Experimental investigation on the engine performance and emission behaviour of turpentine - diesel dual fuel operated modified DI diesel engine / R. Karthikeyan … [et al.]
The dual fuel technique offers the advantage of easy conversion of the diesel engine to work on the dual fuel mode with little engine modifications. In this mode, the primary fuel (turpentine) is inducted along with inlet air stream and the pilot fuel (diesel) is injected through the regular injecti...
| Main Authors: | Karthikeyan, R., Nallusamy, N., Alagumoorthi, N., Ilangovan, V. |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
UiTM Press
2011
|
| Subjects: | |
| Online Access: | https://ir.uitm.edu.my/id/eprint/13827/ |
Similar Items
Analysis of overhead valve push rod type valve train for off road diesel engine / Santosh A. Rane and Vilas Kalamkar
by: A Rane, Santosh, et al.
Published: (2010)
by: A Rane, Santosh, et al.
Published: (2010)
Analysis on the factors and effects of engine tapping noise by Design of Experiment (DOE) / Mohd Shahrudin Mohd Alias … [et al.]
by: Mohd Alias, Mohd Shahrudin, et al.
Published: (2015)
by: Mohd Alias, Mohd Shahrudin, et al.
Published: (2015)
The effect of EFI to the carbureted single cylinder four stroke engine / Idris Ibrahim, Adibah Abdul Jalil and Shaharin A. Sulaiman
by: Ibrahim, Idris, et al.
Published: (2010)
by: Ibrahim, Idris, et al.
Published: (2010)
Development of fuel additives to enhance the performances of four-cylinder spark-ignition engine / Mohd Khaizalfitri Mhd Yaakob, Mohd Azahar Mohd Ariff, Mahamad Hisyam Mahamad Basri, Sharzali Che Mat and Azmi Husin
by: Mohd Ariff, Mohd Azahar, et al.
Published: (2013)
by: Mohd Ariff, Mohd Azahar, et al.
Published: (2013)
The study about gasoline direct injection / Ismail Mesror, Fauzan Manan and Nasrul Rahman Ahmad
by: Mesror, Ismail, et al.
Published: (2002)
by: Mesror, Ismail, et al.
Published: (2002)
Comparision on dynamic behavior of diesel spray and rapeseed oil spray in diesel engine
by: Sapit, Azwan, et al.
Published: (2017)
by: Sapit, Azwan, et al.
Published: (2017)
Experimentally validated analytical modeling of diesel engine power and in-cylinder gas speed dynamics
by: Elmoselhy, Salah A M, et al.
Published: (2016)
by: Elmoselhy, Salah A M, et al.
Published: (2016)
Energy consumption and emissions of diesel-CNG dual fuel engine at high load operation
by: Ismail, Muammar Mukhsin, et al.
Published: (2020)
by: Ismail, Muammar Mukhsin, et al.
Published: (2020)
Comparison of diesel emission experiments in view of
the environment: a case study at Dubai
by: Al Ali, Yousif, et al.
Published: (2012)
by: Al Ali, Yousif, et al.
Published: (2012)
Effects of fuel ratio on performance and emission of diesel-compressed natural gas (CNG) dual fuel engine
by: Ismail, M. M., et al.
Published: (2018)
by: Ismail, M. M., et al.
Published: (2018)
Automatic whiteboard cleaner/ Muhammad Idham Abd Aziz ...[et al.]
by: Abd Aziz, Muhammad Idham, et al.
Published: (2018)
by: Abd Aziz, Muhammad Idham, et al.
Published: (2018)
Performance analysis of open cathode air-cooled fuel cell using HY-EXPERT instructor fuel cell system / Khairul Syazwan Mansor
by: Mansor, Khairul Syazwan
Published: (2010)
by: Mansor, Khairul Syazwan
Published: (2010)
The effect of nozzle diameter, injection pressure and ambient temperature on spray characteristics in diesel engine
by: Andsaler, Adiba Rhaodah, et al.
Published: (2017)
by: Andsaler, Adiba Rhaodah, et al.
Published: (2017)
Wear analysis of piston ring / Muhammad Ridzuwan Tukimin, Zaidi Hafizi Zakaria and Nazli Mahmood
by: Tukimin, Muhammad Ridzuwan, et al.
Published: (2011)
by: Tukimin, Muhammad Ridzuwan, et al.
Published: (2011)
Smart grass cutter/ Muhammad Hifzhan Ruslan, Muhammad Ammar Maznan and Yusri Aizat Mohd Yasir Afkam
by: Ruslan, Muhammad Hifzhan, et al.
Published: (2018)
by: Ruslan, Muhammad Hifzhan, et al.
Published: (2018)
Effect of gas flow rate during Metal Inert Gas (MIG) welding on tensile strength / Ahmad Safri Mohammed Salleh
by: Mohammed Salleh, Ahmad Safri
Published: (2005)
by: Mohammed Salleh, Ahmad Safri
Published: (2005)
Performance and emissions of compression ignition engine fueled with preheated blend of vegetable oil
by: Suffian, Mohamad Mokhsen
Published: (2014)
by: Suffian, Mohamad Mokhsen
Published: (2014)
The theory of the development of an electromagnetic engine for automotive use
by: Rahman, Mohammed Ataur, et al.
Published: (2017)
by: Rahman, Mohammed Ataur, et al.
Published: (2017)
Optimization of injection moulding parameters using Cadmould simulation software for Cover Fog Lamp / Mohammad Marzuki Ashari
by: Ashari, Mohammad Marzuki
Published: (2008)
by: Ashari, Mohammad Marzuki
Published: (2008)
Effect of performance and exhaust emission using liquid phase LPG sequential injection as an alternative fuel in spark ignition engine
by: Tukiman, Mohd Mustaqim, et al.
Published: (2018)
by: Tukiman, Mohd Mustaqim, et al.
Published: (2018)
Experimental investigation on the performance of single
spark ignition and twin spark ignition engine fuelled with
ethanol-gasoline blends
by: Prashant, Jagadesh, et al.
Published: (2020)
by: Prashant, Jagadesh, et al.
Published: (2020)
Prediction on Power Produced from Power Turbine as
a Waste Heat Recovery Mechanism on Naturally Aspirated Spark
Ignition Engine Using Artificial Neural Network
by: Herawan, Safarudin Gazali, et al.
Published: (2016)
by: Herawan, Safarudin Gazali, et al.
Published: (2016)
Study the performance of the four-stroke, four-cylinder petrol engine in the thermodynamic laboratory / Sariman Samuri
by: Samuri, Sariman
Published: (1985)
by: Samuri, Sariman
Published: (1985)
Design and development of embedded system to control motorized CNG-air mixer for diesel dual-fuel engine
by: Al-Saadi, Abdulwahab A. Abdulrahman
Published: (2018)
by: Al-Saadi, Abdulwahab A. Abdulrahman
Published: (2018)
Potential for improving vehicle fuel efficiency and reducing
the environmental pollution via fuel ionization
by: Al Ali, Yousif, et al.
Published: (2012)
by: Al Ali, Yousif, et al.
Published: (2012)
Numerical study of variable length exhaust pipe in small engine
by: Mohammed, Akmal Nizam, et al.
Published: (2017)
by: Mohammed, Akmal Nizam, et al.
Published: (2017)
Combustion characteristics of a spark ignition engine operating with liquid lpg injection
by: Mustaffa, Norrizal
Published: (2019)
by: Mustaffa, Norrizal
Published: (2019)
The study of the effect of intake valve timing on engine using cylinder deactivation technique via simulation
by: Zainal Abidin, S. F., et al.
Published: (2015)
by: Zainal Abidin, S. F., et al.
Published: (2015)
Experimental investigation on the feasibility and durability of a novel diesel particulate filter
by: Mohd Muhsein Taib, Mohd Muhsein
Published: (2012)
by: Mohd Muhsein Taib, Mohd Muhsein
Published: (2012)
Product development using CNC lathe machine / Royhaila Drahman, Nazifah Muti and Zaiton Jahaya
by: Drahman, Royhaila, et al.
Published: (1990)
by: Drahman, Royhaila, et al.
Published: (1990)
A study of tribological aspects in gearbox of CNG engine / Abdul Hakim Ahmad
by: Ahmad, Abdul Hakim
Published: (2010)
by: Ahmad, Abdul Hakim
Published: (2010)
Analysis of a high pressure diesel spray at high pressure and temperature environment conditions
by: Kidoguchi, Yoshiyuki, et al.
Published: (2013)
by: Kidoguchi, Yoshiyuki, et al.
Published: (2013)
Investigation on the prominence of abrupt expansion on the base pressure of an axi-symmetric body
by: Bashir, Musavir, et al.
Published: (2017)
by: Bashir, Musavir, et al.
Published: (2017)
Investigation of the effects of nozzle exit mach number and nozzle pressure ratio on axisymmetric flow through suddenly expanded nozzles
by: Khan, Sher Afghan, et al.
Published: (2019)
by: Khan, Sher Afghan, et al.
Published: (2019)
The hybrid car with waste gas recovery
by: Mohiuddin, A. K. M.
Published: (2012)
by: Mohiuddin, A. K. M.
Published: (2012)
Effect of ambient temperature on ignition delay, combustion process and emission of biodiesel derived from algae
by: Khalid, Amir, et al.
Published: (2018)
by: Khalid, Amir, et al.
Published: (2018)
New intelligent in-series DC motor controller / Abu Zaharin Ahmad
by: Ahmad, Abu Zaharin
Published: (2006)
by: Ahmad, Abu Zaharin
Published: (2006)
Towards keeping diesel fuel supply and demand in balance: dual-fuelling of diesel engines with natural gas
by: Hegab, Abdelrahman, et al.
Published: (2016)
by: Hegab, Abdelrahman, et al.
Published: (2016)
Pembangunan e-modul pembelajaran enjin diesel untuk kursus teknologi automotif
by: Mohamad, Marlina, et al.
Published: (2016)
by: Mohamad, Marlina, et al.
Published: (2016)
Process system engineering in biodiesel production: a review
by: Nasir, N.F., et al.
Published: (2013)
by: Nasir, N.F., et al.
Published: (2013)
Similar Items
-
Analysis of overhead valve push rod type valve train for off road diesel engine / Santosh A. Rane and Vilas Kalamkar
by: A Rane, Santosh, et al.
Published: (2010) -
Analysis on the factors and effects of engine tapping noise by Design of Experiment (DOE) / Mohd Shahrudin Mohd Alias … [et al.]
by: Mohd Alias, Mohd Shahrudin, et al.
Published: (2015) -
The effect of EFI to the carbureted single cylinder four stroke engine / Idris Ibrahim, Adibah Abdul Jalil and Shaharin A. Sulaiman
by: Ibrahim, Idris, et al.
Published: (2010) -
Development of fuel additives to enhance the performances of four-cylinder spark-ignition engine / Mohd Khaizalfitri Mhd Yaakob, Mohd Azahar Mohd Ariff, Mahamad Hisyam Mahamad Basri, Sharzali Che Mat and Azmi Husin
by: Mohd Ariff, Mohd Azahar, et al.
Published: (2013) -
The study about gasoline direct injection / Ismail Mesror, Fauzan Manan and Nasrul Rahman Ahmad
by: Mesror, Ismail, et al.
Published: (2002)