Different approaches to reduce shaft voltage in AC generators

QR Code

Different approaches to reduce shaft voltage in AC generators

This paper presents several shaft voltage reduction techniques for doubly-fed induction generators in wind turbine applications. These techniques includes: pulse width modulated voltage without zero vectors, multi-level inverters with proper PWM strategy, better generator design to minimize effectiv...

Full description

Bibliographic Details
Main Authors:	zare, F., Abadi, J., Ghosh, Arindam
Other Authors:	-
Format:	Conference Paper
Published:	2009 13th European Conference on Power Electronics and Applications (EPE 2009) 2009
Online Access:	http://hdl.handle.net/20.500.11937/25643

Similar Items

End-winding effect on shaft voltage in AC generators
by: Abadi, J., et al.
Published: (2009)

Analysis of Shaft Voltage in a Doubly-fed Induction Generator
by: Adabi, J., et al.
Published: (2009)

Calculations of capacitive couplings in induction generators to analyse shaft voltage
by: Adabi, J., et al.
Published: (2010)

A new generation of high voltage pulsed power converters
by: Zabihi, S., et al.
Published: (2010)

A new unequal DC link voltage configuration for a single phase multilevel converter to reduce low order harmonics
by: Ghasemi, N., et al.
Published: (2011)

Common-mode voltage reduction in a motor drive system with a power factor correction
by: Abadi, J., et al.
Published: (2012)

Tuning Harmonic Absorption of Voltage Source Converters
by: Ledwich, G., et al.
Published: (2010)

Voltage Quality Improvement in Distribution Networks Containing DERs using UPQC
by: Mazumder, S., et al.
Published: (2013)

Voltage unbalance reduction in low voltage distribution networks with Rooftop PVs
by: Shahnia, Farhad, et al.
Published: (2010)

A Novel High-Voltage Pulsed-Power Supply Based on Low-Voltage Switch–Capacitor Units
by: Zabihi, S., et al.
Published: (2009)

Improving Power Quality in Low-Voltage Networks Containing Distributed Energy Resources
by: Mazumder, S., et al.
Published: (2013)

Efficient Voltage/Current Spike Reduction by Active Gate Signaling
by: Boora, A., et al.
Published: (2009)

Asymmetrical DC link voltage configuration for a diode-clamped inverter
by: Nami, A., et al.
Published: (2010)

Predicting Voltage Unbalance Impacts of Plug-in Electric Vehicles Penetration in Residential Low-voltage Distribution Networks
by: Shahnia, Farhad, et al.
Published: (2013)

Common mode voltage in a motor drive system with PFC
by: zare, F., et al.
Published: (2010)

A novel high-voltage pulsed-power supply based on low-voltage switch-capacitor units
by: Zabihi, S., et al.
Published: (2010)

Multi-output buck-boost converter with enhanced dynamic response to load and input voltage changes
by: Boora, A., et al.
Published: (2011)

An Advanced Optimal Approach for High Voltage AC Bushing Design
by: Hesamzadeh, M., et al.
Published: (2008)

A general approach to control a Positive Buck-Boost converter to achieve robustness against input voltage fluctuations and load changes
by: Boora, A., et al.
Published: (2008)

Simulation and modeling of high voltage DC to AC PWM inverter for electrostatic generator
by: Motakabber, S. M. A., et al.
Published: (2018)

Bidirectional power sharing in an ac/dc system with a dual active bridge converter
by: Datta, Amit Jyoti, et al.
Published: (2019)

Application of dynamic hysteresis band height control to improve output voltage transient in boost and Positive Buck-Boost converters
by: Boora, A., et al.
Published: (2009)

Voltage unbalance sensitivity analysis of plug-in electric vehicles in distribution networks
by: Shahnia, Farhad, et al.
Published: (2011)

Stability Analysis for Multiple Voltage Source Converters Connected at a Bus
by: Ghosh, Arindam, et al.
Published: (2011)

Cross voltage control with inner hysteresis current control for multi-output boost converter
by: Nami, A., et al.
Published: (2009)

Load sharing in medium voltage islanded microgrids with advanced angle droop control
by: John, B., et al.
Published: (2018)

A resonant based marx generator
by: Zabihi, S., et al.
Published: (2010)

Utilising robustness of positive buck-boost converter against input voltage and load current disturbances
by: Boora, A., et al.
Published: (2009)

Angle droop versus frequency droop in a voltage source converter based autonomous microgrid
by: Majumder, R., et al.
Published: (2009)

Investigation on the AC breakdown voltage of RBDPO Olein
by: Sinan, Siti Salhaillea, et al.
Published: (2014)

Sensitivity analysis of voltage imbalance in distribution networks with rooftop PVs
by: Shahnia, Farhad, et al.
Published: (2010)

Implementation of a hybrid AC-AC direct power converter with unity voltage transfer
by: Wijekoon, Thiwanka, et al.
Published: (2008)

High bandwidth voltage and current control design for voltage source converters
by: Ghosh, Arindam, et al.
Published: (2010)

High-Voltage Modular Power Supply Using Parallel and Series Configurations of Flyback Converterfor Pulsed Power Applications
by: Davari, P., et al.
Published: (2012)

A new configuration for planar magnetic elements to reduce capacitive couplings
by: Shahabi, N., et al.
Published: (2010)

Load frequency control for rural distributed generation
by: Majumder, R., et al.
Published: (2010)

Flashover phenomena of polluted insulators energized by AC voltage
by: Salam, Md. Abdus, et al.
Published: (1999)

Power system stability and load sharing in distributed generation
by: Majumder, R., et al.
Published: (2008)

Voltage-sharing converter to supply single-phase asymmetrical four-level diode-clamped inverter with high power factor loads
by: Boora, A., et al.
Published: (2010)

Control strategies for load compensation using instantaneous symmetrical component theory under different supply voltages
by: Rao, U., et al.
Published: (2008)