RF parameters characterization of a flexible Cu-PDMS-Cu patch antenna

QR Code

RF parameters characterization of a flexible Cu-PDMS-Cu patch antenna

This paper presents a newly developed flexible Polydimethylsiloxane (PDMS)-Copper (CU) patch antenna. The circular-shaped antenna consists of a 21.28mm radial size Cu patch embedded on a PDMS square substrate. PDMS has a low loss tangent of 0.004 and a relative permittivity of 2.74 that will enhance...

Full description

Bibliographic Details
Main Authors:	Mohd Ramly, Athirah, Abdul Malek, Norun, Ibrahim, Siti Noorjannah, Zainuddin, Ahmad Anwar
Format:	Article
Language:	English English
Published:	Praise Worthy Prize 2017
Subjects:	TK5101 Telecommunication. Including telegraphy, radio, radar, television TK7800 Electronics. Computer engineering. Computer hardware. Photoelectronic devices
Online Access:	http://irep.iium.edu.my/59785/ http://irep.iium.edu.my/59785/7/59785-RF%20Parameters%20Characterization%20of%20a%20Flexible.pdf http://irep.iium.edu.my/59785/8/59785-RF%20parameters%20characterization%20of%20a%20flexible%20Cu-PDMS-Cu%20patch%20antenna_SCOPUS.pdf

Similar Items

Simulation of RF patch antenna sensor for biological applications
by: Yunos, Muhammad Farhan Affendi, et al.
Published: (2018)

RF CMOS-MEMS cantilever resonator
by: Zainuddin, Ahmad Anwar, et al.
Published: (2013)

Design and simulation of RF-CMOS SPST switch for reconfigurable RF front-end
by: Soeroso, Iksannurazmi Bambang, et al.
Published: (2014)

Rapid fabrication and characterization of PDMS microfluidics device using printed conductive silver ink
by: A. Aziz, Azman, et al.
Published: (2019)

Tunable bandpass filter using RF MEMS switches
by: Alam, A. H. M. Zahirul, et al.
Published: (2009)

Compact multiband microstrip patch antenna with slot-rings for wireless applications
by: Nataraj, Chandrasekharan, et al.
Published: (2018)

Design and optimization of alLow-voltage shunt capacitive RF-MEMS switch
by: Ma, Li Ya, et al.
Published: (2014)

Design and analysis of a low-voltage electrostatic actuated RF CMOS-MEMS switch
by: Ma, Li Ya, et al.
Published: (2013)

Design, optimization and simulation of a low‑voltage shunt capacitive RF‑MEMS switch
by: Ma, Li Ya, et al.
Published: (2015)

Theoretical and simulated investigation of dielectric charging effect on a capacitive RF-MEMS switch
by: Ma, Li Ya, et al.
Published: (2016)

Beam steering of four dipoles antenna array using genetic algorithm
by: Abdul Malek, Norun, et al.
Published: (2014)

A novel design of low-voltage low-loss K-band RF-MEMS capacitive switch
by: Ma, Li-Ya, et al.
Published: (2018)

Cognitive radio vs intelligent antenna
by: Mat Nawi, Siti Rabani, et al.
Published: (2011)

Dependence of preferred c-axis orientation on RF magnetron sputtering power for AZO/Si acoustic wave devices
by: Md Ralib @ Md Raghib, Aliza 'Aini, et al.
Published: (2015)

An analysis of a flexible dry surface electrodes
by: Azman, Amelia Wong, et al.
Published: (2018)

2.45 Ghz passive RFID tag antenna mounting on various platforms
by: Yussuf, Abubeker A., et al.
Published: (2011)

High gain UWB horn antenna for concealed metal detection and microwave imaging application
by: Shaikh, Faraz Ahmed, et al.
Published: (2017)

Design and optimization of ultra-wideband antipodal vivaldi antenna for radar and microwave imaging application
by: Shaikh, Faraz Ahmed, et al.
Published: (2018)

Optimum concentric circular array antenna with high gain and side lobe reduction at 5.8 GHz
by: Zaid, Mohammed, et al.
Published: (2017)

Design an ultra-wideband modified wilkinson power divider fed-by balanced antipodal vivaldi antenna array for imaging applications
by: Shaikh, Faraz Ahmed, et al.
Published: (2020)

Design of a circular patch antenna for 3D printing
by: Mohd Ramly, Athirah, et al.
Published: (2016)

Design and simulation of 10 MHz MEMS oscillator
by: Taufik, Mohamad Syamsi, et al.
Published: (2014)

Design and simulation of 20MHz oscillator using CMOS-MEMS beam resonators
by: Zainuddin, Ahmad Anwar, et al.
Published: (2013)

Modeling and development of radio frequency planar interdigital electrode sensors
by: Yunos, Muhammad Farhan Affendi, et al.
Published: (2019)

Design of two-stage CMOS amplifier for quartz crystal resonator
by: Mohd Taufik, Muhammad Syamsi, et al.
Published: (2013)

Design and simulation of Clamped-Clamped and Clamped-Free resonators
by: Zainuddin, Ahmad Anwar, et al.
Published: (2013)

Design and simulation of two-stage CMOS amplifier for MEMS resonator
by: Mohd Taufik, Muhammad Syamsi, et al.
Published: (2013)

Multi-frequency CMOS oscillator based on CMOS MEMS SAW resonator
by: Karim, Jamilah, et al.
Published: (2015)

Optimization of printing techniques for electrochemical biosensors
by: Zainuddin, Ahmad Anwar, et al.
Published: (2017)

Basic study of OFDM with multipath propagation model in GNU Platform
by: Muslimin, Jusnaini, et al.
Published: (2016)

Smart antenna design based on direction of arrival (DOA) and beamforming optimization
by: Islam, Md. Rafiqul, et al.
Published: (2010)

Enhanced multicast routing protocol for wireless mesh networks (WMN)
by: Anwar, Farhat
Published: (2011)

Performance evaluation of selected DHT P2p routing protocols
by: Anwar, Farhat
Published: (2011)

Enhanced sigma protocol for high speed mobile node in IP based communication system
by: Anwar, Farhat
Published: (2011)

Design and analysis of 1-to-4 Wilkinson power divider for antenna array feeding network
by: Shaikh, Faraz Ahmed, et al.
Published: (2018)

Path selection protocols for IEEE 802.11s wlan mesh networks
by: Bari, S. M. Sadakatil, et al.
Published: (2011)

Deployment challenges of MIPV6
by: Masud, Mosharrof Hussain, et al.
Published: (2011)

Analysis of handoff latency factors for MIPV6 network
by: Masud, Masharrof Hussain, et al.
Published: (2011)

Piezoelectric characteristics of CMOS compatible AIN SAW resonators
by: Md Ralib @ Md Raghib, Aliza 'Aini, et al.
Published: (2014)

Design and dimensional analysis of interdigital sensor for blood glucose measurement through non-invasive method
by: Zaharudin, Zarimin, et al.
Published: (2020)