Variations in through-thickness recrystallization and grain growth textures in the Al layers in ARB-processed Al/Al(0.3% Sc) composite sheets
This investigation aims to understand the differences in the recrystallization and grain growth textures in aluminum layers along the thickness direction of two layered composite sheets. The sheets were processed by five cycle accumulative roll bonding of commercially pure aluminum and an aluminum a...
| Main Authors: | , , |
|---|---|
| Format: | Journal Article |
| Published: |
Elsevier
2016
|
| Online Access: | http://hdl.handle.net/20.500.11937/53410 |
Similar Items
Through-thickness variations in recrystallization behavior in an Al-based ARB composite sheet
by: Najafzadeh, N., et al.
Published: (2014)
by: Najafzadeh, N., et al.
Published: (2014)
Through Thickness Microstructural and Texture Inhomogeneity Within Al Layers in ARB-Produced Al-Al(Sc) Layered Composite Sheets
by: Najafzadeh, N., et al.
Published: (2015)
by: Najafzadeh, N., et al.
Published: (2015)
The mechanical performance of ARB fabricated hybrid lamellar composite of recovered/recrystallized Al and precipitation hardened Al(Sc) layers
by: Quadir, Md Zakaria, et al.
Published: (2011)
by: Quadir, Md Zakaria, et al.
Published: (2011)
Grain growth and recrystallization behaviors of an ultrafine grained Al-0.6 wt%Mg-0.4 wt%Si-5vol.%SiC nanocomposite during heat treatment and extrusion
by: Yao, X., et al.
Published: (2018)
by: Yao, X., et al.
Published: (2018)
Crystallography of the low angle lamellar band boundaries in ARB-processed aluminum sheet
by: Quadir, Md Zakaria, et al.
Published: (2012)
by: Quadir, Md Zakaria, et al.
Published: (2012)
Effect of heating rate and annealing temperature on secondary recrystallization of goss grains in a grain orientated silicon steel
by: Citrawati, F., et al.
Published: (2017)
by: Citrawati, F., et al.
Published: (2017)
Structural Refinement, Recrystallization and Grain Growth Phenomena in an Accumulative Roll Bonded Nickel Sheet
by: Quadir, Md Zakaria, et al.
Published: (2017)
by: Quadir, Md Zakaria, et al.
Published: (2017)
Time and temperature regime of continuous grain coarsening in an ECAP-processed Al(0.1 wt.% Sc) alloy
by: Bommareddy, A., et al.
Published: (2012)
by: Bommareddy, A., et al.
Published: (2012)
Origin of copious recrystallization in cold rolled interstitial free (IF) steels
by: Quadir, Md Zakaria, et al.
Published: (2013)
by: Quadir, Md Zakaria, et al.
Published: (2013)
An ebsd study of nickel sheets after unidirectional and cross rolling arb processings
by: Duan, J., et al.
Published: (2015)
by: Duan, J., et al.
Published: (2015)
Effects of temperature and strain rate on the dynamic mechanical behavior of a fine grained Al-Sc alloy
by: Major, Z., et al.
Published: (2017)
by: Major, Z., et al.
Published: (2017)
Microstructure and mechanical properties of a bulk ultrafine grained Al-7Si-0.3Mg alloy produced by thermomechanical consolidation of a nanocrystalline powder
by: Liang, J., et al.
Published: (2016)
by: Liang, J., et al.
Published: (2016)
جذور العربية عرب التاريخ:
دراسةتحليلية = Jazur al-'Arabiyah 'arb al-tarikh: dirasah tahliliyah
by: Yaacob, Solehah@Nik Najah Fadilah
Published: (2015)
by: Yaacob, Solehah@Nik Najah Fadilah
Published: (2015)
Deformation and recrystallization of interstitial free (IF) steel
by: Duggan, B., et al.
Published: (2011)
by: Duggan, B., et al.
Published: (2011)
Prediction of novel alloy phases of Al with Sc or Ta
by: Bilic, Ante, et al.
Published: (2015)
by: Bilic, Ante, et al.
Published: (2015)
The effect of cross-rolling on the growth of goss grains in a grain oriented silicon steel
by: Citrawati, F., et al.
Published: (2016)
by: Citrawati, F., et al.
Published: (2016)
Mechanical response of a gravity cast Mg-9Al-1Zn-0.2Sc alloy at strain rates from 10-4 to 10 3 /s
by: Blessington, R., et al.
Published: (2016)
by: Blessington, R., et al.
Published: (2016)
Grain boundary deformation phenomena and secondary growth of goss grains in a Fe-3.5%Si steel
by: Citrawati, F., et al.
Published: (2017)
by: Citrawati, F., et al.
Published: (2017)
Hall–Petch Slope in Ultrafine Grained Al-Mg Alloys
by: Zhou, D., et al.
Published: (2019)
by: Zhou, D., et al.
Published: (2019)
A novel two-step method to prepare fine-grained SiC/Al-Mg-Sc-Zr nanocomposite: Processing, microstructure and mechanical properties
by: Huang, Guoqiang, et al.
Published: (2021)
by: Huang, Guoqiang, et al.
Published: (2021)
Smart Carretilla Enterprise : “SC System” / Anisah Atirah Kamaruzzaman...[et.al]
by: Kamaruzzaman, Anisah Atirah, et al.
Published: (2017)
by: Kamaruzzaman, Anisah Atirah, et al.
Published: (2017)
Engineering low intensity planar textures in commercial purity nickel sheets by cross roll bonding
by: Duan, J., et al.
Published: (2017)
by: Duan, J., et al.
Published: (2017)
The effect of final annealing heating rate on abnormal grain growth in a Fe-3.5%Si steel
by: Citrawati, F., et al.
Published: (2017)
by: Citrawati, F., et al.
Published: (2017)
Characterization of Aluminium-Silicon (Al-Si) cast alloy refined with Titanium Diboride (TiB2) and Scandium (Sc) / R. Rosmamuhamadani... [et al.]
by: R., Rosmamuhamadani, et al.
Published: (2018)
by: R., Rosmamuhamadani, et al.
Published: (2018)
Fe-Al Diffusion Bonding: Effect of reaction time on the interlayer thickness / Asmawi Ismail...[et al.]
by: Ismail, Asmawi, et al.
Published: (2018)
by: Ismail, Asmawi, et al.
Published: (2018)
The A.C. electrical response from the grain and grain boundary components of a Li0.25Ni0.2Zn0.3Fe2.25O4 ferrite
by: Ahmad Nazlim Yusoff ,, et al.
Published: (1997)
by: Ahmad Nazlim Yusoff ,, et al.
Published: (1997)
Sn-doped/coated Ni-Rich LiNi0.90Co0.04Mn0.03Al0.03O2 cathode materials for improved electrochemical performance of li-ion batteries
by: Jeyakumar, Juliya, et al.
Published: (2024)
by: Jeyakumar, Juliya, et al.
Published: (2024)
Corrosion behaviour of Al-Si cast alloy reinforced with titanium diboride (TiB2) and scandium (Sc)
by: Ibrahim, R. E., et al.
Published: (2018)
by: Ibrahim, R. E., et al.
Published: (2018)
The effect of sheet thickness to formability using hyperform
by: Fatin Zulaikha, Mohd Hatanan
Published: (2016)
by: Fatin Zulaikha, Mohd Hatanan
Published: (2016)
Effect of natural aging prior to heat treatment on tensile property of Al-1.2Si-0.5Mg-0.25Fe sheet alloy
by: Wong, Mee Chu Karen, et al.
Published: (2004)
by: Wong, Mee Chu Karen, et al.
Published: (2004)
Direct Observation of Nanoparticulate Goethite Recrystallization by Atom Probe Analysis of Isotopic Tracers
by: Frierdich, A.J., et al.
Published: (2019)
by: Frierdich, A.J., et al.
Published: (2019)
On the texture formation of selective laser melted Ti-6Al-4V
by: Simonelli, Marco, et al.
Published: (2014)
by: Simonelli, Marco, et al.
Published: (2014)
Influence of heat treatment on the microstructure, texture and formability of Al2024 aluminium alloy
by: Loo Chin Moy, Charles, et al.
Published: (2012)
by: Loo Chin Moy, Charles, et al.
Published: (2012)
Unusual crystallographic aspects of Microband boundaries within {111}<110> oriented grains in a cold rolled interstitial free steel
by: Zinnia, N., et al.
Published: (2014)
by: Zinnia, N., et al.
Published: (2014)
Structural, electrical, and magneto-transport properties of Pr0.7Sr0.3MnO3: Al2O3 composites
by: Lim, Kean Pah, et al.
Published: (2022)
by: Lim, Kean Pah, et al.
Published: (2022)
Relevance of composition and localisation of raw rice grains to texture of cooked rice
by: Awg Hj Tengah, Hjh Noorhasifah
Published: (2016)
by: Awg Hj Tengah, Hjh Noorhasifah
Published: (2016)
The physical properties of submicron and nano-grained La0.7Sr0.3MnO3 and Nd0.7Sr0.3MnO3 synthesised by sol–gel and solid-state reaction methods
by: Lau, Lik Nguong, et al.
Published: (2021)
by: Lau, Lik Nguong, et al.
Published: (2021)
Thickness Measurement of Liquid Sheet Spay Before Breakup
by: Nurrina, Rosli, et al.
Published: (2015)
by: Nurrina, Rosli, et al.
Published: (2015)
Deformation-enhanced recrystallization of titanite drives decoupling between U-Pb and trace elements
by: Gordon, S.M., et al.
Published: (2021)
by: Gordon, S.M., et al.
Published: (2021)
The effect of the rheocast process on the microstructure and mechanical properties of Al-5.7Si-2Cu-0.3Mg alloy
by: Abdelgnei, Mnel A H, et al.
Published: (2019)
by: Abdelgnei, Mnel A H, et al.
Published: (2019)