Analysis of diesel spray characteristic using single hole SAC nozzle and VCO nozzle
This study was focus to investigate the diesel spray characteristics and atomization performance. The influences of injector nozzle geometry and injection pressure conditions on a diesel fuel spray were examined and predicted by using ANSYS FLUENT software. A flow domain and constant volume combusti...
| Main Author: | Mohd Fazwan, Ishak |
|---|---|
| Format: | Undergraduates Project Papers |
| Language: | English |
| Published: |
2012
|
| Subjects: | |
| Online Access: | http://umpir.ump.edu.my/id/eprint/4911/ http://umpir.ump.edu.my/id/eprint/4911/1/32.Analysis%20of%20diesel%20spray%20characteristic%20using%20single%20hole%20SAC%20nozzle%20and%20VCO%20nozzle.pdf |
Similar Items
Analysis of emulsion fuel spray characteristics using SAC and VCO nozzle
by: Che Hanisah, Yaacob
Published: (2012)
by: Che Hanisah, Yaacob
Published: (2012)
A study of the spray characteristic for valve covered orifice diesel nozzle injector using CFD
by: Ahmad Aizuddin Faiz, Che Jaafar
Published: (2013)
by: Ahmad Aizuddin Faiz, Che Jaafar
Published: (2013)
Influence of orifice nozzle geometry on flow and spray characteristics
by: Noor Azuani, Suliman
Published: (2013)
by: Noor Azuani, Suliman
Published: (2013)
Study on spray nozzle of diesel engine
by: Nur Syafiqah, Mohd Nawawi
Published: (2011)
by: Nur Syafiqah, Mohd Nawawi
Published: (2011)
Rapeseed oil spray development of diesel idi spray nozzle under air movement influence
by: Sapit, Azwan, et al.
Published: (2016)
by: Sapit, Azwan, et al.
Published: (2016)
The effect of nozzle diameter, injection pressure and ambient temperature on spray characteristics in diesel engine
by: Andsaler, Adiba Rhaodah, et al.
Published: (2017)
by: Andsaler, Adiba Rhaodah, et al.
Published: (2017)
Numerical simulation on the spray angle of the dual-layer hole nozzle in a partition combustion system of the diesel Engine
by: Hongkun, Lu, et al.
Published: (2024)
by: Hongkun, Lu, et al.
Published: (2024)
Study on characteristics behavior of developing nozzle for aerosol spray
by: Ramlan, Aslinda
Published: (2012)
by: Ramlan, Aslinda
Published: (2012)
Analysis and Optimization of an Aftermarket Intercooler
Spray‟s Nozzle
by: M.I.N, Ma'arof, et al.
Published: (2022)
by: M.I.N, Ma'arof, et al.
Published: (2022)
Design and fabricate of micro spray nozzle
by: Muhammad Syafiq, Razali
Published: (2012)
by: Muhammad Syafiq, Razali
Published: (2012)
Simulation and control of spray drying using nozzle atomizer spray dryer
by: Tan, Lee Woun, et al.
Published: (2009)
by: Tan, Lee Woun, et al.
Published: (2009)
Influence of Actuator Nozzle Angle on the Flow Characteristics in Pressurized-Metered Dose Inhaler Using CFD
by: Abd Rahman, Muhammad Faqhrurrazi, et al.
Published: (2020)
by: Abd Rahman, Muhammad Faqhrurrazi, et al.
Published: (2020)
Influence of spray volumes and nozzles on contamination of spray operator in golf course
by: Omar, Dzolkhifli, et al.
Published: (1999)
by: Omar, Dzolkhifli, et al.
Published: (1999)
Performance Of Plate Distributor And Spray Nozzle For An Unpacked Saturator.
by: Adlan, M N, et al.
Published: (2004)
by: Adlan, M N, et al.
Published: (2004)
An investigational research of spray pattern for deflector flat spray nozzle using horizontal patternator
by: Sies, M.F., et al.
Published: (2019)
by: Sies, M.F., et al.
Published: (2019)
Effect of liquid properties (water and lime juice) on spray characteristics of deflected flat spray nozzle (AL-75)
by: Abd Rahman, Muhammad Faqhrurrazi
Published: (2017)
by: Abd Rahman, Muhammad Faqhrurrazi
Published: (2017)
Design of wind nozzle for nozzle augmented wind turbine
by: Mohammed Aldhufairi, et al.
Published: (2022)
by: Mohammed Aldhufairi, et al.
Published: (2022)
Empirical model of spray drying of whole milk powder using nozzle atomizer spray dryer
by: Tan, Lee Woun, et al.
Published: (2010)
by: Tan, Lee Woun, et al.
Published: (2010)
Empirical modeling, simulation and control of spray drying process using nozzle atomizer spray dryer
by: Tan, Lee Woun
Published: (2011)
by: Tan, Lee Woun
Published: (2011)
Dripping dynamics from a tilted nozzle / Amaraja Taur
by: Amaraja, Taur
Published: (2014)
by: Amaraja, Taur
Published: (2014)
Characteristic study of flat spray nozzle by using Particle Image Velocimetry (PIV) and ANSYS simulation method
by: Pairan, M. Rasidi, et al.
Published: (2022)
by: Pairan, M. Rasidi, et al.
Published: (2022)
Simulation of gaseous fuel injector geometries of mult holes nozzle by using CNG engine
by: Muhamad Akhbar Osman, Md. Hashim
Published: (2009)
by: Muhamad Akhbar Osman, Md. Hashim
Published: (2009)
Investigation of the effects of nozzle exit mach number and nozzle pressure ratio on axisymmetric flow through suddenly expanded nozzles
by: Khan, Sher Afghan, et al.
Published: (2019)
by: Khan, Sher Afghan, et al.
Published: (2019)
Modeling and simulation of the supersonic jet nozzle for oxygen injection system at electric arc furnace
by: Suhaimi, Mohd Sukri
Published: (2010)
by: Suhaimi, Mohd Sukri
Published: (2010)
Influence of Nozzle Design on the Performance of a Partial Combustion Lance: A CFD Study
by: Law, Woon Phui, et al.
Published: (2015)
by: Law, Woon Phui, et al.
Published: (2015)
Comparison fine spray nozzle for two phase flow within experimental and simulation
by: Ali, Hafiz Aizat
Published: (2015)
by: Ali, Hafiz Aizat
Published: (2015)
CFD analysis of CD nozzle and effect of nozzle pressure ratio on pressure and velocity for suddenly expanded flows
by: Khan, Sher Afghan, et al.
Published: (2018)
by: Khan, Sher Afghan, et al.
Published: (2018)
Analysis of wear on abrasive water jet nozzle
by: Izzudin, Nazar
Published: (2016)
by: Izzudin, Nazar
Published: (2016)
Stress analysis of torispherical shell with radial nozzle
by: Ayob, Amran
Published: (2006)
by: Ayob, Amran
Published: (2006)
A comparison study of liquid and vapor phase development at spray boundary of diesel spray, BDF and SVO spray
by: Adam Mohd Izhan, Noor Azam
Published: (2012)
by: Adam Mohd Izhan, Noor Azam
Published: (2012)
Study of kitchen hood water mist system for cooking emission (UL1046) filtration with low pressure delected nozzle
by: Mohamad Jamil, Ahmad Syakir
Published: (2017)
by: Mohamad Jamil, Ahmad Syakir
Published: (2017)
Effect of nozzle assembly, insulation and operating condition on partial combustion unit performance : computational fluid dynamics and experimental study
by: Law, Woon Phui
Published: (2017)
by: Law, Woon Phui
Published: (2017)
Studies on flow from converging nozzle and the effect of nozzle pressure ratio for area ratio of 6.25
by: Ashfaq, Syed, et al.
Published: (2014)
by: Ashfaq, Syed, et al.
Published: (2014)
Nozzle and seat geometry for direct injection.
by: Sahari, Barkawi
Published: (2006)
by: Sahari, Barkawi
Published: (2006)
Thermal performance enhancement of non-premixed syngas combustion in a partial combustion unit by winged nozzle: Experimental and CFD study
by: Law, Woon Phui, et al.
Published: (2019)
by: Law, Woon Phui, et al.
Published: (2019)
Enhanced mitigation of fire and explosion risks due to hydrogen leakage using targeted nitrogen nozzle spray approach
by: Tan, Wei Jian, et al.
Published: (2022)
by: Tan, Wei Jian, et al.
Published: (2022)
CFD analysis of the supersonic nozzle flow with sudden expansion
by: Ahmed, Khizar Pathan, et al.
Published: (2016)
by: Ahmed, Khizar Pathan, et al.
Published: (2016)
Innovation and development of a high pressure water nozzle discharged with curtain spray for oil leakage in offshore
by: Muhammad Nadzir, Nordin
Published: (2013)
by: Muhammad Nadzir, Nordin
Published: (2013)
Numerical analysis of convergent-divergent nozzle using finite element method
by: G M, Fharukh Ahmed, et al.
Published: (2018)
by: G M, Fharukh Ahmed, et al.
Published: (2018)
Super nozzle cleaner for ceiling fan blade
by: Nur Afiqah, Mohd Hasmadi
Published: (2018)
by: Nur Afiqah, Mohd Hasmadi
Published: (2018)
Similar Items
-
Analysis of emulsion fuel spray characteristics using SAC and VCO nozzle
by: Che Hanisah, Yaacob
Published: (2012) -
A study of the spray characteristic for valve covered orifice diesel nozzle injector using CFD
by: Ahmad Aizuddin Faiz, Che Jaafar
Published: (2013) -
Influence of orifice nozzle geometry on flow and spray characteristics
by: Noor Azuani, Suliman
Published: (2013) -
Study on spray nozzle of diesel engine
by: Nur Syafiqah, Mohd Nawawi
Published: (2011) -
Rapeseed oil spray development of diesel idi spray nozzle under air movement influence
by: Sapit, Azwan, et al.
Published: (2016)