Performance assessment of direct injection compressed natural gas vehicle at different injection pressures using speed-sweep test method

QR Code

Performance assessment of direct injection compressed natural gas vehicle at different injection pressures using speed-sweep test method

This paper presents an experimental study on a high-pressure direct injection compressed natural gas engine (HPDI-CNG) vehicle using speed-sweep test method. The objective of this work is to assess the performances of the HPDI-CNG after installation of a new DI configuration on the engine. The gas d...

Full description

Bibliographic Details
Main Authors:	Mohd Fadzil, Rahim, Abdul Aziz, Jaafar, Rizalman, Mamat, Zahari, Taha
Format:	Article
Language:	English
Published:	IOP Publishing
Subjects:	TA Engineering (General). Civil engineering (General) TJ Mechanical engineering and machinery TL Motor vehicles. Aeronautics. Astronautics
Online Access:	http://umpir.ump.edu.my/id/eprint/29065/ http://umpir.ump.edu.my/id/eprint/29065/1/Rahim_2020_IOP_Conf._Ser.__Mater._Sci._Eng._788_012068%20-%20MOHD%20FADZIL%20BIN%20ABDUL%20RAHIM.pdf

Similar Items

Injection characteristics study of high-pressure direct injector for Compressed Natural Gas (CNG) using experimental and analytical method
by: Mohd Fadzil, Abdul Rahim, et al.
Published: (2017)

Injection Characteristics Study of High Pressure Direct Injector for Compressed Natural Gas (CNG) using Experimental and Analytical Method
by: Zahari, Taha, et al.
Published: (2017)

Modelling and calibration of high-pressure direct injection compressed natural gas engine
by: Mohd Fadzil, Abdul Rahim
Published: (2021)

Effect of Injection Pressure, Injection Duration, and Injection Frequency on Direct Injector’s Mass Flow Rate for Compressed Natural Gas Fuel
by: Mohamad Hafizul Rahman, Alias, et al.
Published: (2018)

Simulation study on the effect of fuel injection and air intake boundary setup on the brake torque response by using comprehensive vehicle model for natural gas vehicle (NGV)
by: Ab Rahim, M. F., et al.
Published: (2020)

Electronic fuel injection controller for natural gas vehicle motorcycle
by: Indraguna, Vannebula Eka
Published: (2006)

AVL Boost Simulation of Engine Performance and Emission for Compressed Natural Gas Direct Injection Engine
by: Zahari, Taha, et al.
Published: (2014)

Finite Element Simulation of a Steady-State Stress Distribution in a Four Stroke Compressed Natural Gas-Direct Injection Engine Cylinder Head
by: Shamsudeen, A., et al.
Published: (2006)

Simulation of direct injection, mixing and combustion of CNG fuel in a single - cylinder engine with different injector orientations using CFD
by: Mohd Azlan Fahmi, Muhammad Azmi, et al.
Published: (2022)

Design and Simulation of a Cylinder Head Structure for A Compressed Natural Gas Direct Injection Engine
by: A., Shamsudeen, et al.
Published: (2013)

Study of sequential multipoint injection nozzle effect of compressed natural gas engine
by: Mohd Adib, Alias
Published: (2008)

Experimental test of a new compressed natural gas direct injection engine
by: Hassan, Masjuki, et al.
Published: (2009)

High-Voltage Ignition Circuit For Compressed Natural Gas Direct Injection Engine
by: Omar, Azimah
Published: (2007)

Direct injection of compressed natural gas (CNG) fuel for reciprocating piston internal combustion engine
by: Sahari, Barkawi, et al.
Published: (2008)

Numerical Simulation On The Performances And Emissions Of The Direct Injection Compression Ignition Engine
by: Yap, Mew Yaw
Published: (2019)

Effect of injection position on throttle body injection mixer for compressed natural gas motorcycle
by: Chang, Yvonne S. H., et al.
Published: (2005)

Compressed natural gas fuel injection system and method
by: Sahari, Barkawi
Published: (2010)

Compressed Natural Gas Passenger Vehicle Development â€“ Issues and Challenges
by: Sahari, Barkawi, et al.
Published: (2006)

Influence of injection and ignition of CNG fuelled direct injection engine at constant speed
by: Hassan, Mohd Khair, et al.
Published: (2010)

Study of effects of fuel injection pressure on performance for diesel engine
by: Ahmad Muizz, Ishak
Published: (2012)

Combustion, performances, and emissions characteristics of Hermetia illucens larvae oil in a direct injection compression ignition engine
by: Mohd Kamal, Kamaruzzaman, et al.
Published: (2019)

Development of control strategy of electronic control unit for compressed natural gas direct injection engine
by: Hassan, Mohd Khair
Published: (2011)

Influence of Engine Speed and Injection Timings on In-Cylinder Heat Transfer for Port Injection Hydrogen Fueled Engine
by: M. M., Rahman, et al.
Published: (2010)

Comparison of efficiency and emission characteristics in a direct-injection compression ignition engine fuelled with iso-octane and methanol under low temperature combustion conditions
by: Xu, Leilei, et al.
Published: (2022)

Effect of Fuel Injection Timing of Hydrogen Rich Syngas Augmented With Methane in Direct-Injection Spark-Ignition Engine
by: Hagos, F. Y., et al.
Published: (2017)

Methane Enrichment of Syngas (H2/CO) in a Spark-ignition Direct-injection Engine: Combustion, Performance and Emissions Comparison With Syngas and Compressed Natural Gas
by: Hagos, F. Y., et al.
Published: (2015)

Performance and emission control of using steam injection on medium-speed marine diesel engine running with biodiesel fuel
by: Wan Mohd Noor, Che, et al.
Published: (2021)

Effects of Pilot Injection Timing and EGR on a Modern V6 Common Rail Direct Injection Diesel Engine
by: Nik Rosli, Abdullah, et al.
Published: (2013)

CFD study several injection timing on homogeneous charge compression ignition hydrogen diesel dual fuels
by: Praptijanto, Achmad, et al.
Published: (2019)

Analysis of diesel spray characteristic at high pressure injection
by: Norsyamsul Syazwan, Mohd Nuji
Published: (2012)

Formulation of ceramics feedstock for low pressure injection moulding
by: Tan, Jia Hui
Published: (2021)

Effect of Mixture Strength and Injection Timing on Combustion Characteristics of a Direct Injection Hydrogen-Fueled Engine
by: Hamada, Khalaf I., et al.
Published: (2013)

Effect of various manifold absolute pressures and air flowrate on throttle body injection mixer in compressed natural gas motorcycle
by: Chang, Siu Hua, et al.
Published: (2007)

Effect of various manifold absolute pressures and air flowrates on throttle body injection mixer in compressed natural gas motorcycle
by: Chang, Siu Hua, et al.
Published: (2007)

Performance investigation of vapor compression cycle with a variable speed compressor and refrigerant injection / Ahmed J. Hamad...[et al.]
by: J. Hamad, Ahmed, et al.
Published: (2019)

Study of spray breakup and mixture in a gasoline direct injection engine by using simulation
by: Muzammil, Mohamad Alias
Published: (2013)

Numerical study of dual fuel engine using proportional natural gas split injection
by: Felayati, Frengki Mohamad, et al.
Published: (2019)

Performance and NOx emissions of a diesel engine with water injection
by: Aziz, Amir, et al.
Published: (2017)

WETTABILITY INFLUENCE ON HYSTERESIS FOR IMMISCIBLE WATER-ALTERNATING-GAS (WAG) INJECTION
by: Nasir, F.M., et al.
Published: (2009)

Fuel rail for direct injection gaseous engine.
by: Taha, Zahari, et al.
Published: (2006)