Influence of HALO and Source/Drain Implantation on Threshold Voltage in 45nm PMOS Device
In this paper, we investigate the influence of process parameters like HALO and Source/Drain (S/D) Implantation on threshold voltage in 45nm PMOS device. The settings of process parameters were determined by using Taguchi experimental design method. The level of importance of the process paramete...
| Main Author: | |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
International Network for Scientific Information Publication (INSI)
2011
|
| Subjects: | |
| Online Access: | http://eprints.utem.edu.my/id/eprint/3797/ http://eprints.utem.edu.my/id/eprint/3797/1/%28J5%29_AJBAS_5%281%29_55-61.pdf |
| Summary: | In this paper, we investigate the influence of process parameters like HALO and
Source/Drain (S/D) Implantation on threshold voltage in 45nm PMOS device. The settings of process
parameters were determined by using Taguchi experimental design method. The level of importance
of the process parameters on threshold voltage was determined by using analysis of variance
(ANOVA). The virtual fabrication of the PMOS device was performed by using ATHENA module.
While the electrical characterization of the device was implemented by using ATLAS module. These
two modules were combined with Taguchi method to aid in design and optimizer the process
parameters. Besides HALO and S/D implantation, the other two process parameters which used were
oxide growth temperature and silicide anneal temperature. These process parameters were varied for
3 levels to perform 9 experiments. Threshold voltage (VTH) results were used as the evaluation
variables. Then, the results were subjected to the Taguchi method to determine the optimal process
parameters and to produce predicted values. The predicted values of the process parameters were
verified successfully with ATHENA and ATLAS's simulator. In this research, halo implantation found
to be the major factor affecting the threshold voltage (70%), whereas silicide anneal temperature was
the second ranking factor (17%). As conclusions, halo implantation was identified as one of the
process parameters that has the strongest effect on the response characteristics. While the S/D
Implantation was identified as an adjustment factor to get the threshold voltage closer to the nominal
value (-0.150V). |
|---|