The effect of cross-rolling on the growth of goss grains in a grain oriented silicon steel

QR Code

The effect of cross-rolling on the growth of goss grains in a grain oriented silicon steel

© 2016, Springer International Publishing AG. All rights reserved. A series of cross-rolled cold rolling experiments, followed by annealing experiments, were carried out on a commercial two-pass cold rolled Fe-Si alloy. Even though no major influence was observed on the primary recrystallized grains...

Full description

Bibliographic Details
Main Authors:	Citrawati, F., Quadir, Md Zakaria, Munroe, P.
Format:	Conference Paper
Published:	2016
Online Access:	http://hdl.handle.net/20.500.11937/69920

Similar Items

Effect of heating rate and annealing temperature on secondary recrystallization of goss grains in a grain orientated silicon steel
by: Citrawati, F., et al.
Published: (2017)

Grain boundary deformation phenomena and secondary growth of goss grains in a Fe-3.5%Si steel
by: Citrawati, F., et al.
Published: (2017)

The effect of final annealing heating rate on abnormal grain growth in a Fe-3.5%Si steel
by: Citrawati, F., et al.
Published: (2017)

Unusual crystallographic aspects of Microband boundaries within {111}<110> oriented grains in a cold rolled interstitial free steel
by: Zinnia, N., et al.
Published: (2014)

Structural Refinement, Recrystallization and Grain Growth Phenomena in an Accumulative Roll Bonded Nickel Sheet
by: Quadir, Md Zakaria, et al.
Published: (2017)

A grain detection system for grain-oriented electrical steels
by: Mohd Ali, Borhanuddin, et al.
Published: (1989)

Formation of Highly Misoriented Fragments at Hot Band Grain Boundaries During Cold Rolling of Interstitial-Free Steel
by: Afrin, N., et al.
Published: (2015)

Origin of copious recrystallization in cold rolled interstitial free (IF) steels
by: Quadir, Md Zakaria, et al.
Published: (2013)

On the complexities of microband interactions in a cold-deformed goss-oriented Ni single crystal
by: Afrin, N., et al.
Published: (2014)

Variations in through-thickness recrystallization and grain growth textures in the Al layers in ARB-processed Al/Al(0.3% Sc) composite sheets
by: Quadir, Md Zakaria, et al.
Published: (2016)

Spatial orientations and structural irregularities associated with the formation of microbands in a cold deformed Goss oriented Ni single crystal
by: Afrin, N., et al.
Published: (2012)

Comparison of grain to grain orientation and stiffness mapping by spatially resolved acoustic spectroscopy and EBSD
by: Mark, A.F., et al.
Published: (2017)

Grain growth and recrystallization behaviors of an ultrafine grained Al-0.6 wt%Mg-0.4 wt%Si-5vol.%SiC nanocomposite during heat treatment and extrusion
by: Yao, X., et al.
Published: (2018)

On the bumps and curves in the microband boundaries in a channel-die compressed Goss-oriented Ni single crystal
by: Afrin, N., et al.
Published: (2012)

The three-dimensional nature of microbands in a channel die compressed Goss-oriented Ni single crystal
by: Afrin, N., et al.
Published: (2011)

The Stiffness of Steel-Wood-Steel Connection Loaded Parallel to the Grain
by: Nur Liza, Rahim, et al.
Published: (2022)

Heterosis in grain protein content in varietal crosses of rice
by: Quah, S. C., et al.
Published: (1973)

The initial stages of formation of low angle boundaries within lamellar bands during accumulative roll bonding of aluminum
by: Quadir, Md Zakaria, et al.
Published: (2011)

Effect of grain size and grain content on the hardness and drillability of rocks
by: Mou Yang,, et al.
Published: (2014)

Mechanism of grain refinement in ferritic stainless steel welds: between dendrite fragmentation, grain detachment and heterogeneous nucleation
by: Amuda , Muhammed Olawale Hakeem, et al.
Published: (2011)

Grain refinement practices in ferritic stainless steel welds
by: Amuda, Muhammed Olawale Hakeem, et al.
Published: (2011)

Laser cladding of tool steel for grain boundary stability
by: Fazliana, Fauzun
Published: (2021)

The effect of grain orientation on secondary ion mass spectrometry (SIMS) analysis of rutile
by: Taylor, Rich, et al.
Published: (2012)

An ebsd study of nickel sheets after unidirectional and cross rolling arb processings
by: Duan, J., et al.
Published: (2015)

Effect of nitrogen fertilizer to growth, biomass and grain yield of paddy
by: Bejo, Siti Khairunniza, et al.
Published: (2017)

Effects of grain size and grain geometries on residual oil saturation after water flooding
by: Yunan, Mat Hussin
Published: (2008)

Effects of SiC Nanoparticle Content on the Microstructure and Tensile Mechanical Properties of Ultrafine Grained AA6063-SiCnp Nanocomposites Fabricated by Powder Metallurgy
by: Yao, X., et al.
Published: (2017)

Microstructure and mechanical properties of a bulk ultrafine grained Al-7Si-0.3Mg alloy produced by thermomechanical consolidation of a nanocrystalline powder
by: Liang, J., et al.
Published: (2016)

Effects of temperature and strain rate on the dynamic mechanical behavior of a fine grained Al-Sc alloy
by: Major, Z., et al.
Published: (2017)

Variation in grain Zn concentration, and the grain ionome, in field-grown Indian wheat
by: Prasad, Manoj, et al.
Published: (2018)

Optimization of Coarse-Grained Interaction Potential: Inside Inherent Limitations of Coarse-Graining Methods
by: Kowalczyk, Piotr, et al.
Published: (2011)

Modeling the Effect of Surface Energy on Stressed Grain Growth in Cubic Polycrystalline Bodies
by: M., Jamshidian, et al.
Published: (2016)

Precision grinding of silicon carbide using 46 µm grain diamond cup wheel
by: Mohamed , Konneh, et al.
Published: (2011)

Precision grinding of silicon carbide using 76 µm grain diamond cup wheel
by: Mohamed , Konneh, et al.
Published: (2011)

Precision grinding of silicon carbide using 107 µm Grain diamond cup wheel
by: Mohamed , Konneh, et al.
Published: (2011)

The potential of silicon in improving rice yield, grain quality, and minimising chalkiness: a review
by: Engku Abdullah, Engku Hasmah, et al.
Published: (2021)

Grain refinement in ferritic stainless steel welds: The journey so far
by: Amuda, M.O.H., et al.
Published: (2010)

Nanoscale characterisation of grain boundary oxidation in cold-worked stainless steels
by: Kruska, K., et al.
Published: (2012)

Whole grain uncovered
by: Hazali, Norazlanshah
Published: (2012)

Grain-size analysis
by: Saad, Shahbudin
Published: (2011)