Visual-based fingertip detection for hand rehabilitation

QR Code

Visual-based fingertip detection for hand rehabilitation

This paper presents a visual detection of fingertips by using a classification technique based on the bag-of-words method. In this work, the fingertips are specifically of people who are holding a therapy ball, as it is intended to be used in a hand rehabilitation project. Speeded Up Robust Features...

Full description

Bibliographic Details
Main Authors:	Awang Za’aba, Dayang Qurratu’aini, Sophian, Ali, Sediono, Wahju, Md. Yusof, Hazlina, Sudirman, Sud
Format:	Article
Language:	English English
Published:	Institute of Advanced Engineering and Science (IAES) 2018
Subjects:	T Technology (General) TJ210.2 Mechanical devices and figures. Automata. Ingenious mechanism. Robots (General)
Online Access:	http://irep.iium.edu.my/61384/ http://irep.iium.edu.my/61384/11/61384-Visual-based%20fingertip%20detection%20for%20hand%20rehabilitation-SCOPUS.pdf http://irep.iium.edu.my/61384/17/61384_Visual-based%20fingertip%20detection%20for%20hand%20rehabilitation.pdf

Similar Items

Lower-limb rehabilitation robot design
by: Bouhabba, El Mehdi, et al.
Published: (2013)

Robotic exoskeleton for rehabilitation and motion assist
by: Rahman, Md. Mozasser, et al.
Published: (2006)

Gripping motion of artificial hand using EMG signal
by: Mat Rosly, Muhammad Hadi, et al.
Published: (2016)

Mathematical modeling and trajectory planning of hand finger movements
by: Rahman, Md. Mozasser, et al.
Published: (2014)

Assist-as-needed control strategy for upper-limb rehabilitation based on subject’s functional ability
by: Ahmed Mounis, Shawgi Younis, et al.
Published: (2019)

Markerless detection of fingertips of object-manipulating hand
by: Sophian, Ali, et al.
Published: (2016)

An overview of active compliance control for a robotic hand
by: Sadun, Amirul Syafiq, et al.
Published: (2016)

Adaptive control for one-DOF finger rehabilitation robot
by: Jainal Abidin, Nurul Aqilah
Published: (2019)

Development and evaluation of a spot sensor glove for the tactile prosthetic hand
by: Nemah, Mohammed Najeh, et al.
Published: (2018)

Smart tendon actuated flexible actuator
by: Billah, Md. Masum, et al.
Published: (2015)

Investigation on data extraction trends for snake robot
by: Khan, Md. Raisuddin, et al.
Published: (2014)

Mobility determination and estimation based on smartphones-review of sensing and system
by: Aljeroudi, Yazan, et al.
Published: (2015)

CPG-based control system for flexible snake robot locomotion
by: Khan, Md. Raisuddin, et al.
Published: (2014)

Development and initial testing of an autonomous surface vehicle for shallow water mapping
by: Mat Idris, Mohamad Hilmi, et al.
Published: (2015)

Multiplexing of unformatted asynchronous serial data to a single NMEA 0183 protocol compliance data-stream for autonomous surface vehicles data logging
by: Mat Idris, Mohamad Hilmi, et al.
Published: (2015)

Dynamics and control of quadcopter using linear model predictive control approach
by: Islam, M, et al.
Published: (2017)

Impedance based detection of delamination in composite structures
by: Djemana, Mohamed, et al.
Published: (2017)

Accelerated learning programme for robotic competition
by: Othman, Azam, et al.
Published: (2017)

Thermal performance of fined plate mini-channel heat sink
by: Mohamed Ali, Suliman Mohamed, et al.
Published: (2016)

Human-friendly robot and bio-inspired robot: new challenge in robotics
by: Rahman, Md. Mozasser
Published: (2016)

Optimization of CO2 production rate for firefighting robot applications using response surface methodology
by: Ajala, M. T., et al.
Published: (2018)

Dynamic tuning of torsional transmissibility using magnetorheological elastomer: Modelling and experimental verification
by: Hashi, Hamza, et al.
Published: (2016)

Investigating negative capacitance shunt circuit for broadband vibration damping and utilizing ACO for optimization
by: Wahid, Azni Nabela, et al.
Published: (2016)

Internet based troubleshooting and monitoring system of industrial robots
by: Rahman, Md Mozasser, et al.
Published: (2017)

Introduction to robotic design: theory, hardware and programming
by: Rahman, Md. Mozasser
Published: (2017)

Upper-limb impedance parameters-based model for motor recovery
by: Htoon, Zaw Lay, et al.
Published: (2017)

Numerical investigation of non-dimensional constant and empirical relation representing Nusselt profile non-uniformity
by: Mohd, Umair Siddiqui, et al.
Published: (2020)

Assessing the effect of persuasive robots interactive social cues on users’ psychological reactance, liking, trusting beliefs and compliance
by: Ghazali, Aimi Shazwani, et al.
Published: (2019)

PID and inverse-model-based control of a twin rotor system
by: Toha, Siti Fauziah, et al.
Published: (2011)

Visual tracking and servoing of human face for robotic head Amir-II
by: Shafie, Amir Akramin, et al.
Published: (2010)

Graphical user interface for Humanoid Head Amir-II
by: Shafie, Amir Akramin, et al.
Published: (2010)

Development of a flexible video analysis system for motion detection and alarm generation
by: Shafie, Amir Akramin, et al.
Published: (2010)

Foreground segmentation-based human detection with shadow removal
by: Hafiz, Fadhlan, et al.
Published: (2010)

Advance video analysis system and its applications
by: Ali, Md. Hazrat, et al.
Published: (2010)

Kinematics model of snake robot considering snake scale
by: Khan, Md. Raisuddin, et al.
Published: (2010)

A collaborative navigation algorithm for multi-agent robots in autonomous reconnaissance mission
by: Ahmed, Mohiuddin, et al.
Published: (2010)

Development of an efficient CVT using electromechanical system
by: Shafie, Amir Akramin, et al.
Published: (2009)

Development and performance evaluation of an ultra precision ELID grinding machine
by: Saleh, Tanveer, et al.
Published: (2007)

Development of an on-machine profile measurement system in ELID grinding for machining aspheric surface with software compensation
by: Sazedur Rahman, M., et al.
Published: (2008)

A multiprocess machine tool for compound micromachining
by: Rahman, M., et al.
Published: (2010)