The applicability of ISO household refrigerator-freezer energy test specifications in Malaysia
This paper presents the possibility of introducing ISO household refrigerator–freezer test standards in Malaysia. An experiment was conducted to investigate the effect of room temperature, door opening, thermostat setting position, relative humidity, and loading on energy consumption of a househol...
| Main Authors: | Masjuki , H.H., Saidur , Rahman, Choudhury, Imtiaz Ahmed, Mahlia, Teuku Meurah Indra, Ghani, A.K., Maleque, Md. Abdul |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
Elsevier Limited
2001
|
| Subjects: | |
| Online Access: | http://irep.iium.edu.my/29573/ http://irep.iium.edu.my/29573/1/P9_2001.pdf |
Similar Items
An economic optimization of evaporator and air collector area in a solar assisted heat pump drying system
by: Rahman, S. M. A., et al.
Published: (2013)
by: Rahman, S. M. A., et al.
Published: (2013)
Performance evaluation of solar collectors using a solar simulator
by: Mohamed, Norhafana, et al.
Published: (2015)
by: Mohamed, Norhafana, et al.
Published: (2015)
Modeling and analysis of flutter-based thin-film cantilever microgenerator
by: Abdul Hakim, Javid, et al.
Published: (2015)
by: Abdul Hakim, Javid, et al.
Published: (2015)
Investigation of PEM fuel cell for automotive use
by: Mohiuddin, A. K. M., et al.
Published: (2015)
by: Mohiuddin, A. K. M., et al.
Published: (2015)
Improving the efficiency of poly-crystalline photovoltaic
module using special transparent glass covers
by: Baradey, Y., et al.
Published: (2014)
by: Baradey, Y., et al.
Published: (2014)
Ocean thermal energy conversion: the promise of a clean future
by: Hossain, A., et al.
Published: (2013)
by: Hossain, A., et al.
Published: (2013)
Comparative study of R134a and R744 driven solar assisted heat pump systems for different applications
by: Baradey, Yehya, et al.
Published: (2016)
by: Baradey, Yehya, et al.
Published: (2016)
Design and development of hybrid energy generator
(photovoltaics) with solar tracker
by: Mohiuddin, A. K. M., et al.
Published: (2017)
by: Mohiuddin, A. K. M., et al.
Published: (2017)
Improvement design of parabolic trough
by: Ihsan, Sany Izan, et al.
Published: (2017)
by: Ihsan, Sany Izan, et al.
Published: (2017)
Recycling and disposal of lithium batteries: an economical and environmental approach
by: Rahman, Mohammed Ataur, et al.
Published: (2017)
by: Rahman, Mohammed Ataur, et al.
Published: (2017)
Desalination technologies: a critical review
by: Baradey, Yehya, et al.
Published: (2018)
by: Baradey, Yehya, et al.
Published: (2018)
Modelling of spray evaporation and penetration for alternative fuels
by: Azami, Muhammad Hanafi, et al.
Published: (2016)
by: Azami, Muhammad Hanafi, et al.
Published: (2016)
Enhancement of oil palm empty fruit bunch char by impregnation of pyrolytic carbon from tar vapor decomposition
by: Rozhan, Alya Naili, et al.
Published: (2016)
by: Rozhan, Alya Naili, et al.
Published: (2016)
Carbon deposition from biotar by fast pyrolysis of palm empty fruit bunch
by: Rozhan, Alya Naili, et al.
Published: (2016)
by: Rozhan, Alya Naili, et al.
Published: (2016)
Design and investigation of a fuel cell car prototype
by: Mohiuddin, A. K. M., et al.
Published: (2014)
by: Mohiuddin, A. K. M., et al.
Published: (2014)
Development of solar powered irrigation system
by: Abdelkerim, A I, et al.
Published: (2013)
by: Abdelkerim, A I, et al.
Published: (2013)
Utilization of solar energy and waste heat for water heating, drying and desalination of seawater
by: Hawlader, Mohammad Nurul Alam
Published: (2013)
by: Hawlader, Mohammad Nurul Alam
Published: (2013)
An economic analysis of a solar assisted heat pump system for cooling, water heating and drying
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)
Performance of different photovoltaic cells operating under the meteorological conditions of Singapore
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2011)
Economic performance of bio-gas plant in the context of Bangladesh
by: Paul, Dilip Kumar, et al.
Published: (1999)
by: Paul, Dilip Kumar, et al.
Published: (1999)
An air conditioning system providing cooling, water heating and drying
by: Ihsan, Sany Izan, et al.
Published: (2012)
by: Ihsan, Sany Izan, et al.
Published: (2012)
An integrated solar thermal and photovoltaic system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2012)
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2012)
Design and Development of a Fuel Cell Car Prototype
by: Mohiuddin, A. K. M., et al.
Published: (2013)
by: Mohiuddin, A. K. M., et al.
Published: (2013)
3-D CFD transient simulation of transesterification
in stirred tank reactor
by: Mohiuddin, A. K. M., et al.
Published: (2013)
by: Mohiuddin, A. K. M., et al.
Published: (2013)
Solar assisted heat pump desalination system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2004)
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2004)
An analysis of the non-convecting solar pond
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (1981)
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (1981)
Development of solar air collectors for drying applications
by: Karim, M A, et al.
Published: (2004)
by: Karim, M A, et al.
Published: (2004)
Solar assisted heat-pump dryer and
water heater
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2003)
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2003)
The performance of a solar assisted heat pump water heating system
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2001)
by: Hawlader, Mohammad Nurul Alam, et al.
Published: (2001)
Analysis of crude palm oil composition in a chemical process conveyor using Electrical Capacitance Tomography
by: Mohamad, Elmy Johana, et al.
Published: (2016)
by: Mohamad, Elmy Johana, et al.
Published: (2016)
Performance assessment of parabolic trough collector (ptc) by using three passes receiver for preheating the fuel oil under Iraq climate for different mass flow rates
by: Abbas, Mohammed Saad, et al.
Published: (2019)
by: Abbas, Mohammed Saad, et al.
Published: (2019)
Dynamic analysis of a 10m diameter wind turbine rotor under maximum wind load of Malaysia
by: Mohd, Sofian
Published: (2006)
by: Mohd, Sofian
Published: (2006)
Advance control of Dual Active Bridge Multilevel Inverter (DABMI) with Open Winding Transformer (OWT) model
by: Bohari, Azuwien Aida
Published: (2021)
by: Bohari, Azuwien Aida
Published: (2021)
The bonded macro fiber composite (MFC) and woven kenaf effect analyses on the micro energy harvester performance of kenaf plate using modal testing and Taguchi method
by: Hamdan, A., et al.
Published: (2016)
by: Hamdan, A., et al.
Published: (2016)
Vibration based energy harvesting interface circuit using diode-capacitor topologies for low power applications
by: Amirnudin, Amirul Adlan, et al.
Published: (2017)
by: Amirnudin, Amirul Adlan, et al.
Published: (2017)
A study on palm fiber reinforces as a filament in portable FDM
by: Marwah @ Omar, Omar Mohd Faizan, et al.
Published: (2016)
by: Marwah @ Omar, Omar Mohd Faizan, et al.
Published: (2016)
An extensive review of energy storage system for the residential renewable energy system
by: Mustaza, M. S. A., et al.
Published: (2019)
by: Mustaza, M. S. A., et al.
Published: (2019)
CFD investigation of empty flanged diffuser augmented wind turbine
by: Jabbar Al-Quraishi, Balasem Abdulameer, et al.
Published: (2019)
by: Jabbar Al-Quraishi, Balasem Abdulameer, et al.
Published: (2019)
Solar photocatalytic degradation of basic red 51 in hair dye bathroom greywater using zinc oxide nanoparticles synthesized with Corriandrum sativum leaf extract
by: Gopalakrishnan, Yashni
Published: (2021)
by: Gopalakrishnan, Yashni
Published: (2021)
Lighting system design using green energy from living plants
by: Lee, Ming Foong, et al.
Published: (2018)
by: Lee, Ming Foong, et al.
Published: (2018)
Similar Items
-
An economic optimization of evaporator and air collector area in a solar assisted heat pump drying system
by: Rahman, S. M. A., et al.
Published: (2013) -
Performance evaluation of solar collectors using a solar simulator
by: Mohamed, Norhafana, et al.
Published: (2015) -
Modeling and analysis of flutter-based thin-film cantilever microgenerator
by: Abdul Hakim, Javid, et al.
Published: (2015) -
Investigation of PEM fuel cell for automotive use
by: Mohiuddin, A. K. M., et al.
Published: (2015) -
Improving the efficiency of poly-crystalline photovoltaic
module using special transparent glass covers
by: Baradey, Y., et al.
Published: (2014)