Effect of heating rate and annealing temperature on secondary recrystallization of goss grains in a grain orientated silicon steel

QR Code

Effect of heating rate and annealing temperature on secondary recrystallization of goss grains in a grain orientated silicon steel

© 2017 ISIJ. In this investigation, a grain oriented silicon steel was annealed from a starting state of its primary recrystallized condition by varying time, temperature and heating rate to elucidate the phenomena that occur during the secondary recrystallization growth of Goss grains. Goss seconda...

Full description

Bibliographic Details
Main Authors:	Citrawati, F., Quadir, Md Zakaria, Munroe, P.
Format:	Journal Article
Published:	Nippon Tekko Kyokai 2017
Online Access:	http://hdl.handle.net/20.500.11937/69173

Similar Items

The effect of cross-rolling on the growth of goss grains in a grain oriented silicon steel
by: Citrawati, F., et al.
Published: (2016)

Grain boundary deformation phenomena and secondary growth of goss grains in a Fe-3.5%Si steel
by: Citrawati, F., et al.
Published: (2017)

The effect of final annealing heating rate on abnormal grain growth in a Fe-3.5%Si steel
by: Citrawati, F., et al.
Published: (2017)

Origin of copious recrystallization in cold rolled interstitial free (IF) steels
by: Quadir, Md Zakaria, et al.
Published: (2013)

Grain growth and recrystallization behaviors of an ultrafine grained Al-0.6 wt%Mg-0.4 wt%Si-5vol.%SiC nanocomposite during heat treatment and extrusion
by: Yao, X., et al.
Published: (2018)

Variations in through-thickness recrystallization and grain growth textures in the Al layers in ARB-processed Al/Al(0.3% Sc) composite sheets
by: Quadir, Md Zakaria, et al.
Published: (2016)

Structural Refinement, Recrystallization and Grain Growth Phenomena in an Accumulative Roll Bonded Nickel Sheet
by: Quadir, Md Zakaria, et al.
Published: (2017)

A grain detection system for grain-oriented electrical steels
by: Mohd Ali, Borhanuddin, et al.
Published: (1989)

Deformation and recrystallization of interstitial free (IF) steel
by: Duggan, B., et al.
Published: (2011)

Unusual crystallographic aspects of Microband boundaries within {111}<110> oriented grains in a cold rolled interstitial free steel
by: Zinnia, N., et al.
Published: (2014)

Through-thickness variations in recrystallization behavior in an Al-based ARB composite sheet
by: Najafzadeh, N., et al.
Published: (2014)

Grain-filling rate improves physical grain quality in barley under heat stress conditions during the grain-filling period
by: Shirdelmoghanloo, H., et al.
Published: (2022)

On the complexities of microband interactions in a cold-deformed goss-oriented Ni single crystal
by: Afrin, N., et al.
Published: (2014)

Spatial orientations and structural irregularities associated with the formation of microbands in a cold deformed Goss oriented Ni single crystal
by: Afrin, N., et al.
Published: (2012)

The effect of grain orientation on secondary ion mass spectrometry (SIMS) analysis of rutile
by: Taylor, Rich, et al.
Published: (2012)

Comparison of grain to grain orientation and stiffness mapping by spatially resolved acoustic spectroscopy and EBSD
by: Mark, A.F., et al.
Published: (2017)

On the bumps and curves in the microband boundaries in a channel-die compressed Goss-oriented Ni single crystal
by: Afrin, N., et al.
Published: (2012)

The three-dimensional nature of microbands in a channel die compressed Goss-oriented Ni single crystal
by: Afrin, N., et al.
Published: (2011)

Effects of temperature and strain rate on the dynamic mechanical behavior of a fine grained Al-Sc alloy
by: Major, Z., et al.
Published: (2017)

The Stiffness of Steel-Wood-Steel Connection Loaded Parallel to the Grain
by: Nur Liza, Rahim, et al.
Published: (2022)

Mechanism of grain refinement in ferritic stainless steel welds: between dendrite fragmentation, grain detachment and heterogeneous nucleation
by: Amuda , Muhammed Olawale Hakeem, et al.
Published: (2011)

Grain refinement practices in ferritic stainless steel welds
by: Amuda, Muhammed Olawale Hakeem, et al.
Published: (2011)

Laser cladding of tool steel for grain boundary stability
by: Fazliana, Fauzun
Published: (2021)

Formation of Highly Misoriented Fragments at Hot Band Grain Boundaries During Cold Rolling of Interstitial-Free Steel
by: Afrin, N., et al.
Published: (2015)

Effect of grain size and grain content on the hardness and drillability of rocks
by: Mou Yang,, et al.
Published: (2014)

Time and temperature regime of continuous grain coarsening in an ECAP-processed Al(0.1 wt.% Sc) alloy
by: Bommareddy, A., et al.
Published: (2012)

Precision grinding of silicon carbide using 46 µm grain diamond cup wheel
by: Mohamed , Konneh, et al.
Published: (2011)

Precision grinding of silicon carbide using 76 µm grain diamond cup wheel
by: Mohamed , Konneh, et al.
Published: (2011)

Precision grinding of silicon carbide using 107 µm Grain diamond cup wheel
by: Mohamed , Konneh, et al.
Published: (2011)

The potential of silicon in improving rice yield, grain quality, and minimising chalkiness: a review
by: Engku Abdullah, Engku Hasmah, et al.
Published: (2021)

Grain refinement in ferritic stainless steel welds: The journey so far
by: Amuda, M.O.H., et al.
Published: (2010)

Nanoscale characterisation of grain boundary oxidation in cold-worked stainless steels
by: Kruska, K., et al.
Published: (2012)

Whole grain uncovered
by: Hazali, Norazlanshah
Published: (2012)

Grain-size analysis
by: Saad, Shahbudin
Published: (2011)

Spatially resolved acoustic spectroscopy for rapid imaging of material microstructure and grain orientation
by: Smith, Richard J., et al.
Published: (2014)

Carpel size, grain filling, and morphology determine individual grain weight in wheat
by: Xie, Quan, et al.
Published: (2015)

Variation in grain Zn concentration, and the grain ionome, in field-grown Indian wheat
by: Prasad, Manoj, et al.
Published: (2018)

THE CENTRAL UPLIFT OF GOSSES BLUFF, NORTHERN TERRITORY, AUSTRALIA
by: Kenkmann, T., et al.
Published: (2018)

Exploratory studies on grain refinement in medium chromium ferritic stainless steel welds
by: Amuda, Muhammed Olawale Hakeem, et al.
Published: (2011)

Optimization of Coarse-Grained Interaction Potential: Inside Inherent Limitations of Coarse-Graining Methods
by: Kowalczyk, Piotr, et al.
Published: (2011)