Waste heat recovery in heat pump systems: solution to reduce global warming

QR Code

Waste heat recovery in heat pump systems: solution to reduce global warming

Energy conversion technologies, where waste heat recovery systems are included, have received significant attention in recent years due to reasons that include depletion of fossil fuel, increasing oil prices, changes in climatic conditions, and global warming. For low temperature applications, there...

Full description

Bibliographic Details
Main Authors:	Baradey, Yehya, Hawlader, Mohammad Nurul Alam, Ismail, Ahmad Faris, Hrairi, Meftah
Format:	Article
Language:	English English
Published:	IIUM Press 2015
Subjects:	TJ163.26 Energy conservation
Online Access:	http://irep.iium.edu.my/46397/ http://irep.iium.edu.my/46397/1/602-2434-1-PB.pdf http://irep.iium.edu.my/46397/4/46397_Waste_heat_recovery_in_heat_pump_systems_WOS.pdf

Similar Items

Analysis of solar desalination system using heat pump
by: Amin, Zakaria Mohd., et al.
Published: (2015)

PERFORMANCE OF A SOLAR INTEGRATED HEAT PUMP AIR-CONDITIONER, WATER HEATER AND DRYER
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2008)

Economic evaluation of a solar water heating system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (1987)

A triangular double layer microchannel heat sink: effect of parallel and counter flow
by: Manaf, Hazli, et al.
Published: (2014)

Numerical investigation of flow boiling in double-layer microchannel heat sink
by: Ahmed, Shugata, et al.
Published: (2014)

A solar assisted heat pump system for desalination
by: Amin, Zakaria Mohd., et al.
Published: (2011)

Comparative heat transfer analysis in different mini-channel heat sinks
by: Afzal, Asif, et al.
Published: (2017)

Numerical analysis of heat transfer and nanofluid flow in a triangular duct with vortex generator: two-phase model
by: Ahmed, Mirghani Ishag, et al.
Published: (2014)

Investigation of aluminum heat sink design with thermoelectric generator
by: Mohiuddin, A. K. M., et al.
Published: (2017)

Numerical investigation of semiempirical relations representing the local Nusselt number magnitude of a pin fin heat sink
by: Siddiqi, Mohammad Umar, et al.
Published: (2019)

Combined water and power plant (CWPP) — a novel desalination technology
by: Mahbub, Fazle, et al.
Published: (2009)

Pretreatment of seawater: Results of pilot trials in Singapore
by: Chua, K T, et al.
Published: (2003)

An active cooling system for photovoltaic module
by: Teo, H. G., et al.
Published: (2012)

Performance evaluation of a mechanical vapor compression desalination system
by: Bahar, Rubina, et al.
Published: (2004)

Transport analysis of an Air Gap Membrane Distillation (AGMD) process
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)

Effect of periodic drying on energy utilization, product quality, and drying time
by: Baradey, Yehya, et al.
Published: (2017)

A desalination system utilizing solar ambient and waste energy
by: Hawlader, M N A, et al.
Published: (2011)

Feasibility of double-layer microchannel fabrication at low speed micro end-mill and wire-cut EDM machines
by: Seder, Islam M.F., et al.
Published: (2014)

Validated analytical modeling of diesel engine regulated exhaust CO emission rate
by: Faris, Waleed Fekry, et al.
Published: (2016)

The study on performance of naturally aspirated spark ignition engine equipped with waste heat recovery mechanism
by: Herawan, Safarudin Gazali, et al.
Published: (2015)

Feasibility of double-layer microchannel fabrication at low speed micro end-mill and wire-cut EDM machines
by: Ahmed, Mirghani Ishag, et al.
Published: (2014)

Active control of suddenly expanded flow
by: Khan, Sher Afghan, et al.
Published: (2000)

Modelling and validation of proton exchange membrane fuel cell (PEMFC)
by: Mohiuddin, A. K. M., et al.
Published: (2018)

Performance analyses of horizontal axis wind turbines using QBlade
by: Zuhdi, Amirul Hakim, et al.
Published: (2017)

Energy harvesting from aerodynamic instabilities: Current prospect and future trends
by: Bashir, Musavir, et al.
Published: (2018)

On numerical investigation of semi-empirical relations representing local nusselt number at lower nozzle-target spacing’s
by: Siddique, Mohd Umair, et al.
Published: (2019)

Threaded spikes for bluff body base flow control
by: Khan, Sher Afghan, et al.
Published: (2019)

Hydrocarbons as alternative refrigerants in domestic refrigerators
by: S, Parashurama, et al.
Published: (2019)

Control of ideally expanded and under expanded nozzle flows with micro jets
by: G M, Fharukh Ahmed, et al.
Published: (2016)

Investigation on producing silica from rice husk biomass
by: Uddin, M.N., et al.
Published: (2018)

Thermo-mechanical analysis and estimation of turbine blade tip clearance of a small gas turbine engine under transient operating conditions
by: Kumar, Rahul, et al.
Published: (2020)

Magnetically plucked piezoelectric energy harvester via hybrid kinetic motion
by: Azam, Huda, et al.
Published: (2019)

Optimization of cooling systems in data centre by computational fluid dynamics model and simulation
by: Romadhon, Rahmat, et al.
Published: (2009)

Reconstruction and electronic properties of interface between carbon nanotubes and ferromagnetic co electrodes
by: Cuong, Nguyen Tien, et al.
Published: (2012)

Optimization of a cooling system in data centers
by: Ali, Maisarah, et al.
Published: (2012)

EMK 402 - SISTEM PENUKARAN TENAGA OKT-NOV 1994.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (1994)

EMH 462(3) - ENERGY CONVERSION SYSTEM APRIL 07.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (2007)

EMH 462E(3) - ENERGY CONVERSION SYSTEM APR-MEI 06.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (2006)

EMK 402 - SISTEM PENUKARAN TENAGA APRIL 1997.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (1997)

On the effects of tangential air inlets distribution configurations to the combustion characteristics of a direct injection liquid fueled Swirl Flameless Combustor (SFC)
by: K., Adam, et al.
Published: (2021)