Biodiesel production from crude jatropha oil using a highly active heterogeneous nanocatalyst by optimizing transesterification reaction parameters

QR Code

Biodiesel production from crude jatropha oil using a highly active heterogeneous nanocatalyst by optimizing transesterification reaction parameters

Various heterogeneous catalysts are often used to produce biodiesel from non-edible crude oils. In this study a highly active heterogeneous calcium oxide (CaO) nanocatalyst with a diameter and surface area of 66 ± 3 nm and 90.61 m2/g, respectively, was synthesized from Polymedosa erosa (P. erosa) s...

Full description

Bibliographic Details
Main Authors:	ANR, Reddy, Saleh, A. A., Islam, Md. Saiful, Hamdan, S., Maleque, Md. Abdul
Format:	Article
Language:	English English
Published:	American Chemical Society (ACS) Publications 2016
Subjects:	TJ163.26 Energy conservation TJ807 Renewable energy sources TP200 Manufacture and use of chemicals TP315 Fuel
Online Access:	http://irep.iium.edu.my/49707/ http://irep.iium.edu.my/49707/1/P107_2015_ACS_Saleh.pdf http://irep.iium.edu.my/49707/4/49707_Biodiesel%20Production_wos_scopus.pdf

Similar Items

Development and performance testing of a light weight portable solar rice cooker in rural areas of Bangladesh
by: Ahamed, R., et al.
Published: (2014)

A solar assisted heat pump system for desalination
by: Amin, Zakaria Mohd., et al.
Published: (2011)

Cooling of motorcyclist helmet with thermoelectric module
by: Hrairi, Meftah, et al.
Published: (2013)

A review study on the effect of glass envelope, working fluid and geometry contributions for the receiver on performance of parabolic trough collector (PTC)
by: Abbas, Mohammed Saad, et al.
Published: (2018)

Effect of periodic drying on energy utilization, product quality, and drying time
by: Baradey, Yehya, et al.
Published: (2017)

Magnetically plucked piezoelectric energy harvester via hybrid kinetic motion
by: Azam, Huda, et al.
Published: (2019)

Analysis of solar desalination system using heat pump
by: Amin, Zakaria Mohd., et al.
Published: (2015)

Feasibility of double-layer microchannel fabrication at low speed micro end-mill and wire-cut EDM machines
by: Ahmed, Mirghani Ishag, et al.
Published: (2014)

Numerical investigation of flow boiling in double-layer microchannel heat sink
by: Ahmed, Shugata, et al.
Published: (2014)

Numerical analysis of heat transfer and nanofluid flow in a triangular duct with vortex generator: two-phase model
by: Ahmed, Mirghani Ishag, et al.
Published: (2014)

A triangular double layer microchannel heat sink: effect of parallel and counter flow
by: Manaf, Hazli, et al.
Published: (2014)

Waste heat recovery in heat pump systems: solution to reduce global warming
by: Baradey, Yehya, et al.
Published: (2015)

Active control of suddenly expanded flow
by: Khan, Sher Afghan, et al.
Published: (2000)

Feasibility of double-layer microchannel fabrication at low speed micro end-mill and wire-cut EDM machines
by: Seder, Islam M.F., et al.
Published: (2014)

Modelling and validation of proton exchange membrane fuel cell (PEMFC)
by: Mohiuddin, A. K. M., et al.
Published: (2018)

Performance analyses of horizontal axis wind turbines using QBlade
by: Zuhdi, Amirul Hakim, et al.
Published: (2017)

Investigation of aluminum heat sink design with thermoelectric generator
by: Mohiuddin, A. K. M., et al.
Published: (2017)

Validated analytical modeling of diesel engine regulated exhaust CO emission rate
by: Faris, Waleed Fekry, et al.
Published: (2016)

Comparative heat transfer analysis in different mini-channel heat sinks
by: Afzal, Asif, et al.
Published: (2017)

Energy harvesting from aerodynamic instabilities: Current prospect and future trends
by: Bashir, Musavir, et al.
Published: (2018)

Numerical investigation of semiempirical relations representing the local Nusselt number magnitude of a pin fin heat sink
by: Siddiqi, Mohammad Umar, et al.
Published: (2019)

On numerical investigation of semi-empirical relations representing local nusselt number at lower nozzle-target spacing’s
by: Siddique, Mohd Umair, et al.
Published: (2019)

Threaded spikes for bluff body base flow control
by: Khan, Sher Afghan, et al.
Published: (2019)

Hydrocarbons as alternative refrigerants in domestic refrigerators
by: S, Parashurama, et al.
Published: (2019)

Control of ideally expanded and under expanded nozzle flows with micro jets
by: G M, Fharukh Ahmed, et al.
Published: (2016)

Investigation on producing silica from rice husk biomass
by: Uddin, M.N., et al.
Published: (2018)

Thermo-mechanical analysis and estimation of turbine blade tip clearance of a small gas turbine engine under transient operating conditions
by: Kumar, Rahul, et al.
Published: (2020)

A desalination system utilizing solar ambient and waste energy
by: Hawlader, M N A, et al.
Published: (2011)

Transport analysis of an Air Gap Membrane Distillation (AGMD) process
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)

Optimization of cooling systems in data centre by computational fluid dynamics model and simulation
by: Romadhon, Rahmat, et al.
Published: (2009)

Reconstruction and electronic properties of interface between carbon nanotubes and ferromagnetic co electrodes
by: Cuong, Nguyen Tien, et al.
Published: (2012)

Optimization of a cooling system in data centers
by: Ali, Maisarah, et al.
Published: (2012)

An active cooling system for photovoltaic module
by: Teo, H. G., et al.
Published: (2012)

Combined water and power plant (CWPP) — a novel desalination technology
by: Mahbub, Fazle, et al.
Published: (2009)

PERFORMANCE OF A SOLAR INTEGRATED HEAT PUMP AIR-CONDITIONER, WATER HEATER AND DRYER
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2008)

Performance evaluation of a mechanical vapor compression desalination system
by: Bahar, Rubina, et al.
Published: (2004)

Economic evaluation of a solar water heating system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (1987)

Pretreatment of seawater: Results of pilot trials in Singapore
by: Chua, K T, et al.
Published: (2003)

Experimental investigation on the performance of the TiO2 and ZnO hybrid nanocoolant in ethylene glycol mixture towards AA6061-T6 machining
by: Sahid, N.S.M., et al.
Published: (2017)

3-D CFD transient simulation of transesterification in stirred tank reactor
by: Mohiuddin, A. K. M., et al.
Published: (2013)