Design and optimization of alLow-voltage shunt capacitive RF-MEMS switch

QR Code

Design and optimization of alLow-voltage shunt capacitive RF-MEMS switch

This paper presents the design, optimization and simulation of a radio frequency (RF) micro-electromechanical system (MEMS) switch. The device is a capacitive shunt- connection switch, which uses four folded beams to support a big membrane above the signal transmission line. Another four straight be...

Full description

Bibliographic Details
Main Authors:	Ma, Li Ya, Soin, Norhayati, Nordin, Anis Nurashikin
Format:	Proceeding Paper
Language:	English
Published:	2014
Subjects:	TK7800 Electronics. Computer engineering. Computer hardware. Photoelectronic devices
Online Access:	http://irep.iium.edu.my/46632/ http://irep.iium.edu.my/46632/1/C_-_2014_-_Design_and_Optimization_of_a_Low-Votlage_Shunt_Capacitive_RF-MEMS_Switch.pdf

Similar Items

Design, optimization and simulation of a low‑voltage shunt capacitive RF‑MEMS switch
by: Ma, Li Ya, et al.
Published: (2015)

A novel design of low-voltage low-loss K-band RF-MEMS capacitive switch
by: Ma, Li-Ya, et al.
Published: (2018)

Theoretical and simulated investigation of dielectric charging effect on a capacitive RF-MEMS switch
by: Ma, Li Ya, et al.
Published: (2016)

Design and analysis of a low-voltage electrostatic actuated RF CMOS-MEMS switch
by: Ma, Li Ya, et al.
Published: (2013)

A novel design of a low-voltage low-loss T-match RF-MEMS capacitive switch
by: Ma, Li Ya, et al.
Published: (2018)

Tunable bandpass filter using RF MEMS switches
by: Alam, A. H. M. Zahirul, et al.
Published: (2009)

RF CMOS-MEMS cantilever resonator
by: Zainuddin, Ahmad Anwar, et al.
Published: (2013)

Design and simulation of RF-CMOS SPST switch for reconfigurable RF front-end
by: Soeroso, Iksannurazmi Bambang, et al.
Published: (2014)

Low power and high voltage swing cascode Pierce oscillator for MEMS SAW resonators
by: Md Hamzah, Mohd Haidar, et al.
Published: (2016)

Simulation of MEMs piezoelectric energy harvester
by: Md Ralib, Aliza Aini, et al.
Published: (2010)

Design and simulation of 10 MHz MEMS oscillator
by: Taufik, Mohamad Syamsi, et al.
Published: (2014)

Novel low-voltage RF-MEMS switch: design and simulation
by: Ma, Li Ya, et al.
Published: (2014)

Design and simulation of two-stage CMOS amplifier for MEMS resonator
by: Mohd Taufik, Muhammad Syamsi, et al.
Published: (2013)

Capacitance-voltage characterization of commercial gallium nitride diodes subjected to electron radiation
by: Hedzir, Anati Syahirah, et al.
Published: (2016)

Design and simulation of 20MHz oscillator using CMOS-MEMS beam resonators
by: Zainuddin, Ahmad Anwar, et al.
Published: (2013)

Multi-frequency CMOS oscillator based on CMOS MEMS SAW resonator
by: Karim, Jamilah, et al.
Published: (2015)

Design and analysis of a boosted pierce oscillator using MEMS SAW resonators
by: Md Hamzah, Mohd Haidar, et al.
Published: (2018)

Comparative analysis of zinc oxide and aluminium doped ZnO for GHz CMOS MEMS surface acoustic wave resonator
by: Md Ralib @ Md Raghib, Aliza 'Aini, et al.
Published: (2013)

Piezoelectric thin films for double electrode CMOS MEMS surface acoustic wave (SAW) resonator
by: Md Ralib @ Md Raghib, Aliza 'Aini, et al.
Published: (2015)

Maximum allowable delay bound estimation using Lambert W function
by: Alfergani, Asma, et al.
Published: (2018)

Optimized RC timing technique for accurate measurement of minute capacitance changes
by: Zaharudin, Zarimin, et al.
Published: (2018)

Dependence of preferred c-axis orientation on RF magnetron sputtering power for AZO/Si acoustic wave devices
by: Md Ralib @ Md Raghib, Aliza 'Aini, et al.
Published: (2015)

A study on controllable aluminium doped zinc oxide patterning by chemical etching for MEMS application
by: Md Ralib @ Md Raghib, Aliza 'Aini, et al.
Published: (2017)

Capacitive electrode sensor: design and testing
by: Abdullahi, Salami Ifedapo, et al.
Published: (2018)

Inductive & capacitive wireless power transfer system
by: Mazli, Mohamad Syafiq, et al.
Published: (2018)

Capacitive sensing for non-contact means of measurement
by: Tasnim, Rumana, et al.
Published: (2011)

Acquisition of a very low voltage and a low frequency biomedical signal- frequency selective filter design
by: Shobaki, Mohammed M., et al.
Published: (2014)

Voltage supply and voltage regulation
by: Torla, Ahmad Lutfi, et al.
Published: (2011)

On the electrode arrangements of capacitive sensor for two phase Gas flow measurement
by: Tasnim, Rumana, et al.
Published: (2011)

A K-band switched-line phase shifter using novel low-voltage low-loss RF-MEMS switch
by: Ma, Li-Ya, et al.
Published: (2017)

Gm/ID approach for low power sustaining amplifier circuit for GHz range MEMS SAW oscillator
by: Kamarudin, Norlizawati, et al.
Published: (2019)

Study on capacitance performance of gallium nitride (GaN) diodes in high dose electron irradiation
by: Abdullah, Yusof, et al.
Published: (2019)

Optical-resonator-based biosensing systems: current status and future prospects
by: Nordin, Anis Nurashikin
Published: (2016)

Implementation of CMOS oscillator for CMOS SAW resonator
by: Karim, Jamilah, et al.
Published: (2016)

Design and optimization of a MEMS quartz mass sensor array for biosensing
by: Zainuddin, Ahmad Anwar, et al.
Published: (2018)

Simulation of RF patch antenna sensor for biological applications
by: Yunos, Muhammad Farhan Affendi, et al.
Published: (2018)

Full-wave rectification of a low-voltage source
by: Torla, Ahmad Lutfi, et al.
Published: (2011)

Channel length effect on the saturation current and the threshold voltages of CNTFET
by: Ani, Mohd Hanafi, et al.
Published: (2014)

Theoretical modelling of interdigitated electrode sensor for mammalian cell characterization
by: Mohd Mansor, Ahmad Fairuzabadi, et al.
Published: (2018)

Analysis of hybrid stepper motor performance under the influence of voltage supply interference
by: Salami, Abdulazeez F., et al.
Published: (2011)