Parametric study of earth-to-air heat exchanger in Malaysian climate

QR Code

Parametric study of earth-to-air heat exchanger in Malaysian climate

The technology, where the ground was used as a heat sink to produce cooler air, has been an area of interest in Malaysia even before National Green Technology Policy was launched in 2009. This simulation study is based on ASHRAE Weather database, local data collected in previous field studies at Uni...

Full description

Bibliographic Details
Main Authors:	Ibrahim, Md. Najib, Sanusi, Aliyah Nur Zafirah, Ali, Maisarah, Aziz Ahmed, Soran Hama
Format:	Proceeding Paper
Language:	English
Published:	2013
Subjects:	TH7005 Heating and ventilation TJ163.26 Energy conservation
Online Access:	http://irep.iium.edu.my/32504/ http://irep.iium.edu.my/32504/1/Sanusi_Ibrahim_ACSEE_Offprint_0140.pdf

Similar Items

Energy-Efficient Low-Complexity Algorithm in 5G Massive MIMO Systems
by: Salh, Adeeb, et al.
Published: (2021)

PERFORMANCE OF A SOLAR INTEGRATED HEAT PUMP AIR-CONDITIONER, WATER HEATER AND DRYER
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2008)

Modelling and validation of proton exchange membrane fuel cell (PEMFC)
by: Mohiuddin, A. K. M., et al.
Published: (2018)

Transport analysis of an Air Gap Membrane Distillation (AGMD) process
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)

The potential of low energy earth pipe cooling in hot and humid Malaysia
by: Sanusi, Aliyah Nur Zafirah, et al.
Published: (2012)

Optimization of a cooling system in data centers
by: Ali, Maisarah, et al.
Published: (2012)

Optimization of cooling systems in data centre by computational fluid dynamics model and simulation
by: Romadhon, Rahmat, et al.
Published: (2009)

Comparative heat transfer analysis in different mini-channel heat sinks
by: Afzal, Asif, et al.
Published: (2017)

Waste heat recovery in heat pump systems: solution to reduce global warming
by: Baradey, Yehya, et al.
Published: (2015)

Analysis of solar desalination system using heat pump
by: Amin, Zakaria Mohd., et al.
Published: (2015)

Investigation of aluminum heat sink design with thermoelectric generator
by: Mohiuddin, A. K. M., et al.
Published: (2017)

Economic evaluation of a solar water heating system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (1987)

On the effects of tangential air inlets distribution configurations to the combustion characteristics of a direct injection liquid fueled Swirl Flameless Combustor (SFC)
by: K., Adam, et al.
Published: (2021)

Numerical investigation of flow boiling in double-layer microchannel heat sink
by: Ahmed, Shugata, et al.
Published: (2014)

A triangular double layer microchannel heat sink: effect of parallel and counter flow
by: Manaf, Hazli, et al.
Published: (2014)

Numerical analysis of heat transfer and nanofluid flow in a triangular duct with vortex generator: two-phase model
by: Ahmed, Mirghani Ishag, et al.
Published: (2014)

Numerical investigation of semiempirical relations representing the local Nusselt number magnitude of a pin fin heat sink
by: Siddiqi, Mohammad Umar, et al.
Published: (2019)

Feasibility of double-layer microchannel fabrication at low speed micro end-mill and wire-cut EDM machines
by: Ahmed, Mirghani Ishag, et al.
Published: (2014)

Active control of suddenly expanded flow
by: Khan, Sher Afghan, et al.
Published: (2000)

Feasibility of double-layer microchannel fabrication at low speed micro end-mill and wire-cut EDM machines
by: Seder, Islam M.F., et al.
Published: (2014)

Performance analyses of horizontal axis wind turbines using QBlade
by: Zuhdi, Amirul Hakim, et al.
Published: (2017)

Validated analytical modeling of diesel engine regulated exhaust CO emission rate
by: Faris, Waleed Fekry, et al.
Published: (2016)

Energy harvesting from aerodynamic instabilities: Current prospect and future trends
by: Bashir, Musavir, et al.
Published: (2018)

On numerical investigation of semi-empirical relations representing local nusselt number at lower nozzle-target spacing’s
by: Siddique, Mohd Umair, et al.
Published: (2019)

Threaded spikes for bluff body base flow control
by: Khan, Sher Afghan, et al.
Published: (2019)

Hydrocarbons as alternative refrigerants in domestic refrigerators
by: S, Parashurama, et al.
Published: (2019)

Control of ideally expanded and under expanded nozzle flows with micro jets
by: G M, Fharukh Ahmed, et al.
Published: (2016)

Investigation on producing silica from rice husk biomass
by: Uddin, M.N., et al.
Published: (2018)

Thermo-mechanical analysis and estimation of turbine blade tip clearance of a small gas turbine engine under transient operating conditions
by: Kumar, Rahul, et al.
Published: (2020)

Magnetically plucked piezoelectric energy harvester via hybrid kinetic motion
by: Azam, Huda, et al.
Published: (2019)

A desalination system utilizing solar ambient and waste energy
by: Hawlader, M N A, et al.
Published: (2011)

Reconstruction and electronic properties of interface between carbon nanotubes and ferromagnetic co electrodes
by: Cuong, Nguyen Tien, et al.
Published: (2012)

An active cooling system for photovoltaic module
by: Teo, H. G., et al.
Published: (2012)

Combined water and power plant (CWPP) — a novel desalination technology
by: Mahbub, Fazle, et al.
Published: (2009)

Performance evaluation of a mechanical vapor compression desalination system
by: Bahar, Rubina, et al.
Published: (2004)

Pretreatment of seawater: Results of pilot trials in Singapore
by: Chua, K T, et al.
Published: (2003)

An improved method to evaluate indoor microclimatic data: case study of a book archive in a hot and humid climate
by: Ali, Maisarah, et al.
Published: (2014)

EMK 402 - SISTEM PENUKARAN TENAGA OKT-NOV 1994.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (1994)

EMH 462(3) - ENERGY CONVERSION SYSTEM APRIL 07.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (2007)

EMH 462E(3) - ENERGY CONVERSION SYSTEM APR-MEI 06.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (2006)