Diffusion and precipitation phenomena across layer interfaces in a roll bonding composite of Al(Si) and Al(Cu)
Layered composite structures can be generated in metallic sheets by roll bonding of dissimilar metals/alloys. In this investigation, heat treatable (Al(Cu)) and non-heat treatable (Al(Si)) aluminium alloys are roll bonded in sheet form. Large hardness differences between layers poses significant bon...
| Main Authors: | Quadir, Md Zakaria, Lau, K., Afrin, N., Ferry, M. |
|---|---|
| Format: | Journal Article |
| Published: |
VSP BV, BRILL ACADEMIC PUBLISHERS,
2015
|
| Online Access: | http://hdl.handle.net/20.500.11937/54910 |
Similar Items
Structural Refinement, Recrystallization and Grain Growth Phenomena in an Accumulative Roll Bonded Nickel Sheet
by: Quadir, Md Zakaria, et al.
Published: (2017)
by: Quadir, Md Zakaria, et al.
Published: (2017)
An Analytical Framework for Predicting the Limit in Structural Refinement in Accumulative Roll Bonded Nickel
by: Duan, J., et al.
Published: (2015)
by: Duan, J., et al.
Published: (2015)
Substructural phenomena in Cu wire bond after laser assisted manufacturing in electronic packaging
by: Quadir, Zakaria, et al.
Published: (2020)
by: Quadir, Zakaria, et al.
Published: (2020)
Engineering low intensity planar textures in commercial purity nickel sheets by cross roll bonding
by: Duan, J., et al.
Published: (2017)
by: Duan, J., et al.
Published: (2017)
The mechanical performance of ARB fabricated hybrid lamellar composite of recovered/recrystallized Al and precipitation hardened Al(Sc) layers
by: Quadir, Md Zakaria, et al.
Published: (2011)
by: Quadir, Md Zakaria, et al.
Published: (2011)
Formation of Highly Misoriented Fragments at Hot Band Grain Boundaries During Cold Rolling of Interstitial-Free Steel
by: Afrin, N., et al.
Published: (2015)
by: Afrin, N., et al.
Published: (2015)
The initial stages of formation of low angle boundaries within lamellar bands during accumulative roll bonding of aluminum
by: Quadir, Md Zakaria, et al.
Published: (2011)
by: Quadir, Md Zakaria, et al.
Published: (2011)
Texture balancing in a fcc/bcc multilayered composite produced by accumulative roll bonding
by: Duan, J., et al.
Published: (2016)
by: Duan, J., et al.
Published: (2016)
Effect of copper and magnesium on the precipitation characteristics of Al-Li-Mg, Al-Li-Cu and Al-Li-Cu-Mg alloys
by: Katsikis, Spyros
Published: (2001)
by: Katsikis, Spyros
Published: (2001)
On the precipitation hardening of selective laser melted AlSi10Mg
by: Aboulkhair, Nesma T., et al.
Published: (2015)
by: Aboulkhair, Nesma T., et al.
Published: (2015)
Interface study of SiCp/6061Al composite
by: Adebisi, Adetayo A., et al.
Published: (2020)
by: Adebisi, Adetayo A., et al.
Published: (2020)
An ebsd study of nickel sheets after unidirectional and cross rolling arb processings
by: Duan, J., et al.
Published: (2015)
by: Duan, J., et al.
Published: (2015)
Fe-Al Diffusion Bonding: Effect of reaction time on the interlayer thickness / Asmawi Ismail...[et al.]
by: Ismail, Asmawi, et al.
Published: (2018)
by: Ismail, Asmawi, et al.
Published: (2018)
Grain boundary deformation phenomena and secondary growth of goss grains in a Fe-3.5%Si steel
by: Citrawati, F., et al.
Published: (2017)
by: Citrawati, F., et al.
Published: (2017)
Challenges in designing digital interfaces for the study of multimodal phenomena
by: O'Halloran, Kay, et al.
Published: (2010)
by: O'Halloran, Kay, et al.
Published: (2010)
The crystallinity and hardness properties of Al-Cu/SiCp new composite materials
by: Arifutzzaman, A., et al.
Published: (2012)
by: Arifutzzaman, A., et al.
Published: (2012)
The crystallinity and hardness properties of Al-Cu/SiCp new composite materials
by: Arifutzzama, A., et al.
Published: (2012)
by: Arifutzzama, A., et al.
Published: (2012)
Development of Al-Cu-SiCp metal matrix composite for automotive applications
by: Md Jalil, Mohd Azlis Sani
Published: (2005)
by: Md Jalil, Mohd Azlis Sani
Published: (2005)
Effect of microstructural anisotropy on the dynamic mechanical behaviour of rolled Ti-6Al-4V
by: Lock, A., et al.
Published: (2016)
by: Lock, A., et al.
Published: (2016)
Unusual crystallographic aspects of Microband boundaries within {111}<110> oriented grains in a cold rolled interstitial free steel
by: Zinnia, N., et al.
Published: (2014)
by: Zinnia, N., et al.
Published: (2014)
Coupled dissolution and precipitation at mineral-fluid interfaces
by: Rioz-Agudo, E., et al.
Published: (2014)
by: Rioz-Agudo, E., et al.
Published: (2014)
Bubble formation and interface phenomena of aqueous solution under microwave irradiation
by: Asakuma, Y., et al.
Published: (2016)
by: Asakuma, Y., et al.
Published: (2016)
Effect of copper on tensile strength improvement of Al-Cu-SiCp new composite
by: Maleque, Md. Abdul, et al.
Published: (2014)
by: Maleque, Md. Abdul, et al.
Published: (2014)
Permodelan termodinamik aloi al-Si-Cu untuk pemprosesan
logam separa pepejal
by: Salleh, M.S., et al.
Published: (2014)
by: Salleh, M.S., et al.
Published: (2014)
On the complexities of microband interactions in a cold-deformed goss-oriented Ni single crystal
by: Afrin, N., et al.
Published: (2014)
by: Afrin, N., et al.
Published: (2014)
3D microband boundary alignments and transitions in a cold rolled commercial purity aluminum alloy
by: George, C., et al.
Published: (2013)
by: George, C., et al.
Published: (2013)
Timescales of interface-coupled dissolution-precipitation reactions on carbonates
by: Renard, F., et al.
Published: (2019)
by: Renard, F., et al.
Published: (2019)
Unsteady transport phenomena of hybrid Al2O3-Cu/H2O nanofluid past a shrinking slender cylinder
by: Nurul Amira Zainal,, et al.
Published: (2021)
by: Nurul Amira Zainal,, et al.
Published: (2021)
Spontaneous S-Si bonding of alkanethiols to Si(111)-H: Towards Si-molecule-Si circuits
by: Peiris, Chandramalika, et al.
Published: (2020)
by: Peiris, Chandramalika, et al.
Published: (2020)
Interface bonding of NiCrAlY coating on laser modified H13 tool
steel surface
by: Mohamed Reza Zalani, Mohamed Suffian, et al.
Published: (2016)
by: Mohamed Reza Zalani, Mohamed Suffian, et al.
Published: (2016)
Interface Bonding of NiCrAlY Coating on Laser Modified H13 Tool Steel Surface
by: M. S., Reza, et al.
Published: (2016)
by: M. S., Reza, et al.
Published: (2016)
Effects of interface bonding of NiCrAlY on sandblasted laser modified H13 tool steel
by: Mohamed Reza Zalani, Mohamed Suffian, et al.
Published: (2025)
by: Mohamed Reza Zalani, Mohamed Suffian, et al.
Published: (2025)
Origin of copious recrystallization in cold rolled interstitial free (IF) steels
by: Quadir, Md Zakaria, et al.
Published: (2013)
by: Quadir, Md Zakaria, et al.
Published: (2013)
Participatory Budgeting: Diffusion and Outcomes across the World
by: Wampler, B., et al.
Published: (2012)
by: Wampler, B., et al.
Published: (2012)
Covalently bonded interfaces for polymer/graphene composites
by: Ma, Jun, et al.
Published: (2013)
by: Ma, Jun, et al.
Published: (2013)
Time and temperature regime of continuous grain coarsening in an ECAP-processed Al(0.1 wt.% Sc) alloy
by: Bommareddy, A., et al.
Published: (2012)
by: Bommareddy, A., et al.
Published: (2012)
Reduced graphene oxide-silicon interface involving direct Si-O bonding as a conductive and mechanical stable ohmic contact
by: Rahpeima, Soraya, et al.
Published: (2020)
by: Rahpeima, Soraya, et al.
Published: (2020)
Effect of lattice potential upon the surface diffusion of Si on Si(100)
by: Ibrahim Ali , Noorbatcha, et al.
Published: (1985)
by: Ibrahim Ali , Noorbatcha, et al.
Published: (1985)
Classical trajectory study of adsorption and surface diffusion of Si on Si(100)
by: Ibrahim Ali , Noorbatcha, et al.
Published: (1984)
by: Ibrahim Ali , Noorbatcha, et al.
Published: (1984)
Through Thickness Microstructural and Texture Inhomogeneity Within Al Layers in ARB-Produced Al-Al(Sc) Layered Composite Sheets
by: Najafzadeh, N., et al.
Published: (2015)
by: Najafzadeh, N., et al.
Published: (2015)
Similar Items
-
Structural Refinement, Recrystallization and Grain Growth Phenomena in an Accumulative Roll Bonded Nickel Sheet
by: Quadir, Md Zakaria, et al.
Published: (2017) -
An Analytical Framework for Predicting the Limit in Structural Refinement in Accumulative Roll Bonded Nickel
by: Duan, J., et al.
Published: (2015) -
Substructural phenomena in Cu wire bond after laser assisted manufacturing in electronic packaging
by: Quadir, Zakaria, et al.
Published: (2020) -
Engineering low intensity planar textures in commercial purity nickel sheets by cross roll bonding
by: Duan, J., et al.
Published: (2017) -
The mechanical performance of ARB fabricated hybrid lamellar composite of recovered/recrystallized Al and precipitation hardened Al(Sc) layers
by: Quadir, Md Zakaria, et al.
Published: (2011)