Mode III stress intensity factors of sickle-shaped surface cracks in round bars / Al Emran Ismail
The solutions of stress intensity factors (SIFs) of sickle-shaped surface crack in round bars are not currently available especially when the cracks are subjected to mode III loading. Mode I SIFs can be obtained in open literature however they are also insufficiently completed. Therefore, this paper...
| Main Author: | Ismail, Al Emran |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
Faculty of Mechanical Engineering Universiti Teknologi MARA (UiTM)
2016
|
| Subjects: | |
| Online Access: | https://ir.uitm.edu.my/id/eprint/16138/ |
Similar Items
Stress intensity factors for surface cracks in round bar under single and combined loadings
by: Ismail, Al Emran, et al.
Published: (2012)
by: Ismail, Al Emran, et al.
Published: (2012)
Finite element analysis of j-integral for surface cracks in round bars under combined mode i loading
by: Ismail, Al Emran, et al.
Published: (2017)
by: Ismail, Al Emran, et al.
Published: (2017)
Crack behavior of heat treated sintered steel under cyclic loading / Al Emran Ismail
by: Ismail, Al Emran
Published: (2003)
by: Ismail, Al Emran
Published: (2003)
Mode i stress intensity factors of slanted cracks
by: Ismail, Al Emran, et al.
Published: (2017)
by: Ismail, Al Emran, et al.
Published: (2017)
Fatigue crack initiation in powder metallurgically-processed tool steel material under cyclic loading / Al Emran Ismail and Mohd Nor Berhan
by: Ismail, Al Emran, et al.
Published: (2006)
by: Ismail, Al Emran, et al.
Published: (2006)
Parental stress among patients with schizophrenia spectrum disorder in Hospital Kuala Lumpur / Fatimah Emran
by: Emran, Fatimah
Published: (2019)
by: Emran, Fatimah
Published: (2019)
Effect of curved surface of a shoulder fillet round bar on stress concentration factor for axial tension loading
by: Prajapati, Hiren, et al.
Published: (2023)
by: Prajapati, Hiren, et al.
Published: (2023)
Stress intensity factors for embedded cracks within torsionally loaded square prismatic bars / Zhou Ding
by: Zhou, Ding
Published: (2017)
by: Zhou, Ding
Published: (2017)
Pemeliharaan rumah – rumah kedai di Jalan Pudu / Ali Emran Shaarani
by: Ali Emran, Shaarani
Published: (1990)
by: Ali Emran, Shaarani
Published: (1990)
The factors influencing health wellbeing in Celcom Johor / Badrul Emran Badrul Hisham
by: Badrul Hisham, Badrul Emran
Published: (2018)
by: Badrul Hisham, Badrul Emran
Published: (2018)
Tetrahedral meshing by finite element analysis for surface cracks with respect to corner point singularities for smooth and stepped round bars / Sharon Teh Ai Ping
by: Sharon Teh , Ai Ping
Published: (2022)
by: Sharon Teh , Ai Ping
Published: (2022)
Mode I stress intensity factor for a cracked plate with an integrated piezoelectric actuator
by: Abuzaid, Ahmed, et al.
Published: (2015)
by: Abuzaid, Ahmed, et al.
Published: (2015)
Al-qira'at al-qur'aniyyat sebagai satu aspek fonologi Bahasa Arab / Emran bin Hj. Bakar.
by: Bakar, Emran
Published: (1995)
by: Bakar, Emran
Published: (1995)
Natural logarithm sliding mode control (ln-SMC) using EMRAN for active engine mounting system
by: Wijaya, Andika Aji, et al.
Published: (2010)
by: Wijaya, Andika Aji, et al.
Published: (2010)
Closed-form solution for stress intensity factors of semi elliptical surface cracks with different inclinations in a cylinder bar under pure tension and pure torsion / Mohammadkazem Ramezani
by: Mohammadkazem, Ramezani
Published: (2018)
by: Mohammadkazem, Ramezani
Published: (2018)
Probabilistic stress intensity factor prediction of surface crack using bootstrap sampling method
by: M.N.M., Husnain, et al.
Published: (2022)
by: M.N.M., Husnain, et al.
Published: (2022)
Antiplane shear mode stress intensity factor for a slightly perturbed circular crack subject to shear load
by: Nik Mohd Asri Nik Long,, et al.
Published: (2011)
by: Nik Mohd Asri Nik Long,, et al.
Published: (2011)
Antiplane shear mode stress intensity factor for a slightly perturbed circular crack subject to shear load
by: Nik Long, Nik Mohd Asri, et al.
Published: (2011)
by: Nik Long, Nik Mohd Asri, et al.
Published: (2011)
Mode stresses for the interaction between an inclined crack and curved crack in plane elasticity
by: Nik Long, Nik Mohd Asri, et al.
Published: (2014)
by: Nik Long, Nik Mohd Asri, et al.
Published: (2014)
Stress intensity factor for multiple cracks in half plane elasticity
by: Elfakhakhre, Nawara R. F., et al.
Published: (2016)
by: Elfakhakhre, Nawara R. F., et al.
Published: (2016)
Stress intensity factors of edge cracks in dissimilar joint plates
by: Nik Ismail, Nik Ainun
Published: (2014)
by: Nik Ismail, Nik Ainun
Published: (2014)
Stress Intensity factor for cracks problems in bonded dissimilar materials
by: Hamzah, Khairum, et al.
Published: (2020)
by: Hamzah, Khairum, et al.
Published: (2020)
Crack tip stress intensity factors for a crack emanating from a sharp notch
by: S., Karuppanan, et al.
Published: (2008)
by: S., Karuppanan, et al.
Published: (2008)
Plasma volume in normal and sickle cell pregnancy
by: Afolabi, Bosede
Published: (2011)
by: Afolabi, Bosede
Published: (2011)
Analysis Of Design Of An Intervention Oil Palm Sickle
by: Awang Mansor, Muhammad Adib Haikal
Published: (2022)
by: Awang Mansor, Muhammad Adib Haikal
Published: (2022)
The comparison of efficiency between conventional sickle and inertial sickle: case study at Felcra Bukit Sedanan Berhad / Muhammad Fadhli Ahmad
by: Ahmad, Muhammad Fadhli
Published: (2018)
by: Ahmad, Muhammad Fadhli
Published: (2018)
Stress intensity factors for a crack in bonded dissimilar materials subjected to various stresses
by: Hamzah, Khairum, et al.
Published: (2019)
by: Hamzah, Khairum, et al.
Published: (2019)
Stress intensity factor for the interaction between a straight crack and a curved crack in plane elasticity
by: Aridi, M. R., et al.
Published: (2016)
by: Aridi, M. R., et al.
Published: (2016)
Analysis of thermal stress intensity factors for edge cracked bimaterial system
by: Hrairi, Meftah, et al.
Published: (2012)
by: Hrairi, Meftah, et al.
Published: (2012)
Stress intensity factors for Thermoelectric Bonded Materials weakened by an inclined crack
by: Mohd Nordin, Muhammad Haziq Iqmal, et al.
Published: (2024)
by: Mohd Nordin, Muhammad Haziq Iqmal, et al.
Published: (2024)
Stress intensity factor for bonded dissimilar materials weakened by multiple cracks
by: Hamzah, K., et al.
Published: (2020)
by: Hamzah, K., et al.
Published: (2020)
Gene therapy in treating sickle cell anemia disease
by: Dol Ramli, Nur Amira, et al.
Published: (2022)
by: Dol Ramli, Nur Amira, et al.
Published: (2022)
Gene therapy in treating sickle cell anemia disease
by: Dol Ramli, Nur Amira, et al.
Published: (2022)
by: Dol Ramli, Nur Amira, et al.
Published: (2022)
A new empirical model to predict stress intensity factor for double interacting surface cracks located in hollow cylinder
by: Fakhri, Omar Mohammed
Published: (2021)
by: Fakhri, Omar Mohammed
Published: (2021)
Derivation of stress intensity factor for a cracked plate with an integrated piezoelectric actuator
by: Abuzaid, Ahmed, et al.
Published: (2014)
by: Abuzaid, Ahmed, et al.
Published: (2014)
Stress intensity factor for an elastic half plane weakend by multiple curved cracks
by: Elfakhakhre, Nawara Rajab Fathullah, et al.
Published: (2018)
by: Elfakhakhre, Nawara Rajab Fathullah, et al.
Published: (2018)
Stress intensity factor for a thermally insulated crack in bonded dissimilar materials
by: Hamzah, K. B., et al.
Published: (2019)
by: Hamzah, K. B., et al.
Published: (2019)
Mode stresses for the interaction between straight and curved cracks problem in plane elasticity
by: Aridi, Mohd Radzi, et al.
Published: (2014)
by: Aridi, Mohd Radzi, et al.
Published: (2014)
An analysis of TCP Port 0 traffic and net BIOS SMB spam advertisement incidents within a set of honeypots / Emran Mohd Tamil and Abdul Hamid Othman
by: Mohd Tamil, Emran, et al.
Published: (2006)
by: Mohd Tamil, Emran, et al.
Published: (2006)
Stress intensity factor for a crack within a strip under
arbitrary loading
by: Karuppanan, S, et al.
Published: (2007)
by: Karuppanan, S, et al.
Published: (2007)
Similar Items
-
Stress intensity factors for surface cracks in round bar under single and combined loadings
by: Ismail, Al Emran, et al.
Published: (2012) -
Finite element analysis of j-integral for surface cracks in round bars under combined mode i loading
by: Ismail, Al Emran, et al.
Published: (2017) -
Crack behavior of heat treated sintered steel under cyclic loading / Al Emran Ismail
by: Ismail, Al Emran
Published: (2003) -
Mode i stress intensity factors of slanted cracks
by: Ismail, Al Emran, et al.
Published: (2017) -
Fatigue crack initiation in powder metallurgically-processed tool steel material under cyclic loading / Al Emran Ismail and Mohd Nor Berhan
by: Ismail, Al Emran, et al.
Published: (2006)