Effect of Heater Size on Confined Subcooled Jet Impingement Boiling
Jet impingement boiling heat transfer is a potential technique for the removal of very high heat fluxes concentrated at discrete locations, such as in power electronic components. In the present research, the effect of heater-nozzle size ratio (in the range 0.5 ≤ wH/wN ≤ 11) on jet impingement boili...
| Main Authors: | Abishek, S., Narayanaswamy, Ramesh, Narayanan, V. |
|---|---|
| Other Authors: | ASME |
| Format: | Conference Paper |
| Published: |
ASME
2012
|
| Subjects: | |
| Online Access: | http://hdl.handle.net/20.500.11937/33399 |
Similar Items
Experimental Study of Low Frequency Pulsating Liquid Jet Impingement in a confined planar geometry
by: Sridhar, Abishek, et al.
Published: (2013)
by: Sridhar, Abishek, et al.
Published: (2013)
Experimental Study of Pulsed and Steady State Confined Subcooled Jet Impingement Boiling
by: Sridhar, Abishek, et al.
Published: (2014)
by: Sridhar, Abishek, et al.
Published: (2014)
Effect of heater size and Reynolds number on the partitioning of surface heat flux in subcooled jet impingement boiling
by: Sridhar, Abishek, et al.
Published: (2013)
by: Sridhar, Abishek, et al.
Published: (2013)
Heat transfer and flow characteristics of fluid jets impinging on a surface with cavities
by: King, Andrew, et al.
Published: (2010)
by: King, Andrew, et al.
Published: (2010)
Effect of Standoff Distance on the Partitioning of Surface Heat Flux during Subcooled Jet Impingement Boiling
by: Abishek, S., et al.
Published: (2012)
by: Abishek, S., et al.
Published: (2012)
Direct jet impingement cooling of power electronics
by: Skuriat, Robert
Published: (2012)
by: Skuriat, Robert
Published: (2012)
Experimental and numerical heat transfer investigation of reverse jet impingement
by: Ahmed, Abdallah
Published: (2023)
by: Ahmed, Abdallah
Published: (2023)
Effect of standoff distance on the partitioning of surface heat flux during subcooled jet impingement boiling
by: Sridhar, Abishek, et al.
Published: (2012)
by: Sridhar, Abishek, et al.
Published: (2012)
Thermal enhancement strategies for fluid jets impinging on a heated surface
by: King, Andrew
Published: (2007)
by: King, Andrew
Published: (2007)
Transient Characteristics of Confined Submerjed Laminar Jet Impingement Heat Transfer from a Vibrating Heater
by: Sridhar, Abishek, et al.
Published: (2011)
by: Sridhar, Abishek, et al.
Published: (2011)
Effect of multiple jet impingement plate configurations on Reynolds Number in a pipe
by: Ramli, M. S., et al.
Published: (2016)
by: Ramli, M. S., et al.
Published: (2016)
Numerical investigations of convective phenomena of oil impingement on end-windings
by: Connor, P.H., et al.
Published: (2018)
by: Connor, P.H., et al.
Published: (2018)
Self-assembly under confinement: nanocorrals for understanding fundamentals of 2D crystallization
by: Verstraete, Lander, et al.
Published: (2016)
by: Verstraete, Lander, et al.
Published: (2016)
Flow Dependence of Carbon Dioxide Corrosion Using Short Electrodes by Jet Impingement
by: John, Doug, et al.
Published: (2009)
by: John, Doug, et al.
Published: (2009)
Single phase and boiling heat transfer under steady and pulsating confined jet impingement
by: Sridhar, Abishek
Published: (2013)
by: Sridhar, Abishek
Published: (2013)
Preliminary Investigation of the GCL’s Boiling toward An Upward Water Flow
by: Budihardjo, Mochamad, et al.
Published: (2012)
by: Budihardjo, Mochamad, et al.
Published: (2012)
Thermal stratification analysis of triangular integral collector storage solar water heater
by: Al-Talib, Ammar Abdul Aziz
Published: (2009)
by: Al-Talib, Ammar Abdul Aziz
Published: (2009)
On the impingement of droplets upon moving films
by: Mitchell, Antony James
Published: (2019)
by: Mitchell, Antony James
Published: (2019)
The synthesis and characterisation of confined polyoxometalates within nanostructured carbon
by: Kemp, Matthew G
Published: (2021)
by: Kemp, Matthew G
Published: (2021)
Coupled Effects of Surface-Radiation and Buoyancy on Jet-Impingement Heat Transfer
by: Abishek, S., et al.
Published: (2012)
by: Abishek, S., et al.
Published: (2012)
Heat transfer enhancement in microchannels with cross-flow synthetic jets
by: Chandratilleke, Tilak, et al.
Published: (2010)
by: Chandratilleke, Tilak, et al.
Published: (2010)
Computational investigation of boiling flows within micro-pin fin evaporators for thermal management of high-power
density micro-electronics
by: El Mellas, Ismail
Published: (2024)
by: El Mellas, Ismail
Published: (2024)
Interactive flow behaviour and heat transfer enhancement in a microchannel with cross flow synthetic jet
by: Jagannatha, Deepak, et al.
Published: (2010)
by: Jagannatha, Deepak, et al.
Published: (2010)
Effects of non-isothermal single circular impinging jet on a quasi-adiabatic flat plate
by: Mohd Saiah, Helmey Ramdhaney
Published: (2011)
by: Mohd Saiah, Helmey Ramdhaney
Published: (2011)
Simulation and Optimization of Thermosyphon Solar WateHeater for Kuala Lumpur Climate Using Trnsys Software
by: Zahedi, Seyed Hamidreza
Published: (2005)
by: Zahedi, Seyed Hamidreza
Published: (2005)
Heat Transfer and Dynamics of Impinging Droplets on Hot Horizontal Surfaces
by: Utikar, Ranjeet, et al.
Published: (2010)
by: Utikar, Ranjeet, et al.
Published: (2010)
Heat transfer and fluid flow characteristics of synthetic jets
by: Jagannatha, Deepak
Published: (2009)
by: Jagannatha, Deepak
Published: (2009)
CFD Calculation Of Impinging Confined Gas Jet Flamesfires
by: Anuar, Syed Muhammad Syimir Syed Mohamed
Published: (2017)
by: Anuar, Syed Muhammad Syimir Syed Mohamed
Published: (2017)
Numerical and experimental investigation of boiling nanofluids in vapour absorption refrigeration
by: Mohammed, Hayder I.
Published: (2019)
by: Mohammed, Hayder I.
Published: (2019)
Study on water quality of unconfined and confined aquifer in Selangor: aeration method
by: Nik Daud, Nik Norsyahariati, et al.
Published: (2016)
by: Nik Daud, Nik Norsyahariati, et al.
Published: (2016)
A case study of the carbon footprint of milk from high-performing confinement and grass-based dairy farms
by: O'Brien, D., et al.
Published: (2014)
by: O'Brien, D., et al.
Published: (2014)
Opening angles, Lorentz factors and confinement of X-ray binary jets
by: Miller-Jones, James, et al.
Published: (2006)
by: Miller-Jones, James, et al.
Published: (2006)
Behaviour and performance efficiency of solar air heater with impinging jets on corrugated plate
by: Aboghrara, Alsanossi Mohamed
Published: (2017)
by: Aboghrara, Alsanossi Mohamed
Published: (2017)
Numerical simulation of multiphase jet fragmentation using Smoothed Particle Hydrodynamics
by: Yue, Thomas Chun Long
Published: (2015)
by: Yue, Thomas Chun Long
Published: (2015)
Crystal Nucleation and Growth of Inorganic Ionic Materials from Aqueous Solution: Selected Recent Developments, and Implications
by: Gebauer, Denis, et al.
Published: (2022)
by: Gebauer, Denis, et al.
Published: (2022)
Advancing electrochemical jet machining techniques
by: Mitchell-Smith, Jonathon
Published: (2018)
by: Mitchell-Smith, Jonathon
Published: (2018)
Comparison of alkene hydrogenation in carbon nanoreactors of different diameters: probing the effects of nanoscale confinement on ruthenium nanoparticle catalysis
by: Aygun, Mehtap, et al.
Published: (2017)
by: Aygun, Mehtap, et al.
Published: (2017)
Controllable preparation of graphitic carbon nitride nanosheets via confined interlayer nanospace of layered clays
by: Jiang, G., et al.
Published: (2010)
by: Jiang, G., et al.
Published: (2010)
Design and Performance Analysis of a Flat Plate Collector
by: Pramanik, Alokesh, et al.
Published: (1999)
by: Pramanik, Alokesh, et al.
Published: (1999)
Determining the Electronic Confinement of a Subsurface Metallic State
by: Mazzola, F., et al.
Published: (2014)
by: Mazzola, F., et al.
Published: (2014)
Similar Items
-
Experimental Study of Low Frequency Pulsating Liquid Jet Impingement in a confined planar geometry
by: Sridhar, Abishek, et al.
Published: (2013) -
Experimental Study of Pulsed and Steady State Confined Subcooled Jet Impingement Boiling
by: Sridhar, Abishek, et al.
Published: (2014) -
Effect of heater size and Reynolds number on the partitioning of surface heat flux in subcooled jet impingement boiling
by: Sridhar, Abishek, et al.
Published: (2013) -
Heat transfer and flow characteristics of fluid jets impinging on a surface with cavities
by: King, Andrew, et al.
Published: (2010) -
Effect of Standoff Distance on the Partitioning of Surface Heat Flux during Subcooled Jet Impingement Boiling
by: Abishek, S., et al.
Published: (2012)