda , Zakaria
Published: (2019)
Shallots skin peeler machine
by: Kamaruddin, Muhammad Hazeem, et al.
Published: (2017)
by: Kamaruddin, Muhammad Hazeem, et al.
Published: (2017)
Corrosion behaviour of poly-l-lactic acid coated magnesium by electrospinning / Wan Nur Atikah Haji Wan Nafi
by: Wan Nur Atikah, Haji Wan Nafi
Published: (2017)
by: Wan Nur Atikah, Haji Wan Nafi
Published: (2017)
High-Resolution Fibre Bragg Grating (FBG) Pressure Transducer for Low-Pressure Detection
by: Z. M., Hafizi, et al.
Published: (2019)
by: Z. M., Hafizi, et al.
Published: (2019)
Effect of Nanolubricant on Evaporator and Condenser Pressure of Automotive Air Conditioning System
by: M. Z., Sharif, et al.
Published: (2016)
by: M. Z., Sharif, et al.
Published: (2016)
The effect of fuel feed rate on temperature profiles of a cascading hearth with secondary swirl combustor
by: Wan Mohamed, Wan Ahmad Najmi, et al.
Published: (2002)
by: Wan Mohamed, Wan Ahmad Najmi, et al.
Published: (2002)
Analysis of diesel spray characteristic at high pressure injection
by: Norsyamsul Syazwan, Mohd Nuji
Published: (2012)
by: Norsyamsul Syazwan, Mohd Nuji
Published: (2012)
The Trends of Research in Compressed Natural Gas (CNG) Pressure Vessel Technology: An Overview
by: R. A., Bakar, et al.
Published: (2008)
by: R. A., Bakar, et al.
Published: (2008)
Investigation of the pressure ratio and efficiency of a turbocharger centrifugal compressor with a vaned diffuser
by: Hilmi, Amiruddin, et al.
Published: (2018)
by: Hilmi, Amiruddin, et al.
Published: (2018)
Development of intelligent leak detection system based on artificial pressure transient signal using integrated Kurtosis-based Algorithm for Z-filter Technique (I-Kaz)
by: Hanafi, M. Yusop, et al.
Published: (2017)
by: Hanafi, M. Yusop, et al.
Published: (2017)
Performance of TialN coated carbide tool in peck drilling stainless steel SS316L with pressurized minimum quantity lubrication
by: M., Malik, et al.
Published: (2014)
by: M., Malik, et al.
Published: (2014)
Development Of A High Pressure Chamber For Spray Vessels
by: Amirruddin, Abdul Kadir, et al.
Published: (2010)
by: Amirruddin, Abdul Kadir, et al.
Published: (2010)
Computer based instrumentation system for pressure measurement in matlab application
by: Nurliyana, Mohd Johari
Published: (2008)
by: Nurliyana, Mohd Johari
Published: (2008)
Optimum autofrettage pressure in thick cylinders
by: Ayob, Amran, et al.
Published: (2007)
by: Ayob, Amran, et al.
Published: (2007)
Multi dimensional modelling of a high pressure natural gas fuel injection process in prechamber of a single cylinder four-stroke engine
by: Muhamad Azman, Mohd Yamin
Published: (2012)
by: Muhamad Azman, Mohd Yamin
Published: (2012)
Heat transfer and pressure drop of water based hybrid Al2O3:SiO2 nanofluids in cooling plate of PEMFC
by: Muhammad Syafiq, Idris, et al.
Published: (2021)
by: Muhammad Syafiq, Idris, et al.
Published: (2021)
Finite element analysis of upper crankshaft six stroke engine using CAE software
by: Muhammad Nasiruddin, Anidin
Published: (2009)
by: Muhammad Nasiruddin, Anidin
Published: (2009)
3 in 1 processor coconut dehusker machine
by: Ngadiron, Mohamad Faridzuan, et al.
Published: (2017)
by: Ngadiron, Mohamad Faridzuan, et al.
Published: (2017)
Improvement of Cepstrum Analysis for the Purpose to Detect Leak, Feature and Its Location in Water Distribution System based on Pressure Transient Analysis
by: Hanafi, M. Yusop, et al.
Published: (2017)
by: Hanafi, M. Yusop, et al.
Published: (2017)
Cyclic pressure variations in a single-cylinder diesel engine fueled with biodiesel and antioxidant blends
by: Mohd Hafiz, Ali, et al.
Published: (2019)
by: Mohd Hafiz, Ali, et al.
Published: (2019)
Multipurpose automatic Kerisik packaging machine
by: Sukarman, Muhammad Izwan, et al.
Published: (2017)
by: Sukarman, Muhammad Izwan, et al.
Published: (2017)
Analysis of cylinder pressure cyclic variability operating with butanol blends in a diesel engine
by: Mohd Hafizil, Mat Yasin, et al.
Published: (2020)
by: Mohd Hafizil, Mat Yasin, et al.
Published: (2020)
Cylinder Pressure Cyclic Variations in a Diesel Engine operating with Biodiesel-Alcohol Blends
by: Mohd Hafizil, Mat Yasin, et al.
Published: (2017)
by: Mohd Hafizil, Mat Yasin, et al.
Published: (2017)
Electro-thermal characteristics of hybrid TiO2-SiO2 nanofluid coolants in an electrically-active system
by: Wan Ahmad Najmi, Wan Mohamed, et al.
Published: (2021)
by: Wan Ahmad Najmi, Wan Mohamed, et al.
Published: (2021)
Experimental investigation of the base flow and base pressure of sudden expansion nozzle
by: Saleel, Ahmed, et al.
Published: (2018)
by: Saleel, Ahmed, et al.
Published: (2018)
Burst pressure prediction of multiple cracks in pipelines
by: Norhaida, Ab. Razak, et al.
Published: (2013)
by: Norhaida, Ab. Razak, et al.
Published: (2013)
Interface pressure distributions through structural modifications
by: Abu Bakar, A R., et al.
Published: (2003)
by: Abu Bakar, A R., et al.
Published: (2003)
Robust and reliable dual the classification system with error compensation module
by: Ahmad Nasiruddin, Ab Razak
Published: (2014)
by: Ahmad Nasiruddin, Ab Razak
Published: (2014)
Similar Items
-
Experimental investigation the effect of nanofluid on the pressure drop across the solar collector
by: Nurshahiera, Mohidin
Published: (2013) -
Effects of temperature and time on the physical characteristics of moist cakes baked in air fryer
by: Zakuan Azmi, Mazidah Mior, et al.
Published: (2019) -
Effect of pre-treatment in producing pumpkin powder using air fryer and its application in 'Bingka' baking
by: Nik Murzaini, Nik Masturah, et al.
Published: (2020) -
Optimization of processing conditions in drying of different parts pumpkin powder using air fryer method
by: Nik Murzaini, Nik Masturah, et al.
Published: (2016) -
Effects of different operating conditions of air fryer and convection oven on the quality of moist chocolate cake
by: Mior Zakuan Azmi, Mazidah
Published: (2019)