Efficient Voltage/Current Spike Reduction by Active Gate Signaling

QR Code

Efficient Voltage/Current Spike Reduction by Active Gate Signaling

This paper presents an active gate signaling scheme to reduce voltage/current spikes across insulated gate power switches in hard switching power electronic circuits. Voltage and/or current spikes may cause EMI noise. In addition, they increase voltage/current stress on the switch. Traditionally, a...

Full description

Bibliographic Details
Main Authors:	Boora, A., zare, F., Ghosh, Arindam
Other Authors:	-
Format:	Conference Paper
Published:	Institute of Electrical and Electronics Engineers ( IEEE ) 2009
Online Access:	http://hdl.handle.net/20.500.11937/33051

Similar Items

Utilising robustness of positive buck-boost converter against input voltage and load current disturbances
by: Boora, A., et al.
Published: (2009)

Multi-output buck-boost converter with enhanced dynamic response to load and input voltage changes
by: Boora, A., et al.
Published: (2011)

Common-mode voltage reduction in a motor drive system with a power factor correction
by: Abadi, J., et al.
Published: (2012)

Application of dynamic hysteresis band height control to improve output voltage transient in boost and Positive Buck-Boost converters
by: Boora, A., et al.
Published: (2009)

Voltage unbalance reduction in low voltage distribution networks with Rooftop PVs
by: Shahnia, Farhad, et al.
Published: (2010)

A general approach to control a Positive Buck-Boost converter to achieve robustness against input voltage fluctuations and load changes
by: Boora, A., et al.
Published: (2008)

Cross voltage control with inner hysteresis current control for multi-output boost converter
by: Nami, A., et al.
Published: (2009)

Voltage-sharing converter to supply single-phase asymmetrical four-level diode-clamped inverter with high power factor loads
by: Boora, A., et al.
Published: (2010)

High bandwidth voltage and current control design for voltage source converters
by: Ghosh, Arindam, et al.
Published: (2010)

Harmonic elimination technique for a single-phase multilevel converter with unequal DC link voltage levels
by: Ghasemi, N., et al.
Published: (2012)

A new family of multi-output DC-DC converter topologies to supply an asymmetrical four-level diode-clamped inverter
by: Boora, A., et al.
Published: (2011)

Tuning Harmonic Absorption of Voltage Source Converters
by: Ledwich, G., et al.
Published: (2010)

Voltage Quality Improvement in Distribution Networks Containing DERs using UPQC
by: Mazumder, S., et al.
Published: (2013)

Demand-side response model to avoid spike of electricity price
by: Marwan, M., et al.
Published: (2014)

A Novel High-Voltage Pulsed-Power Supply Based on Low-Voltage Switch–Capacitor Units
by: Zabihi, S., et al.
Published: (2009)

Different approaches to reduce shaft voltage in AC generators
by: zare, F., et al.
Published: (2009)

End-winding effect on shaft voltage in AC generators
by: Abadi, J., et al.
Published: (2009)

Improving Power Quality in Low-Voltage Networks Containing Distributed Energy Resources
by: Mazumder, S., et al.
Published: (2013)

Asymmetrical DC link voltage configuration for a diode-clamped inverter
by: Nami, A., et al.
Published: (2010)

Voltage Unbalance Reduction in Low Voltage Feeders by Dynamic Switching of Residential Customers Among Three Phases
by: Shahnia, Farhad, et al.
Published: (2014)

Low voltage DC power supply with spike-blocking features
by: Torla, A. Lutfi, et al.
Published: (2013)

Predicting Voltage Unbalance Impacts of Plug-in Electric Vehicles Penetration in Residential Low-voltage Distribution Networks
by: Shahnia, Farhad, et al.
Published: (2013)

Bidirectional positive buck-boost converter
by: Boora, A., et al.
Published: (2008)

A New DC-DC Converter with Multi Output: Topology and Control Strategies
by: Boora, A., et al.
Published: (2008)

A novel winding structure in planar inductors to decrease overall capacitive couplings
by: Shahabi, N., et al.
Published: (2012)

Common mode voltage in a motor drive system with PFC
by: zare, F., et al.
Published: (2010)

A novel high-voltage pulsed-power supply based on low-voltage switch-capacitor units
by: Zabihi, S., et al.
Published: (2010)

Analysis of Shaft Voltage in a Doubly-fed Induction Generator
by: Adabi, J., et al.
Published: (2009)

Calculations of capacitive couplings in induction generators to analyse shaft voltage
by: Adabi, J., et al.
Published: (2010)

Controlling current and voltage type interfaces in power-hardware-in-the-loop simulations
by: Dargahi, M., et al.
Published: (2014)

Improved multilevel hysteresis current regulation and capacitor voltage balancing schemes for flying capacitor multilevel inverter
by: Shukla, A., et al.
Published: (2008)

Voltage unbalance sensitivity analysis of plug-in electric vehicles in distribution networks
by: Shahnia, Farhad, et al.
Published: (2011)

Stability Analysis for Multiple Voltage Source Converters Connected at a Bus
by: Ghosh, Arindam, et al.
Published: (2011)

Load sharing in medium voltage islanded microgrids with advanced angle droop control
by: John, B., et al.
Published: (2018)

Dendritic cable with active spines: a modeling study in the spike-diffuse-spike framework
by: Timofeeva, Yulia, et al.
Published: (2005)

A new generation of high voltage pulsed power converters
by: Zabihi, S., et al.
Published: (2010)

Defining expected cost for the air conditioning to avoid a price spike of electricity market under DSR model
by: Marwan, M., et al.
Published: (2013)

Angle droop versus frequency droop in a voltage source converter based autonomous microgrid
by: Majumder, R., et al.
Published: (2009)

A novel winding structure in planar inductors to decrease the overall capacitive couplings
by: Shahabi, N., et al.
Published: (2010)

Online estimation of signal parameters in the presence of harmonic and noise distortion
by: Zadeh, R., et al.
Published: (2009)