Modelling of Catalytic Converter in CNGV Cold-start Engine

QR Code

Modelling of Catalytic Converter in CNGV Cold-start Engine

Modelling of cold-start engine behaviour at catalytic converter is a difficult task as it involves complicated convection-diffusion-reactions flow.This work presents a CFD calculation to predict the transient thermal and conversion characteristics of catalytic converter during the light-off operatio...

Full description

Bibliographic Details
Main Authors:	Jolius, Gimbun, Chuah, T.G, Thomas, S. Y. Choong, Sahari, Barkawi, Fakhru'l-Razi, A
Format:	Article
Language:	English
Published:	Institute of Advanced Technology 2004
Subjects:	TP Chemical technology
Online Access:	http://umpir.ump.edu.my/id/eprint/18452/ http://umpir.ump.edu.my/id/eprint/18452/1/Adv%20Technol%202004.pdf

Similar Items

Prediction of CO and NOx Abatement in Catalytic Converter of a Compressed Natural Gas Vehicle (CNGV) Cold-Start Engine
by: Abdullah, Luqman Chuah, et al.
Published: (2011)

Prediction of CO and NOx abatement in catalytic converter of a compressed natural gas vehicle (CNGV) cold-start engine
by: Abdullah, Luqman Chuah, et al.
Published: (2009)

3D CFD Modelling of Aerocyclones Operating at High Temperature
by: Jolius, Gimbun, et al.
Published: (2004)

A CFD analysis on the effect of vortex finder and cylindrical length on cyclone hydrodynamics and centrifugal forces
by: Luqman Chuah, Abdullah, et al.
Published: (2008)

An investigation into the cold start performance of automotive diesel engines
by: Burrows, John Antony
Published: (1998)

The influence of temperature and inlet velocity on cyclone pressure drop: a CFD study
by: Gimbun, Jolius, et al.
Published: (2005)

Prediction of the effects of cone tip diameter on the cyclone performance
by: Gimbun, Jolius, et al.
Published: (2005)

Influences on the cold start behaviour of a diesel engine at reduced compression ratio
by: MacMillan, David James
Published: (2009)

Fuel consumption and pollutant emissions of spark ignition engines during cold-started drive cycles
by: Darnton, Nicholas Julian
Published: (1997)

Effect of synthesis condition on the growth of SWCNTs via catalytic chemical vapor deposition
by: Setareh Monshi Toussi,, et al.
Published: (2011)

Effect of synthesis condition on the growth of SWCNTs via catalytic chemical vapour deposition
by: Toussi, Setareh Monshi, et al.
Published: (2011)

Normalization-based neighborhood model for cold start problem in recommendation system
by: Zahid, Aafaq, et al.
Published: (2020)

Development and test of a new catalytic converter for natural gas fuelled engine
by: Kalam, Md. Abul, et al.
Published: (2009)

Experimental analysis and simulation of catalytic converters
by: Mohiuddin, A. K. M.
Published: (2011)

The prevention of thermal losses from automotive lubricants to improve cold start efficiency
by: Roberts, Andrew P.
Published: (2015)

Materials, energy and CNGDI vehicle engineering
by: Sahari, Barkawi
Published: (2009)

Analysis and comparison of performance characteristics of catalytic converters
by: Mohiuddin, A. K. M., et al.
Published: (2005)

Experimental investigation and simulation of catalytic converter performance
by: Mohiuddin, A. K. M., et al.
Published: (2005)

Catalytic combustion of hydrogen and methane for autothermal reformer start-up ignition system
by: Razak, M. M. A., et al.
Published: (2004)

Test method and optimisation of ignition system parameters inside CNG-DI engine.
by: Sahari, Barkawi
Published: (2005)

Method for controlling multiple-injection of gaseous fuel in a direct injection engine.
by: Sahari, Barkawi
Published: (2005)

Development of catalytic converter using non-precious metals
by: Mohiuddin, A. K. M.
Published: (2015)

Experimental analysis and comparison of performance characteristics of catalytic converters
by: Mohiuddin, A. K. M.
Published: (2011)

Development of catalytic converter using low cost metal
by: Mohiuddin, A. K. M.
Published: (2014)

Fluidized bed catalytic chemical vapor deposition synthesis of carbon nanotubes-a review
by: Danafar, Firoozeh, et al.
Published: (2009)

Chemical engineering input in agricultural production
by: Bidin, Abdul Rahman, et al.
Published: (1984)

Design and fabrication of a new converter system for pre-heating vehicle catalytic converter (Not for loan)
by: Zerin, Ipshita
Published: (2018)

Numerical Simulation Of Nitrous Oxide And Carbon Monoxide Abatement In The Catalytic Converter Of A Compressed Natural Gas Engine
by: Cheong, Yoon Kwan
Published: (2008)

A comparative evalaution on the performance and emission characteristics of an internal combustion engine using ceramic and metallic catalytic converter
by: Jajuli, Fatin Afiqah
Published: (2017)

Automotive catalytic converters : current status and some future perspectives
by: Mohiuddin, A. K. M., et al.
Published: (2011)

An innovative procedure for large-scale synthesis of carbon nanotubes by fluidized bed catalytic vapor deposition technique
by: Ahmadun, Fakhru'l-Razi, et al.
Published: (2009)

The effect of reactor temperature and hydrogen flow rate on carbon nanofibers (CNFs) characterizations and their adsorption capacity
by: Abdul Halif, Norzilah, et al.
Published: (2012)

Investigation of non-precious metals for the development of low cost catalytic converter
by: Mohiuddin, A. K. M., et al.
Published: (2011)

Experimental analysis and comparison performance characterisation of catalytic converters including simulation
by: Mohiuddin, A. K. M., et al.
Published: (2007)

Development of low cost catalytic converter from non-precious metals
by: Mohiuddin, A. K. M.
Published: (2011)

Computational fluid dynamics (CFD) analysis for a catalytic converter design
by: Amirnordin, Shahrin Hisham
Published: (2009)

Comparison of performance and emission characteristics between ceramic and metallic catalytic converter
by: W Abdul Rahman, Wan Fakhrurrazi
Published: (2018)

Fluidized bed chemical vapor deposition synthesis of carbon nanotubes using different Fe-Co/Alumina catalytic powders
by: Ahmadun, Fakhru'l-Razi, et al.
Published: (2012)

Catalytic Performance of Cement Clinker Supported Nickel Catalyst In Glycerol Dry Reforming
by: Hua, Chyn Lee, et al.
Published: (2014)

Liquid State Bioconversion of Sewage Treatment Plant Sludge
by: Ahmadun, Fakhru'l-Razi
Published: (2010)