Wear, performance and emissions of a two-stroke engine running on palm oil methyl ester blended lubricant
Results of study on wear of piston rings, engine performance and exhaust gas emissions of palm oil methyl ester (POME) as a lubricating oil additive in a two-stroke gasoline engine test are presented. Piston ring wear behaviour was monitored as a function of running time. The power output and brake...
| Main Authors: | Masjuki, H.H., Maleque, Md. Abdul |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
SAGE Publications Ltd
1996
|
| Subjects: | |
| Online Access: | http://irep.iium.edu.my/29649/ http://irep.iium.edu.my/29649/1/P3_1996_Wear%2C_Performance_and_Emissions_of_a_Two-Stroke_Engine_Running_on_Palm_Oil_Methyl_Ester_Blended.pdf |
Similar Items
Wear surface characteristics study of tribo-materials under palm oil methyl ester added lubricant
by: Maleque, Md. Abdul, et al.
Published: (2002)
by: Maleque, Md. Abdul, et al.
Published: (2002)
Performance, emissions and wear characteristics of an indirect injection diesel engine using coconut oil blended fuel
by: Masjuki, H.H., et al.
Published: (2001)
by: Masjuki, H.H., et al.
Published: (2001)
Validated analytical modeling of diesel engine regulated exhaust CO emission rate
by: Faris, Waleed Fekry, et al.
Published: (2016)
by: Faris, Waleed Fekry, et al.
Published: (2016)
An active cooling system for photovoltaic module
by: Teo, H. G., et al.
Published: (2012)
by: Teo, H. G., et al.
Published: (2012)
Economic evaluation of a solar water heating system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (1987)
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (1987)
Analysis of solar desalination system using heat pump
by: Amin, Zakaria Mohd., et al.
Published: (2015)
by: Amin, Zakaria Mohd., et al.
Published: (2015)
Feasibility of double-layer microchannel fabrication at low speed micro end-mill and wire-cut EDM machines
by: Ahmed, Mirghani Ishag, et al.
Published: (2014)
by: Ahmed, Mirghani Ishag, et al.
Published: (2014)
Numerical investigation of flow boiling in double-layer microchannel heat sink
by: Ahmed, Shugata, et al.
Published: (2014)
by: Ahmed, Shugata, et al.
Published: (2014)
Numerical analysis of heat transfer and nanofluid flow in a
triangular duct with vortex generator: two-phase model
by: Ahmed, Mirghani Ishag, et al.
Published: (2014)
by: Ahmed, Mirghani Ishag, et al.
Published: (2014)
A triangular double layer microchannel heat sink: effect of parallel and counter flow
by: Manaf, Hazli, et al.
Published: (2014)
by: Manaf, Hazli, et al.
Published: (2014)
Waste heat recovery in heat pump systems: solution to reduce global warming
by: Baradey, Yehya, et al.
Published: (2015)
by: Baradey, Yehya, et al.
Published: (2015)
Active control of suddenly expanded flow
by: Khan, Sher Afghan, et al.
Published: (2000)
by: Khan, Sher Afghan, et al.
Published: (2000)
Feasibility of double-layer microchannel fabrication at low speed micro end-mill and wire-cut EDM machines
by: Seder, Islam M.F., et al.
Published: (2014)
by: Seder, Islam M.F., et al.
Published: (2014)
Modelling and validation of proton exchange membrane fuel cell (PEMFC)
by: Mohiuddin, A. K. M., et al.
Published: (2018)
by: Mohiuddin, A. K. M., et al.
Published: (2018)
Performance analyses of horizontal axis wind turbines using QBlade
by: Zuhdi, Amirul Hakim, et al.
Published: (2017)
by: Zuhdi, Amirul Hakim, et al.
Published: (2017)
Investigation of aluminum heat sink design with thermoelectric generator
by: Mohiuddin, A. K. M., et al.
Published: (2017)
by: Mohiuddin, A. K. M., et al.
Published: (2017)
Comparative heat transfer analysis in different mini-channel heat sinks
by: Afzal, Asif, et al.
Published: (2017)
by: Afzal, Asif, et al.
Published: (2017)
Energy harvesting from aerodynamic instabilities: Current
prospect and future trends
by: Bashir, Musavir, et al.
Published: (2018)
by: Bashir, Musavir, et al.
Published: (2018)
Numerical investigation of semiempirical relations representing the local Nusselt number magnitude of a pin fin heat sink
by: Siddiqi, Mohammad Umar, et al.
Published: (2019)
by: Siddiqi, Mohammad Umar, et al.
Published: (2019)
On numerical investigation of semi-empirical relations representing local nusselt number at lower nozzle-target spacing’s
by: Siddique, Mohd Umair, et al.
Published: (2019)
by: Siddique, Mohd Umair, et al.
Published: (2019)
Threaded spikes for bluff body base flow control
by: Khan, Sher Afghan, et al.
Published: (2019)
by: Khan, Sher Afghan, et al.
Published: (2019)
Hydrocarbons as alternative refrigerants in domestic refrigerators
by: S, Parashurama, et al.
Published: (2019)
by: S, Parashurama, et al.
Published: (2019)
Control of ideally expanded and under expanded nozzle flows with micro jets
by: G M, Fharukh Ahmed, et al.
Published: (2016)
by: G M, Fharukh Ahmed, et al.
Published: (2016)
Investigation on producing silica from rice husk biomass
by: Uddin, M.N., et al.
Published: (2018)
by: Uddin, M.N., et al.
Published: (2018)
Thermo-mechanical analysis and estimation of turbine blade tip clearance of a small gas turbine engine under transient operating conditions
by: Kumar, Rahul, et al.
Published: (2020)
by: Kumar, Rahul, et al.
Published: (2020)
Magnetically plucked piezoelectric energy harvester via hybrid kinetic motion
by: Azam, Huda, et al.
Published: (2019)
by: Azam, Huda, et al.
Published: (2019)
A desalination system utilizing solar ambient and waste energy
by: Hawlader, M N A, et al.
Published: (2011)
by: Hawlader, M N A, et al.
Published: (2011)
Transport analysis of an Air Gap Membrane Distillation (AGMD) process
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)
Optimization of cooling systems in data centre by computational fluid dynamics model and simulation
by: Romadhon, Rahmat, et al.
Published: (2009)
by: Romadhon, Rahmat, et al.
Published: (2009)
Reconstruction and electronic properties of interface between carbon nanotubes and ferromagnetic co electrodes
by: Cuong, Nguyen Tien, et al.
Published: (2012)
by: Cuong, Nguyen Tien, et al.
Published: (2012)
Optimization of a cooling system in data centers
by: Ali, Maisarah, et al.
Published: (2012)
by: Ali, Maisarah, et al.
Published: (2012)
Combined water and power plant (CWPP) — a novel desalination technology
by: Mahbub, Fazle, et al.
Published: (2009)
by: Mahbub, Fazle, et al.
Published: (2009)
PERFORMANCE OF A SOLAR INTEGRATED HEAT PUMP AIR-CONDITIONER, WATER HEATER AND DRYER
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2008)
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2008)
Performance evaluation of a mechanical vapor compression
desalination system
by: Bahar, Rubina, et al.
Published: (2004)
by: Bahar, Rubina, et al.
Published: (2004)
Pretreatment of seawater: Results of pilot trials in Singapore
by: Chua, K T, et al.
Published: (2003)
by: Chua, K T, et al.
Published: (2003)
EMK 402 - SISTEM PENUKARAN TENAGA OKT-NOV 1994.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (1994)
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (1994)
EMH 462(3) - ENERGY CONVERSION SYSTEM APRIL 07.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (2007)
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (2007)
EMH 462E(3) - ENERGY CONVERSION SYSTEM APR-MEI 06.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (2006)
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (2006)
EMK 402 - SISTEM PENUKARAN TENAGA APRIL 1997.
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (1997)
by: PPKM, Pusat Pengajian Kejuruteraan Mekanikal
Published: (1997)
On the effects of tangential air inlets distribution
configurations to the combustion characteristics of a direct
injection liquid fueled Swirl Flameless Combustor (SFC)
by: K., Adam, et al.
Published: (2021)
by: K., Adam, et al.
Published: (2021)
Similar Items
-
Wear surface characteristics study of tribo-materials under palm oil methyl ester added lubricant
by: Maleque, Md. Abdul, et al.
Published: (2002) -
Performance, emissions and wear characteristics of an indirect injection diesel engine using coconut oil blended fuel
by: Masjuki, H.H., et al.
Published: (2001) -
Validated analytical modeling of diesel engine regulated exhaust CO emission rate
by: Faris, Waleed Fekry, et al.
Published: (2016) -
An active cooling system for photovoltaic module
by: Teo, H. G., et al.
Published: (2012) -
Economic evaluation of a solar water heating system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (1987)