Particle swarm optimization of micro air launch vehicle trajectory

QR Code

Particle swarm optimization of micro air launch vehicle trajectory

The demand for sub microsatellites is growing rapidly. A new low-cost launching method is needed to launch these types of satellites. This can be done by launching from airplanes. By implementing air launching, there would be no restrictions on the launch site, the launch angle, and the launch dire...

Full description

Bibliographic Details
Main Authors:	Omar, Hanafy, Idres, Moumen, Kafafy, Raed
Format:	Article
Language:	English
Published:	Canadian Aeronautics and Space Institute 2011
Subjects:	TJ Mechanical engineering and machinery
Online Access:	http://irep.iium.edu.my/43836/ http://irep.iium.edu.my/43836/1/2011-Particleswarmoptimizationofamicroairlaunch_2011.pdf

Similar Items

Particle Swarm-Based Micro Air Launch Vehicle Trajectory Optimization Method
by: Omar, Hanafy, et al.
Published: (2012)

Particle swarm optimization of air-launch vehicle and trajectory
by: Aldheeb, M, et al.
Published: (2011)

Design optimization of Micro Air Launch Vehicle using differential evolution
by: Aldheeb, Mohammed, et al.
Published: (2012)

On the scaling of air launch vehicles
by: Kafafy, Raed, et al.
Published: (2011)

Air supply system transient model for proton exchange membrane fuel cell
by: Mohammed Idres, Moumen, et al.
Published: (2011)

Dynamic thermal model for proton-exchange membrane fuel cell
by: Mohamed Idres, Moumen, et al.
Published: (2010)

Air supply system transient model for proton exchange membrane fuel cell
by: Mahmoud Idres, Moumen Mohammed, et al.
Published: (2011)

One-dimensional analysis of thermoelement exposed to lateral heat transfer as a wall in MEMS-based thermoelectrically controlled micronozzle
by: Hameed, Ammar, et al.
Published: (2012)

Modelling and Optimization of Asymmetric Vehicle Routing Problem Using Particle Swarm Optimization Algorithm
by: Muhamad Rozikin, Kamaluddin, et al.
Published: (2021)

Effectiveness of wheel-typed grain design for hybrid rocket motor performance
by: Kafafy, Raed Ismail, et al.
Published: (2013)

Simulation of wheel type fuel grain in hybrid rocket motor
by: Azami, Muhammad Hanafi, et al.
Published: (2013)

Hybrid rocket performance with varying additive concentrations
by: Kafafy, Raed, et al.
Published: (2013)

One dimensional analysis of thermoelement exposed to lateral heat transfer as a wall in MEMS-Based thermoelectrically controlled micronozzle
by: Mohammed Idres, Moumen, et al.
Published: (2011)

Effect of varying design options on the transient behavior of a hybrid rocket motor
by: Kafafy, Raed Ismail, et al.
Published: (2014)

Frequency estimation of flow induced vibration in thin cantilever plate
by: Javeed, Abdulhakeem, et al.
Published: (2013)

Experimental investigation of the performance of flutter-based microgenerators
by: Kafafy, Raed, et al.
Published: (2013)

Two-dimensional flow properties of micronozzle under varied isothermal wall conditions
by: Hameed, Amar Hasan, et al.
Published: (2011)

Optimization of multi-holes drilling path using particle swarm optimization
by: Najwa Wahida, Zainal Abidin, et al.
Published: (2018)

Design of an autopilot for an autonomous unmanned aerial vehicle
by: Idres, Moumen, et al.
Published: (2011)

Parametric Optimization Of Magneto-Rheological Fluid Damper Using Particle Swarm Optimization
by: Mohd Azraai, M. Razman, et al.
Published: (2015)

Modeling and optimization of multi-holes drilling path using Particle Swarm Optimization
by: Ab Rashid, Mohd Fadzil Faisae, et al.
Published: (2018)

Three-dimensional vibration analysis of fluid-filled pipes
by: Kolo, Isa, et al.
Published: (2013)

Development of generic algorithm in wheel-typed hybrid rocket grain design for performance estimation
by: Kafafy, Raed, et al.
Published: (2012)

Orifice plate flowmeter performance under pulsating flow conditions
by: Idres, Moumen, et al.
Published: (2014)

An enhancement of binary particle swarm optimization for gene selection in classifying cancer classes
by: Mohd Saberi, Mohamad, et al.
Published: (2013)

Development and optimization of a vehicle front-end geometry model for improved pedestrian safety
by: Abdullah, Kassim Abdulrahman, et al.
Published: (2014)

Minimizing normal vehicle forces effect during cornering of a two in-wheel vehicle through the identification of optimum speed via particle swarm optimization
by: Nurul Afiqah, Zainal, et al.
Published: (2021)

Methods of aircraft trajectory optimisation in air combat
by: Nusyirwan, Istas Fahrurrazi, et al.
Published: (2007)

Minimization of tool path length of drilling process using particle swarm optimization (PSO)
by: Abdullah, Haslina, et al.
Published: (2020)

Two-dimensional flow properties of micronozzle under varied isothermal wall conditions
by: Hameed, Amar Hasan, et al.
Published: (2013)

Optimization of PID parameters for hydraulic positioning system utilizing variable weight Grey-Taguchi and particle swarm optimization
by: Nur Iffah, Mohamed Azmi
Published: (2014)

Parameter identification of a coupled tank liquid evel system via particle swarm optimization
by: Nur Azmina, Othman
Published: (2009)

Introduction to compressors
by: Idres, Moumen
Published: (2011)

Three-dimensional analysis of compressors
by: Idres, Moumen
Published: (2011)

Rotating stall and surge
by: Idres, Moumen
Published: (2011)

Modeling of compression systems
by: Idres, Moumen
Published: (2011)

Experimental Study on the Effect of Skin Flexibility on Aerodynamic Performance of Flapping Wings for Micro Air Vehicles
by: Hamid, Yusoff, et al.
Published: (2014)

Tuning of Optimum PID Controller Parameter using Particle Swarm Optimization Algorithm Approach
by: Wan Azhar, Wan Yusoff, et al.
Published: (2007)

Trajectory planning using GPS for Unmanned Aerial Vehicle with microcontroller based system
by: Shafie, Amir Akramin, et al.
Published: (2011)

Development of economical vehicle model for pedestrian-friendly front-end profile study
by: Kausalyah, Venkatason, et al.
Published: (2014)