Flow Dependence of Carbon Dioxide Corrosion Using Short Electrodes by Jet Impingement
The jet impingement technique is a valuable methodology for the evaluation of carbon dioxide corrosion and inhibition under high flow velocities. This technique commonly employs short electrodes that remain within a region of the developing diffusion boundary layer induced by the reactively corrodin...
| Main Authors: | , , , |
|---|---|
| Format: | Journal Article |
| Published: |
NACE International
2009
|
| Subjects: | |
| Online Access: | http://hdl.handle.net/20.500.11937/32159 |
Similar Items
Effect of trace dissolved oxygen on the cathodic kinetics of carbon dioxide corrosion of carbon steel.
by: John, Doug, et al.
Published: (2008)
by: John, Doug, et al.
Published: (2008)
Cathodic mass transfer relationship of carbonic acid solutions with trace dissolved oxygen contamination. Paper number 2731
by: John, Doug, et al.
Published: (2008)
by: John, Doug, et al.
Published: (2008)
Heat transfer and flow characteristics of fluid jets impinging on a surface with cavities
by: King, Andrew, et al.
Published: (2010)
by: King, Andrew, et al.
Published: (2010)
Experimental and numerical heat transfer investigation of reverse jet impingement
by: Ahmed, Abdallah
Published: (2023)
by: Ahmed, Abdallah
Published: (2023)
Thermal enhancement strategies for fluid jets impinging on a heated surface
by: King, Andrew
Published: (2007)
by: King, Andrew
Published: (2007)
Experimental Study of Low Frequency Pulsating Liquid Jet Impingement in a confined planar geometry
by: Sridhar, Abishek, et al.
Published: (2013)
by: Sridhar, Abishek, et al.
Published: (2013)
Direct jet impingement cooling of power electronics
by: Skuriat, Robert
Published: (2012)
by: Skuriat, Robert
Published: (2012)
Effect of multiple jet impingement plate configurations on Reynolds Number in a pipe
by: Ramli, M. S., et al.
Published: (2016)
by: Ramli, M. S., et al.
Published: (2016)
Effect of Heater Size on Confined Subcooled Jet Impingement Boiling
by: Abishek, S., et al.
Published: (2012)
by: Abishek, S., et al.
Published: (2012)
Numerical investigations of convective phenomena of oil impingement on end-windings
by: Connor, P.H., et al.
Published: (2018)
by: Connor, P.H., et al.
Published: (2018)
The influence of microstructure on the corrosion rate of various carbon steels
by: Kinsella, Brian, et al.
Published: (2005)
by: Kinsella, Brian, et al.
Published: (2005)
Electrochemical studies on carbon dioxide corrosion and its inhibition.
by: Tan, Yong-jun
Published: (1996)
by: Tan, Yong-jun
Published: (1996)
Galvanic Corrosion of Carbon Steel in Carbon Dioxide Caused by Magnetite Paper Number 3092
by: Chan, E., et al.
Published: (2008)
by: Chan, E., et al.
Published: (2008)
An in situ electrochemical impedance spectroscopy/synchrotron radiation grazing incidence X-ray diffraction study of the influence of acetate on the carbon dioxide corrosion of mild steel
by: De Marco, Roland, et al.
Published: (2007)
by: De Marco, Roland, et al.
Published: (2007)
Impact of mineral deposits on CO2 corrosion of carbon steel
by: Pandarinathan, Vedapriya, et al.
Published: (2013)
by: Pandarinathan, Vedapriya, et al.
Published: (2013)
Crevice Corrosion Studies on Corrosion Resistant Alloys in Stagnant Natural Seawater
by: Machuca, Laura, et al.
Published: (2013)
by: Machuca, Laura, et al.
Published: (2013)
On the impingement of droplets upon moving films
by: Mitchell, Antony James
Published: (2019)
by: Mitchell, Antony James
Published: (2019)
Microbial Corrosion Resistance of Stainless Steels for Marine Energy Installations
by: Machuca, L., et al.
Published: (2011)
by: Machuca, L., et al.
Published: (2011)
Heat transfer and fluid flow characteristics of synthetic jets
by: Jagannatha, Deepak
Published: (2009)
by: Jagannatha, Deepak
Published: (2009)
Heat transfer enhancement in microchannels with cross-flow synthetic jets
by: Chandratilleke, Tilak, et al.
Published: (2010)
by: Chandratilleke, Tilak, et al.
Published: (2010)
The application of neutron reflectometry and atomic force microscopy in the study of corrosion inhibitor films
by: John, Doug, et al.
Published: (2006)
by: John, Doug, et al.
Published: (2006)
Corrosion of Stainless Steels in the Marine Splash Zone
by: Bailey, Stuart, et al.
Published: (2013)
by: Bailey, Stuart, et al.
Published: (2013)
Interactive flow behaviour and heat transfer enhancement in a microchannel with cross flow synthetic jet
by: Jagannatha, Deepak, et al.
Published: (2010)
by: Jagannatha, Deepak, et al.
Published: (2010)
The Development of an Online Course in Corrosion Engineering – A Critical Aspect in any Corrosion Management System
by: Gubner, Rolf, et al.
Published: (2011)
by: Gubner, Rolf, et al.
Published: (2011)
Effect of carbon steel metallurgy on the inhibition of carbon dioxide corrosion by film forming inhibitors
by: Bailey, Stuart, et al.
Published: (2009)
by: Bailey, Stuart, et al.
Published: (2009)
A Laboratory Technique for Evaluating Marine Splash Zone Corrosion
by: Li, X., et al.
Published: (2012)
by: Li, X., et al.
Published: (2012)
Effects of non-isothermal single circular impinging jet on a quasi-adiabatic flat plate
by: Mohd Saiah, Helmey Ramdhaney
Published: (2011)
by: Mohd Saiah, Helmey Ramdhaney
Published: (2011)
Evaluation of the effects of seawater ingress into 316L lined pipes on corrosion performance
by: Machuca, Laura, et al.
Published: (2014)
by: Machuca, Laura, et al.
Published: (2014)
Inhibition of CO2 Corrosion of 1030 Carbon Steel Beneath Sand-deposits
by: Pandarinathan, V., et al.
Published: (2011)
by: Pandarinathan, V., et al.
Published: (2011)
Systematic study of the corrosion properties of selected high-resistance alloys in natural seawater
by: Machuca, Laura, et al.
Published: (2012)
by: Machuca, Laura, et al.
Published: (2012)
A corrosion inhibition study of steel grinding balls in an oxygen and alkaline environment
by: Kinsella, Brian, et al.
Published: (2006)
by: Kinsella, Brian, et al.
Published: (2006)
Testing of generic volatile inhibitor compounds in different top-of-the-line corrosion laboratory test methods
by: Oehler, Mike, et al.
Published: (2012)
by: Oehler, Mike, et al.
Published: (2012)
Coconut pulp waste extract (cocos nucifera l.) as corrosion inhibitor for mild steel in 1.0 M acid corrosion
by: Rahim, Norin Hafizah
Published: (2017)
by: Rahim, Norin Hafizah
Published: (2017)
Modelling the prestress transfer in pre-tensioned concrete elements
by: Abdelatif, Amged O., et al.
Published: (2015)
by: Abdelatif, Amged O., et al.
Published: (2015)
Filtration–UV irradiation as an option for mitigating the risk of microbiologically influenced corrosion of subsea construction alloys in seawater
by: Machuca, Laura, et al.
Published: (2014)
by: Machuca, Laura, et al.
Published: (2014)
Effect of oxygen and biofilms on crevice corrosion of UNS S31803 and UNS N08825 in natural seawater
by: Machuca, Laura, et al.
Published: (2013)
by: Machuca, Laura, et al.
Published: (2013)
Microbiologically influenced corrosion of high resistance alloys in seawater
by: Machuca, Laura, et al.
Published: (2011)
by: Machuca, Laura, et al.
Published: (2011)
Numerical simulation of multiphase jet fragmentation using Smoothed Particle Hydrodynamics
by: Yue, Thomas Chun Long
Published: (2015)
by: Yue, Thomas Chun Long
Published: (2015)
Advancing electrochemical jet machining techniques
by: Mitchell-Smith, Jonathon
Published: (2018)
by: Mitchell-Smith, Jonathon
Published: (2018)
An Analysis of Entry Modes In The Chinese Car Industry
by: Hu, Liu
Published: (2007)
by: Hu, Liu
Published: (2007)