Interfacing SAW resonators for wireless high temperature applications

QR Code

Interfacing SAW resonators for wireless high temperature applications

In the recent year, wireless sensor has become the interest of research due to their ability to monitor remotely especially in harsh condition. Here a double surface acoustic wave (SAW) resonator system for wireless high temperature sensor application is discussed. The system also did not need any e...

Full description

Bibliographic Details
Main Authors:	Sarraf, Mohammad Javadian, Hamidon, Mohd Nizar, Mohd Isa, Maryam, Ismail, Alyani, Zarabi, Amir Reza
Format:	Article
Language:	English
Published:	International Frequency Sensor Association Publishing 2011
Online Access:	http://psasir.upm.edu.my/id/eprint/23064/ http://psasir.upm.edu.my/id/eprint/23064/1/Interfacing%20SAW%20resonators%20for%20wireless%20high%20temperature%20applications.pdf

Similar Items

Design and simulation of one-port SAW resonator for wireless and high temperature application
by: Mousavi, Sayed Alireza, et al.
Published: (2008)

Development of passive system for high temperature wireless sensor applications
by: Sarraf, Mohammad Javadian
Published: (2012)

Design and modeling of one-port SAW resonator at 2.45 GHz for wireless application base on GaPO4
by: Mousavi, Sayed Alireza, et al.
Published: (2008)

Hydrogen gas sensor using double SAW resonator system
by: Yunusa, Zainab, et al.
Published: (2016)

Relation of parallel resistance to the passive double SAW resonator
by: Sim, Guan Ling, et al.
Published: (2015)

On-chip hotplate for temperature control of CMOS SAW resonators
by: Nordin, Anis Nurashikin, et al.
Published: (2008)

Temperature control circuit for surface acoustic wave (SAW) resonators
by: Ashari, Zainab, et al.
Published: (2011)

Micro-hotplate based temperature stabilization system for CMOS SAW resonators
by: Nordin, Anis Nurashikin, et al.
Published: (2009)

Design and analysis of helical antenna for short-range ultra-high-speed THz wireless applications
by: Raad Mayoof Hajiyat, Zahraa, et al.
Published: (2021)

Theoretical design of CMOS SAW resonator
by: Soeroso, Iksannurazmi Bambang, et al.
Published: (2012)

Nonlinear dynamics of resonant tunneling optoelectronic circuits for wireless/Optical interfaces
by: Romeira, B., et al.
Published: (2009)

Centered-gap and aligned-gap multiple split ring resonator for bio-sensing application
by: Mat Rusni, Izyani, et al.
Published: (2013)

Low power and high voltage swing cascode Pierce oscillator for MEMS SAW resonators
by: Md Hamzah, Mohd Haidar, et al.
Published: (2016)

Implementation of CMOS oscillator for CMOS SAW resonator
by: Karim, Jamilah, et al.
Published: (2016)

Piezoelectric characteristics of CMOS compatible AIN SAW resonators
by: Md Ralib @ Md Raghib, Aliza 'Aini, et al.
Published: (2014)

Finite modeling of SAW resonator for DF-1 cells
by: Jamil, Nadira, et al.
Published: (2010)

Design and modeling of MEMS SAW resonator on Lithium Niobate
by: Ramli, Noor Amalina, et al.
Published: (2011)

Design of a pierce oscillator for CMOS SAW resonator
by: Karim, Jamilah, et al.
Published: (2012)

Sensitivity enhancement of chemical sensor using aligned-gap split ring resonator
by: Mat Rusni, Izyani, et al.
Published: (2018)

Aligned-gap multiple split ring resonator for dielectric sensing application
by: Mat Rusni, Izyani, et al.
Published: (2014)

Wireless propagation studies in highly resonant and dynamic environments
by: Panitz, Mark
Published: (2011)

Development of an RF-CMOS surface acoustic wave (SAW) resonator
by: Sidek, Fatini, et al.
Published: (2011)

Highly efficient magnetic resonance coupling wireless power transfer for 5G applications
by: Kamarudin, Saidatul Izyanie
Published: (2021)

Nanotechnology for wireless gas sensor
by: Hamidon, Mohd Nizar
Published: (2017)

Design interface circuits for thick film heater for a gas sensor resistor
by: Khakpour, Reza, et al.
Published: (2009)

Design and implementation of interface circuitry for CMOS-based SAW gas sensors
by: Yasin, F. M., et al.
Published: (2005)

An aligned-gap and centered-gap rectangular multiple split ring resonator for dielectric sensing applications
by: Mat Rusni, Izyani, et al.
Published: (2014)

Multi‑frequency CMOS oscillator based on CMOS MEMS SAW resonator
by: Karim, Jamilah, et al.
Published: (2015)

Multi-frequency CMOS oscillator based on CMOS MEMS SAW resonator
by: Karim, Jamilah, et al.
Published: (2015)

Design and analysis of a boosted pierce oscillator using MEMS SAW resonators
by: Md Hamzah, Mohd Haidar, et al.
Published: (2018)

Biosensing using aligned-gap multiple split ring resonator at microwave frequency for possible application in halal industry
by: Mat Rusni, Izyani, et al.
Published: (2014)

High-performance THz metallic axial mode helix antenna with optimised truncated hollow cone ground plane for 6G wireless communication system
by: Mayoof Hajiyat, Zahraa Raad, et al.
Published: (2024)

Design of auto control interface circuit for thick film heater gas sensor
by: Khakpour, Reza, et al.
Published: (2010)

Development of an auto-calibrated interfacing circuit for thick film multi-gas sensor
by: Khakpour, Reza, et al.
Published: (2013)

Application of Taguchi signal to noise ratio design method to ZnO thin film CMOS SAW resonators
by: Md Ralib @ Md Raghib, Aliza 'Aini, et al.
Published: (2019)

Silicon nanowire interface circuit for biosensing applications
by: Usman, Kamilu Iman, et al.
Published: (2015)

An interface of wireless network traffic analysis
by: Mohamed Almoustafa, Ahmad Mohamed Jamil
Published: (2007)

Resonant coils analysis for inductively coupled wireless power transfer applications
by: Nataraj, Chandrasekharan, et al.
Published: (2016)

Antenna in 6G wireless communication system: specifications, challenges, and research directions
by: Hajiyat, Zahraa Raad Mayoof, et al.
Published: (2021)

5G magnetic resonance coupling planar spiral coil wireless power transfer
by: Kamarudin, Saidatul Izyanie, et al.
Published: (2022)