A proposed resistance-to-time converter with switching impulse calibrators for resistive bridge sensors

QR Code

A proposed resistance-to-time converter with switching impulse calibrators for resistive bridge sensors

This paper presents a simple resistance-to-time converter. It consists of two voltage comparators, a ramp voltage generator, two logic gates and impulse voltage calibrators. A square-wave generator circuit is suggested in this paper. The design is simple and independent of the OPAMP offset issue...

Full description

Bibliographic Details
Main Authors:	Mohammad, Zahangir Alam, Khan, Sheroz, Adam, Ismail, Kadir, Kushairy, Nordin, Anis Nurashikin, Ibrahim, Siti Noorjannah
Format:	Proceeding Paper
Language:	English English
Published:	Institute of Electrical and Electronics Engineers Inc. 2018
Subjects:	TK Electrical engineering. Electronics Nuclear engineering TK7800 Electronics. Computer engineering. Computer hardware. Photoelectronic devices
Online Access:	http://irep.iium.edu.my/72880/ http://irep.iium.edu.my/72880/1/72880_4th%20IEEE%20International%20Conference%20on%20Smart%20Instrumentation_complete_new.pdf http://irep.iium.edu.my/72880/2/72880_4th%20IEEE%20International%20Conference%20on%20Smart%20Instrumentation_scopus.pdf

Similar Items

A proposed resistance-to-time converter with switching impulse calibrators for application in resistive bridge sensors
by: Mohammad, Zahangir Alam, et al.
Published: (2018)

The principle of resistive sensing
by: Arshad, Atika, et al.
Published: (2011)

Design of differential resistive measuring system and its applications
by: Abdul Wahab, Deji, et al.
Published: (2011)

Wide range modulation indexes featuring carrier-based PWM stepped waveform for half-bridge modular multilevel converters
by: Tohtayong, Majdee, et al.
Published: (2018)

Input-series output-parallel full-bridge DC-DC converter for high power applications
by: Daoud, Guerras, et al.
Published: (2018)

Design and optimization of alLow-voltage shunt capacitive RF-MEMS switch
by: Ma, Li Ya, et al.
Published: (2014)

Design and analysis of a low-voltage electrostatic actuated RF CMOS-MEMS switch
by: Ma, Li Ya, et al.
Published: (2013)

Design, optimization and simulation of a low‑voltage shunt capacitive RF‑MEMS switch
by: Ma, Li Ya, et al.
Published: (2015)

Theoretical and simulated investigation of dielectric charging effect on a capacitive RF-MEMS switch
by: Ma, Li Ya, et al.
Published: (2016)

Design and simulation of RF-CMOS SPST switch for reconfigurable RF front-end
by: Soeroso, Iksannurazmi Bambang, et al.
Published: (2014)

A novel design of low-voltage low-loss K-band RF-MEMS capacitive switch
by: Ma, Li-Ya, et al.
Published: (2018)

Tunable bandpass filter using RF MEMS switches
by: Alam, A. H. M. Zahirul, et al.
Published: (2009)

Piece-wise linear analog to digital (PLADC) converter process
by: Salami, Abdulazeez F., et al.
Published: (2011)

DC-DC boost converter for grid-tied renewable energy generation systems
by: Shahid, Zeeshan, et al.
Published: (2014)

Harmonics elimination based on curve fitting method for modular multilevel converters
by: Tohtayong, Majdee, et al.
Published: (2017)

Experimental verification and simulation of two stages positive output cascade boost converter super-lift DC/DC Luo-converter
by: Hammoda, Ahmed, et al.
Published: (2018)

A novel design of a low-voltage low-loss T-match RF-MEMS capacitive switch
by: Ma, Li Ya, et al.
Published: (2018)

Induced current distribution in 3D soil model as lightning impulse discharge strike earth surface
by: Fajingbesi, Fawwaz Eniola, et al.
Published: (2020)

A novel multilevel DC - AC converter from green energy power generators using step-square waving and PWM technique
by: Fajingbesi, Fawwaz Eniola, et al.
Published: (2017)

Crosstalk freeness of concatenated modified plus-minus 2i photonic switching network
by: Rahman, M.M. Hafizur, et al.
Published: (2014)

Inductive & capacitive wireless power transfer system
by: Mazli, Mohamad Syafiq, et al.
Published: (2018)

Design and simulation of 10 MHz MEMS oscillator
by: Taufik, Mohamad Syamsi, et al.
Published: (2014)

Acquisition of a very low voltage and a low frequency biomedical signal- frequency selective filter design
by: Shobaki, Mohammed M., et al.
Published: (2014)

Design and simulation of 20MHz oscillator using CMOS-MEMS beam resonators
by: Zainuddin, Ahmad Anwar, et al.
Published: (2013)

Modeling and development of radio frequency planar interdigital electrode sensors
by: Yunos, Muhammad Farhan Affendi, et al.
Published: (2019)

Sensor and sensor response-issues and interfacing
by: Ahmmad, Syed Masrur, et al.
Published: (2011)

The proposal of partial sharing for link-sharing method of buffer in NoC router
by: Fukase, Naohisa, et al.
Published: (2014)

Design of two-stage CMOS amplifier for quartz crystal resonator
by: Mohd Taufik, Muhammad Syamsi, et al.
Published: (2013)

A concatenated modified plus-minus 2^i (CMPM2I) photonic switching network
by: Rahman, M.M. Hafizur, et al.
Published: (2012)

Inductive loops for sensing position as signature signals
by: Larbani, Sofiane, et al.
Published: (2013)

Design and simulation of Clamped-Clamped and Clamped-Free resonators
by: Zainuddin, Ahmad Anwar, et al.
Published: (2013)

An estimation of the coupling coefficient of the series inductive resonant wireless power transfer coils
by: Adam, Ismail, et al.
Published: (2020)

RF CMOS-MEMS cantilever resonator
by: Zainuddin, Ahmad Anwar, et al.
Published: (2013)

Optical-resonator-based biosensing systems: current status and future prospects
by: Nordin, Anis Nurashikin
Published: (2016)

Posture characterization based on time and frequency domains parameters for erector spine SEMG signal
by: Shobaki, Mohammed M., et al.
Published: (2014)

The load reliant power transfer of the series-to-series inductive resonant wireless power transfer
by: Adam, Ismail, et al.
Published: (2020)

Implementation of CMOS oscillator for CMOS SAW resonator
by: Karim, Jamilah, et al.
Published: (2016)

High quality acquisition of surface electromyography – conditioning circuit design
by: Shobaki, Mohammed M., et al.
Published: (2013)

Simulation of RF patch antenna sensor for biological applications
by: Yunos, Muhammad Farhan Affendi, et al.
Published: (2018)

Performance improvement of sensors response using piece-wise non-linear (PWL) A/D and pulse-width modulation (PWM) A/D techniques
by: Tijani, Ismaila, et al.
Published: (2011)