Simulation and experimental investigation of muffler performance

QR Code

Simulation and experimental investigation of muffler performance

The purpose of the muffler is to reduce the exhaust noise produced by the engine. The main objective of this study is to simulate and investigate experimentally the muffler of the Alfa Romeo 145 vehicle. The dimensions of the muffler were used to perform the simulation. Experimentations were per...

Full description

Bibliographic Details
Main Authors:	Mohiuddin, A. K. M., Rahman, Mohammed Ataur, Gazali, Yazid
Format:	Article
Language:	English
Published:	Universiti Malaya 2007
Subjects:	TL1 Motor vehicles
Online Access:	http://irep.iium.edu.my/1195/ http://irep.iium.edu.my/1195/1/IJMME_2007-4.pdf

Similar Items

Experimental investigation and simulation of muffler performance
by: Mohiuddin, A. K. M., et al.
Published: (2007)

Experimental analysis of noise and back pressure for muffler design
by: Mohiuddin, A. K. M., et al.
Published: (2008)

Muffler design optimization through experimental analysis of noise and back pressure
by: Mohiuddin, A. K. M., et al.
Published: (2005)

Experimental investigation of the swirl effect on CAMPRO engine using designed swirl adapter
by: Mohiuddin, A. K. M., et al.
Published: (2011)

Investigation using simulations for the development of low cost catalytic converter from non-precious metals
by: Mohiuddin, A. K. M., et al.
Published: (2012)

Experimental analysis and comparison performance characterisation of catalytic converters including simulation
by: Mohiuddin, A. K. M., et al.
Published: (2007)

Study on air-cushion tracked vehicle performance: theoretical analysis and experimental validation
by: Hossain, Altab, et al.
Published: (2011)

Investigation of non-precious metals for the development of low cost catalytic converter
by: Mohiuddin, A. K. M., et al.
Published: (2011)

Intelligent air-cushion tracked vehicle performance investigation: neural-networks
by: Hossain, Altab, et al.
Published: (2012)

Intelligent traction control system of an electric golf car: nonlinear dynamics investigation
by: Rahman, Mohammed Ataur, et al.
Published: (2011)

Investigation of the swirl effect on CAMPRO 1.6L engine using GT-SUITE
by: Mohiuddin, A. K. M., et al.
Published: (2009)

Mobility investigation of an intelligent air-cushion tracked vehicle on swamp peat terrain in Malaysia
by: Hossain, Altab, et al.
Published: (2011)

Mobility investigation of a designed and developed segmented rubber track vehicle on Sepang peat terrain in Malaysia
by: Rahman, Mohammed Ataur, et al.
Published: (2007)

Effectiveness of the developed instrumentation system on the vehicle tractive performance measurement
by: Rahman, Mohammed Ataur, et al.
Published: (2007)

Kinematics model for the wheeled vehicle tractive performance determination on Sepang’s peat terrain in Malaysia
by: Rahman, Mohammed Ataur, et al.
Published: (2009)

Investigation of low end torque dip problem of CAMPRO 1.6L engine
by: Mohiuddin, A. K. M., et al.
Published: (2008)

Tractive performance of LGP-30 wheeled vehicle during straight motion on Sepang peat terrain in Malaysia
by: Rahman, Mohammed Ataur, et al.
Published: (2009)

Investigation and probable solution of low end torque dip problem of CAMPRO 1.6L Engine
by: Mohiuddin, A. K. M., et al.
Published: (2008)

Performance investigation of an advanced tracked prime mover on the low bearing soil
by: Rahman, Mohammed Ataur, et al.
Published: (2013)

Intelligent air-cushion tracked vehicle performance investigation: neural-networks
by: Rahman, Mohammed Ataur, et al.
Published: (2011)

Electro-mechanically controlled continuously variable transmission system for passenger cars
by: Mohiuddin, A. K. M., et al.
Published: (2009)

Tractive performance prediction for intelligent air-cushion track vehicle: fuzzy logic approach
by: Hossain, Altab, et al.
Published: (2010)

Nonlinear controller of an air-cushion system for a swamp terrain vehicle: fuzzy logic approach
by: Hossain, Altab, et al.
Published: (2011)

Load distribution for an intelligent air-cushion track vehicle based on optimal power consumption
by: Hossain, Altab, et al.
Published: (2010)

Hybrid electrical air-cushion tracked vehicle for swamp peat in Malaysia
by: Rahman, Mohammed Ataur, et al.
Published: (2008)

Study of Fuzzy Controller to control vertical position of an air-cushion tracked vehicle
by: Hossain, Altab, et al.
Published: (2011)

Dynamic modeling and simulation of waste energy harvesting system for urban car
by: Abdul Razak, Fadhilah, et al.
Published: (2012)

Electromagnetic contactless torque transducer: torque measurement and shaft impediment approach
by: Rahman, Mohammed Ataur, et al.
Published: (2019)

Application of Multi-objective Genetic Algorithm (MOGA) for design optimization of valve timing at various engine speeds
by: Mohiuddin, A. K. M., et al.
Published: (2011)

Simulated steerability of a segmented rubber tracked vehicle during turning on sepang peat terrain in Malaysia
by: Rahman, Mohammed Ataur, et al.
Published: (2005)

Investigation of the Swirl Effect on Engine Using Designed Swirl Adapter
by: Mohiuddin, A. K. M.
Published: (2011)

Modelling and simulation of graphene/palladium catalyst reformer for hydrogen generation from the waste of IC engine
by: Rahman, Mohammed Ataur, et al.
Published: (2018)

Possible solution to smoothen the nature of the torque curve of the CAMPRO engine
by: Mohiuddin, A. K. M., et al.
Published: (2011)

Optimal design of automobile exhaust system using GT-power
by: Mohiuddin, A. K. M., et al.
Published: (2007)

Dynamic modeling of intelligent air-cushion tracked vehicle for swamp peat
by: Hossain, Altab, et al.
Published: (2010)

Study on the development of a fuzzy logic control electromagnetic actuated CVT system
by: Sharif, Sazzad, et al.
Published: (2013)

Possible solution to smoothen the torque curve of the CAMPRO engine
by: Mohiuddin, A. K. M., et al.
Published: (2011)

Probable solution of torque dip problem of CAMPRO 1.6L engine
by: Mohiuddin, A. K. M., et al.
Published: (2008)

Experimental study of noise and back pressure for silencer design characteristics
by: Mohiuddin, A. K. M., et al.
Published: (2005)

Design and development of an automatic car door opening and locking system
by: Rahman, Mohammed Ataur, et al.
Published: (2008)